W8U55FS3700_users manual_Rev 1

FCC ID: W8U55FS3700

Users Manual

Download: PDF
FCCID_2487099

Important Information Important Safety Instructions 1. Read these instructions. CAUTION This symbol indicates that this product 2. Keep these instructions. Important Product Information RISK OF ELECTRIC SHOCK. DO NOT OPEN. incorporates double insulation between hazardous main voltage and user accessible parts. When servicing, use only identical replacement parts. 3. 4. Heed all warnings. Follow all instructions. 5. Do not use this apparatus near water. Caution: To reduce the risk of electric shock, do not remove cover (or back). No user serviceable parts inside. Refer servicing to qualified service personnel. 6. Clean only with dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. This symbol indicates “dangerous voltage” 8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including This symbol indicates important inside the product that presents a risk of instructions accompanying the product. amplifiers) that produce heat. electric shock or personal injury. This product incorporates HDMI technology. 9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades HDMI, the HDMI logo, and High-Definition Multimedia Interface are with one wider than the other. A grounding type plug has two blades and a third grounding prong. The trademarks or registered trademarks of HDMI Licensing LLC. wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, WARNING WARNING consult an electrician for replacement of the obsolete outlet. To reduce the risk of fire or electric shock, do not The TV is unstable if it is not properly attached to the expose this product to rain or moisture. This product base or mounted to the wall. Please follow the base 10. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, should not be exposed to dripping or splashing. No or wall mounting instructions provided in the User’s and the point where it exits from the apparatus. objects filled with liquids, such as vases, should be Guide to ensure your safety. 11. Only use attachments/accessories specified by the manufacturer. placed on the apparatus. 12. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination ENERGY STAR is a set of power-saving guidelines issued by the U.S. to avoid injury from tip-over. Environmental Protection Agency (EPA). WARNING The batteries shall not be exposed to excessive heat such as sunshine, fire or the like. 13. Unplug this apparatus during lightning storms or when unused for long periods of time. ENERGY STAR is a joint program of the U.S. Environmental Protection Refer to the identification/rating label located on the back panel of your product for its proper operating voltage. 14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been Agency and the U.S. Department of Energy helping us all save money and FCC regulations state that unauthorized changes or modifications to this equipment may void the user’s authority to damaged in any way, such as power-supply cord or plug damaged, liquid has been spilled or objects have protect the environment through energy efficient products and practices. operate it. fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, This product qualifies for ENERGY STAR in the "factory default" setting or has been dropped. Cable TV Installer: This reminder is provided to call your attention to Article 820-40 of the National Electrical Code ("Home Mode" option in the initial Setup Wizard or "Energy Star" option (Section 54 of the Canadian Electrical Code, Part 1) which provides guidelines for proper grounding and, in particular, 15. If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is for "Picture Mode" in Picture menu) and this is the setting in which power specifies that the cable ground should be connected to the grounding system of the building as close to the point of grounded so as to provide some protection against voltage surges and built-up static charges. Section 810 savings will be achieved. Changing the factory default picture settings cable entry as practical. of the National Electrical Code, ANSI/NFPA No. 70-2011 (Section 54 of Canadian Electrical Code, Part 1) or enabling other features may increase power consumption that could Important: This television is a table model and is designed to sit on a firm, flat surface. Don’t place the TV on soft provides information with respect to proper grounding of the mast and supporting structure, grounding of exceed the limits necessary to qualify for ENERGY STAR rating. carpeting or similar surface because the ventilation slots on the bottom of the unit will be blocked, resulting in reduced the lead-in wire to an antenna-discharge unit, size of grounding conductors, location of antenna-discharge lifetime from overheating. To assure adequate ventilation for this product, maintain a spacing of 4 inches from the top unit, connection to grounding electrodes, and requirements for the grounding electrode. See following and side of the TV receiver and 2 inches from the rear of the TV receiver and other surfaces. FCC Information example: Also, make sure the stand or base you use is of adequate size and strength to prevent the TV from being accidentally This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant tipped over, pushed off, or pulled off. This could cause personal injury and/or damage to the TV. Refer to the to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful Important Safety Instructions on the next page. The Power button (followed by the power symbol) on this TV and your remote control puts the TV into a very low- ANTENNA LEAD ANTENNA LEAD IN IN WIRE WIRE interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference power standby mode but will not completely turn the power off. In order to completely shut the power off, you will to radio communications. However, there is no guarantee that interference will not occur in a particular need to disconnect the power cord from the outlet. The mains plug/appliance coupler is used as disconnect device, the disconnect device shall remain readily operable. Therefore, you should ensure that the TV is installed in a manner GROUND CLAMP GROUND CLAMP installation. If this equipment does cause harmful interference to radio or television reception, which can be that allows you to disconnect the power cord when desired. determined by turning the equipment off and on, the user is encouraged to try to correct the interference by ANTENNA DISCHARGE UNIT ANTENNA DISCHARGE one or more of the following measures: (NEC SECTION UNIT(NEC 810-20) SEC TION 810-20) • Reorient or relocate the receiving antenna. Product Registration • Increase the separation between the equipment and receiver. Please register your TCL purchase on-line at www.tclusa.com. It will make it easier to contact you should it ever be • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. necessary. Registration is not required for warranty coverage. • Consult the dealer or an experienced radio/TV technician for help. GROUNDING GROUNDING CONDUCTORS CONDUC TORS (NECSEC SECTION 810-21) This Class B digital apparatus complies with Canadian ICES-003. Product Information GROUND (NEC CLAMPS GROUND CLAMPS TION 810-21) This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: Keep your sales receipt to obtain warranty parts and service and for proof of purchase. Attach it here and record the ELECTRIC SERVICE ELEC TRIC SER VICE serial and model numbers in case you need them. These numbers are located on the product. EQUIPMENT EQUIPMENT POWER SERVICE POWER SER GROUNDING VICE GROUNDING (1) This device may not cause harmful interference, and ELECTRODE SYSTEM (NEC ART ELEC TRODE SYSTEM (NECPARTH) ART 250, PA R TH) 250, (2) this device must accept any interference received, including interference that may cause undesired Model No. ______________________ Serial No._____________________________________ operation. Purchase Date __________________ Dealer/Address/Phone__________________________



Document Created: 2014-12-24 09:39:09
Document Modified: 2014-12-24 09:39:09
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC