User Manual

FCC ID: XHT-10087

Users Manual

Download: PDF
FCCID_4432758

ORBIT TUMBLER OPERATING INSTRUCTIONS n Carefully remove items from package. m The car requires six "AA" 1.5V alkaline batteries (not nfl The remote control requires one 9V alkaline battery included). The battery compartment is on the underside (not included). Open the battery cover by depressing of the vehicle. Loosen both screws using a phillips or the small spring loaded pin using a tool while sliding cross screwdriver to remove the battery cover. Insert the cover down in the direction of the arrow. Insert the "AA" batteries according to the diagram inside the the battery according to the diagram inside the battery tray. Replace battery cover and tighten screws. battery compartment, and replace the cover. Stunt Button Right Battery Wheels Screws LJ Battery Cover Pairing: SAFETY PRECAUTIONS The Orbit Tumbler and Remote must be paired before driving. * Avoid water when operating. 1. Turn on remote — its status light will flash. *« Do not submerge trike or controller in water. 2. Turn on Orbit Tumbler — its lights will flash rapidly. + Do not use people or animals as obstacles. 3. The lights on the orbit tumbler will be off and the light on remote will be illuminated when they are paired. + Do not run car into furniture objects or hard surfaces as this If you have more than one vehicle and remote, you must pair onefirst, and then you may pair others. will cause damage to both the objects and trike. + Keep fingers, hair and loose clothing away from the tires, gears and motor while car is switched to "ON". *Press and Hold * Do not leave car or remote control near sources of heat or under direct sunlight for long periods of time. + Remove all batteries when not in use to avoid accidental operation. + Adult supervision is recommended when operating trike. + Thoroughly inspect products before every use. If the product appears worn, frayed/splintered, cracked, or broken in any manner, discontinue use and discard immediately. BATTERY WARNING: Do not mix old and new batteries. Do not mix alkaline, standard (carbon—zinc}, or rechargeable batteries. Alkaline batteries are recommended. Use only the specified voltage. Insert batteries using the correct polarity. Always use, replace, and recharge (if applicable) batteries under adult *Press and Hold supervision. Do not charge with non—rechargeable batteries. Do not short—circuit the battery supply terminals. Do not dispose of batteries in a fire, batteries may explode or leak. Remove batteries before storing. Recycle or dispose of batteries according to federal, state, and local laws. Keep these instructions for future reference. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user‘s authority to operate the Spinning Action *Press and Hold equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Tumbling KEEP THIS INSTRUCTION MANUAL AS IT CONTAINS IMPORTANT When the vehicle is moving INFORMATION FOR FUTURE REFERENCE. forward or backward and Due to continuous product improvements, the pictures on this manual may push the stunt button, it will > differ slightly from the actual product. cause it to flip over. The artwork and design of this manual are protected by US copyright law and may not be reproduced, distributed, displaced, published or used for any purpose without prior written permission. Altering, removing or reproducing any of the trademark or copyright notices on this package is not permitted. Sharper Image® name and logo are registered trademarks. Distributed by and © 2019 MerchSource, LLC. Irvine, CA 92618. All rights reserved. Model Number: YR201906 Printed in China FOR TECHNICAL SUPPORT, PLEASE CALL Note: for best operation, use vehicle on hard rough surface. 1 -800-374-2744


Document Created: 2019-08-15 13:36:30
Document Modified: 2019-08-15 13:36:30
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC