manual

FCC ID: S6T561

Users Manual

Download: PDF
FCCID_1169726

TEK 561 TEKELEK LPG LEVEL MONITOR 3 FITTING TRANSMITTER • The Tekelek LPG Level Monitor This unit is only to be fitted measures the level of usable LPG to a tank with a compatible in your tank in 10 graduations of Rochester twin-site gauge head. the tank height. • Check that the existing tank • We give a full 3 year warranty subject to normal conditions. gauge is of the same design Supplied with long life no service lithium battery The warranty as the one on the end of the becomes invalid if the sealed unit is opened. cable from the TEKELEK LPG Monitor. Then check • Suitable for use in tanks for the storage of LPG, Propane or and note the reading on the existing gauge and remove the gauge display only – This is held in place with two securing screws. Dispose of Butane. Check with the manufacturer and/or supplier before the old gauge according to local environmental guidelines. using with any other fluids. • Fit the new gauge to the tank using the same screws. And check that • The TEKELEK LPG will fit easily to most standard storage the level on the gauge is the same as before. tanks using a standard Rochester type gauge head. • Locate the transmitter on a wall (with screws) or drain pipe (with cable ties) in a position that is unlikely to be subject to impact causing damage • 400 meters ‘line of sight’ transmission range. Please note that to the equipment. the radio transmission distance will be reduced by the proximity of metal, e.g., steel in buildings, metal domestic appliances etc • Tidy up the cable so as not to cause an obstruction. that are effectively between the transmitter and receiver. • Do not fit the unit to the LPG feed pipe from the tank. The unit may only • -30°C to 45°C operating temperature range. Please note that be fitted to a non LPG carrying pipe. the battery operating lifetime may be reduced at higher temperatures The TEKELEK LPG Level Monitor is now fully installed and signals should be received every hour. After initial installation it may take one hour for the correct level indication to be displayed on the receiver. We reserve the right to change or improve the performance and specification. NOTE: In the event of a power failure or if the receiver is switched off or moved INSTALLATION INSTRUCTIONS to a new socket: First, Read the essential health and safety notice. When power returns again or unit is switched on, the receiver display • Tools required: Star/Philips head screwdriver will show the top bar flashing. There is no need to repeat the matching instruction. The top bar will continue to flash for 2 minutes, 1 SETTING RECEIVER after which time the display will show the last reading, whilst the unique signal is located. This may take up to one hour. • The multi switches are located in a recess at the back of the receiver above the pins. If the tank is a vertical tank then set 4 ESSENTIAL HEALTH AND SAFETY NOTICE switch 1 on (up), if it’s horizontal set switch 1 off (down) Manufactured by Tekelek Europe LTD, Your TEKELEK LPG receiver is now Shannon, Ireland programmed to your tank height. Part Nr: 17-5497 (EU), 17-5495 (USA) 2 MATCHING RECEIVER AND TRANSMITTER II 2 G Ex ib IIA Tamb: -30 to +45°C You should match the receiver with the 0891 TRAC09ATEX21221X transmitter so that the system code is unique to your tank. • The Battery is not replaceable You only need to do this once. • Do not attempt to open the unit in a potentially explosive atmosphere • Periodically check that the unit is intact and securely fastened to the tank. • Plug receiver into a suitable and • Check with the manufacturer on the chemical compatibility prior to use. convenient electrical socket and switch • Do not attempt to repair this equipment. It must be returned to the manufacturer for repair. on. The display screen on the front of • Warning! Electrostatic Hazard! Clean only with an antistatic cloth the receiver will show a flashing top bar as shown in diagram. This indicates FCC ID:S6T-561 that the receiver is awaiting a unique This device complies with Part 15 of the FCC Rules. Operation is subject to the code. The bar will continue to flash for 2 following two conditions: (1) This device may not cause harmful interference, minutes during which time you can and (2) This device must accept any interference received, including match the transmitter to the receiver. interference that may cause undesired operation. • Hold the transmitter against the Declaration: receiver right hand side, as shown, This apparatus is designed to:- Not to give rise to physical injury or other so that the black dots are touching harm due to contact. Not to produce excessive surface temperatures, infra- each other (important!) for about 20 red, electromagnetic, ionising radiation. To have no non-electrical dangers, seconds to allow unique code to be when used in accordance with these user and installation instructions transferred. Bars will increase up the display screen. When all 10 bars are Warning: shown they will flash to indicate that If the equipment is likely to come in to contact with aggressive substances, the unique code is transferred. then it is the responsibility of the user to take suitable precautions that prevent it from being adversely affected, thus ensuring that the type of protection is not compromised. Aggressive substances; - e.g. acidic liquids or gases that may attack metals, or solvents that may affect polymeric materials. Note: No modifications or additions are allowed to this equipment as to do so will void the user’s authority to operate the equipment. Complies with EN60079-0:2006 and EN60079-11:2007 1 9-5452-01

TEKELEK LPG DISPLAY NORMAL MESSAGES Full Early Warning Almost empty Flashing triangle, no bars No radio signal (after waiting for two hours) - check for correct matching procedure - location of receiver to transmitter (try repositioning receiver) - moisture ingress due to seal damage - exhausted battery No Signal Steady triangle. Low battery - The battery in the transmitter is getting low. - The battery is not replaceable – The unit must be returned to the factory for replacement – The normal service life of the battery is 15 years. Low battery CHANGING BATTERY Though the lithium battery will have a very long service life, it will eventually become exhausted and need changing. Do not attempt to replace the battery – simply remove the unit from the tank and return the complete unit to the factory for replacement. The battery can only be replaced by the manufacturer. For support contact: support@tekelek.ie Tekelek Europe Ltd. 2 9-5452-01


Document Created: 2019-11-02 13:46:28
Document Modified: 2019-11-02 13:46:28
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC