Attachment Patroon Creek RadHaz

This document pretains to SES-LIC-20170215-00167 for License on a Satellite Earth Station filing.

IBFS_SESLIC2017021500167_1187725

Radiation Hazard Analysis NYS Div. of Homeland Security and Emergency Services 3.8m Ku-Band Earth Station in Patroon Creek, NY This analysis predicts the radiation levels around a proposed satellite terminal, comprised of one antenna which will be tested in a fixed environment. This report is developed in accordance with the prediction methods contained in OET Bulletin No. 65, Evaluating Compliance with FCC Guidelines for Human Exposure to Radio Frequency Electromagnetic Fields, Edition 9-01, pp 26-30. The maximum level of non-ionizing radiation to which employees may be exposed is limited to a power density level of 5 milliwatts per square centimeter (5 mW/cm2) averaged over any 6-minute period in a controlled environment and the maximum level of non-ionizing radiation to which the general public is exposed is limited to a power density level of 1 milliwatt per square centimeter (1 mW/cm2) averaged over any 30- minute period in an uncontrolled environment. Note that the worse-case radiation hazards exist along the beam axis. Under normal circumstances, it is highly unlikely that the antenna axis will be aligned with any occupied area since that would represent a blockage to the desired signals, thus rendering the link unusable. Satellite Terminal Technical Parameter Table Antenna Actual Diameter 3.8 meters Antenna Surface Area 11.34 meters2 Antenna Isotropic Gain 52.4 dBi Number of Identical Adjacent Antennas 1 Nominal Antenna Efficiency 65% Nominal Frequency 14.125 GHz Nominal Wavelength 0.0212 meters Maximum Transmit Power/Carrier 40 watts Number of Carriers 1 Total Transmit Power 40 watts W/G Loss from Transmitter to Feed 0.5 dB Total Feed Input Power 35.65 watts Near Field Limit 169.97 meters Far Field Limit 407.93 meters Transition Region 169.97 to 407.93 meters In the following sections, the power density in the above regions, as well as other critically important areas will be calculated and evaluated. The calculations are done in the order discussed in OET Bulletin 65.

1.0 At the Antenna Surface The power density at the reflector surface can be calculated from the expression: PDrefl = 4P/A = 1.26 mW/cm2 Where: P = total power at feed in milliwatts A = Total area of reflector in square centimeters In the normal range of transmit powers for satellite antennas, the power densities at or around the reflector surface is expected to exceed safe levels. This area will not be accessible to the general public. Operators and technicians shall receive training specifying this area as a high exposure area. Procedures will be established that will assure that all transmitters are rerouted or turned off before access by maintenance personnel to this area is possible. 2.0 On-Axis Near Field Region The geometrical limits of the radiated power in the near field approximate a cylindrical volume with a diameter equal to that of the antenna. In the near field, the power density is neither uniform nor does its value vary uniformly with distance from the antenna. For the purpose of considering radiation hazard it is assumed that the on-axis flux density is at its maximum value throughout the length of this region. The length of this region, i.e. the distance from the antenna to the end of the near field, is computed as R nf above. The maximum power density in the near field is given by: PDnf = 0.649 mW/cm2 From 0 to 169.97 meters Evaluation: Uncontrolled Environment: Meets Controlled Limits Controlled Environment: Meets Controlled Limits

3.0 On-Axis Transition Region The transition region is located between the near and far field regions. As stated in Bulletin 65, the power density begins to vary inversely with distance in the transition region. The maximum power density in the transition region will not exceed that calculated for the near field region, and the transition region begins at that value. The maximum value for a given distance within the transition region may be computed for the point of interest according to: PDt = (PDnf * Rnf)/R = dependent on R (1) Where: PDnf = near field power density Rnf = near field distance R = distance to point of interest For: 169.97 < R < 407.93 meters We use Equation (1) to determine the safe on-axis distance required for the two occupancy conditions. Uncontrolled Environment Safe Operating Distance, Rsafe,u: 110.3 meters Controlled Environment Safe Operating Distance, Rsafe,c: 22.1 meters 4.0 On-Axis Far Field Region The on-axis power density in the far field region (PD ff) varies inversely with the square of the distance as follows: PDff = (P*G)/(4*pi*R2) = dependent on R Where: P = total power at feed G = numeric antenna gain in the direction of interest relative to isotropic radiator R = distance to point of interest For: R > Rff = 407.93 meters PDff = 0.278 mW/cm2 at Rff

5.0 Off-Axis Levels at the Far Field Limit and Beyond In the far field region the power is distributed in a pattern of maxima and minima (side lobes) as a function of the off-axis angle between the antenna center line and the point of interest. Off-axis power density in the far field can be estimated using the antenna radiation patterns prescribed for the antenna in use. Usually this will correspond to the antenna gain pattern envelope defined by the FCC or the ITU, which takes the form of: Goff = 32 - 25*log(theta) For 1 < theta < 48 degrees; -10 dBi from 48 < theta < 180 degrees (Applicable for commonly used satellite transmit antennas) Considering that satellite antenna beams are aimed skyward, power density in the far field will usually not be a problem except at low look angles. In these cases the off-axis gain reduction may be used to further reduce the power density levels. For example: At 1 degree off-axis at the far field limit we can calculate the power density as: Goff = 32 - 25*log(theta) = 32 - 0 dBi = 1585 numeric PD(1 deg. off-axis) = PDff * 1585/G = 0.0025 mW/cm2 6.0 Off-Axis Power Density in the Near Field and Transitional Regions According to Bulletin 65, off-axis calculations in the near field may be performed as follows. Assuming that the point of interest is at least one antenna diameter removed from the center of the main beam the power density at that point is at least a factor of 100 (20 dB) less than the value calculated for the equivalent on-axis power density in the main beam. Therefore, for regions at least D meters away from the center line of the dish, whether behind, below or in front of the antenna's main beam, the power density exposure is at least 20 dB below the main beam level as follows: PDnf(off-axis) = PDnf/100 = 0.00649 mW/cm2 at D off-axis See Section 7 for the calculation for the distance vs. elevation angle required to achieve this rule for a given object height.

7.0 Evaluation of Safe Occupancy Area in Front of Antenna The distance (S) from a vertical axis passing through the dish center to a safe off-axis location in front of the antenna can be determined based on the dish diameter rule (Item 6.0). Assuming a flat terrain in front of the antenna the relationship is: S = (D/sin(alpha)) + (2h - D - 2)/(2tan(alpha)) (2) Where: alpha = minimum elevation angle of antenna D = dish diameter in meters h = maximum height of object to be cleared in meters For distances equal to or greater than determined by Equation (2) the radiation hazard will be below safe levels. For: D = 3.8 meters h = 2 meters Then: alpha S 6.5 16.92 15 7.59 20 5.89 25 4.92 35 3.91 The operational area proposed for this terminal will not involve antenna elevation angles less than 6.55 degrees so the minimum separation distance between the terminal and the general public is 16.92 meters. Suitable fencing or other barriers will be provided to prevent casual occupancy of the area in front of the antenna within the limits prescribed above at the lowest elevation angle required. Summary The earth station will be protected from uncontrolled access with suitable fencing and other barrier walls. There will also be proper emission warning signs placed and all operating personnel will be aware of the human exposure levels at and around the terminal. The applicant agrees to abide by the conditions specified in Condition 5208 provided below: Condition 5208 - The licensee shall take all necessary measures to ensure that the antenna does not create potential exposure of humans to radiofrequency radiation in excess of the FCC exposure limits defined in 47 CFR 1.1307(b) and 1.1310 wherever such exposures might occur. Measures must be taken to ensure compliance with limits for both occupational/controlled exposure and for general population/uncontrolled exposure, as defined in these rule sections. Compliance can be accomplished in most cases by appropriate restrictions such as fencing. Requirements for restrictions can be determined by predictions based on calculations, modeling or by field measurements. The FCC's OET Bulletin 65 (available on-line at

www.fcc.gov/oet/rfsafety) provides information on predicting exposure levels and on methods for ensuring compliance, including the use of warning and alerting signs and protective equipment for workers. The following table summarizes all of the above calculations:

prom is Tnc_ Fom bme m Amows Denewr o sal mewn amoms Cenerine i 20— meen snsSurtce Are s 13| _news |mzpiya imoms crouniieion ce nees EremenyofOperaion F an mecogh ic remmmn lirs ouparone ns o ieXaners tow i. i ~Timamgremime [Ransnit PoveracFlane r TnW—|10" TorPied t« hom mmom c m povemm m a Suusim| ns sw AperunEen h ssovl —ms —|acrricoont 1: Refector Surtce Reson Cneuitonn Retecor surtice Pover D Fox nsl us rcmucm 1.287]_ntWic DoNot Meet Uncontolled Limits MectContrliet Limin TommNorFarGemm Enmsenm is rain|_nes_[Pram S50~ no Rernoirnabone Fow en e teccrrmcnn aai] miven""[Mecs Conroet im Mects Conroed Limi [Con—XTramton Regon Goutoms Eatero Tmstion Resiomim m iain|_new_[Pram Eaterto Tamston Regiomm ssrsol i fater of TssitonRegion mau m wsil_nen[oemi® faten o TamsitonRegio mau Tun|~ fe Woot Cse trmstin Reon oDenaty __JtDr o wat Jrememine0) sstol_miticn [Mcts Comrted Limis Mets Conolld Limis Cnnnnied Enromenmt Opcomg pooncoo Tins] m |roatin rou [Conmat moromment se operine Dvance [toe 1| ~m~ |roayrtie (corararriat cneumiom Disance o h FarFd gion m nsl nen (ooomin Toanil re lor—Asis Pover Denity i in FarFeld row 2nl wel (ourmiatnt k vam|—mien"" [MectConroted imin MectComroted Limin commincutmcrcon em Reticor suthce Pover Denity ho. wal c * n/d*n> KE GorGe) [Gontie t xompieamsieo 1 cerce (on3r— mc aoves] mWer""[iecs Conrted im (CorasPover Derity im mc NeFdland frandionRegionCnelaton Fover deny 110otwa torneamece. es vocol wa‘ uesncrypcopn iemoved amoet|_ntvin Intects Contrated Linits Tomnnyicprmomn mm som oommpmaneremm «> ninimim cieaion anle oranem o & 1 msmumheghoronsi be ced metn Eomm Commmmnenmmanmenmmmn ral m dratonangte is m s is am


Document Created: 2017-02-15 21:46:58
Document Modified: 2017-02-15 21:46:58
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC