Part IV BTB Module RF Report

FCC ID: QOQWRAP2022-1-B2B

Test Report

Download: PDF
FCCID_469539

 2. HIGH FREQUENCY SECTION 2480 MHz (HOPPING OFF). See next plot.




 Verdict: PASS




Report No:                                                          Page: 23 of 46
19807RET.101


                                                                    Annex A
Date: 2004-05-31
 FET45_00.DOC


 3. LOW FREQUENCY SECTION (HOPPING ON). See next plot.




 Verdict: PASS




Report No:                                               Page: 24 of 46
19807RET.101


                                                         Annex A
Date: 2004-05-31
 FET45_00.DOC


 4. HIGH FREQUENCY SECTION (HOPPING ON). See next plot.




 Verdict: PASS




Report No:                                                Page: 25 of 46
19807RET.101


                                                          Annex A
Date: 2004-05-31
 FET45_00.DOC


          Section 15.247 Subclause (c). Emission limitations conducted (Transmitter)


 SPECIFICATION
 In any 100 kHz bandwidth outside the frequency band in which the intentional radiator is
 operating, the radio frequency power that is produced by the intentional radiator shall be
 at least 20dB below that in the 100kHz bandwidth within the band that contains the
 highest level of the desired power.


 RESULTS:


 1. LOWEST CHANNEL (2402 MHz): 30 MHz-25 GHz (see next plot).




 Note: The peak above the limit is the carrier frequency.
 Verdict: PASS

Report No:                                                                             Page: 26 of 46
19807RET.101


                                                                                       Annex A
Date: 2004-05-31
 FET45_00.DOC


 2. MIDDLE CHANNEL (2441 MHz): 30 MHz-25 GHz (see next plot).




 Note: The peak above the limit is the carrier frequency.
 Verdict: PASS




Report No:                                                      Page: 27 of 46
19807RET.101


                                                                Annex A
Date: 2004-05-31
 FET45_00.DOC


 3. HIGH CHANNEL (2480 MHz): 30 MHz-25 GHz (see next plot).




 Note: The peak above the limit is the carrier frequency.
 Verdict: PASS




Report No:                                                    Page: 28 of 46
19807RET.101


                                                              Annex A
Date: 2004-05-31
 FET45_00.DOC


           Section 15.247 Subclause (c). Emission limitations radiated (Transmitter)


 SPECIFICATION

 Radiated emissions which fall in the restricted bands, as defined in §15.205(a), must also comply
 with the radiated emission limits specified in §15.209(a) (see §15.205(c)):


      Frequency Range        Field strength (µV/m)      Field strength      Measurement distance
           (MHz)                                         (dBµV/m)                  (m)
         0.009-0.490             2400/F(kHz)                   -                     300
         0.490-1.705            24000/F(kHz)                   -                     300
         1.705 - 30.0                 30                       -                       30
                30 - 88              100                      40                       3
            88 - 216                 150                     43.5                      3
           216 - 960                 200                      46                       3
         960 - 25000                 500                      54                       3

 The emission limits shown in the above table are based on measurements employing CISPR
 quasi-peak detector except for the frequency bands 9-90 kHz, 110-490 kHz and above 1000
 MHz. Radiated emission limits in these three bands are based on measurements employing an
 average detector.
 For average radiated emission measurements above 1000 MHz, there is also a limit
 corresponding to 20 dB above the indicated values in the table is specified when measuring
 with peak detector function.


 RESULTS:
 The field strength is calculated by adding correction factor to the measured level from the
 spectrum analyser. This correction factor includes antenna factor, cable loss and pre-
 amplifiers gain.
 The equipment transmits continuously in the selected channel so it is not necessary a duty
 cycle correction factor.




Report No:                                                                                  Page: 29 of 46
19807RET.101


                                                                                            Annex A
Date: 2004-05-31
 FET45_00.DOC


 Frequency range 30 MHz-1000 MHz.

 All emissions inside this range are produced by the test board where the module is mounted.



     Spurious frequency        Polarization        Detector      Emission Level     Uncertainty
           (MHz)                                                  (dBµV/m)            (dB)
                45.200              V            Quasi-peak            23.5           ±3.8 dB
                86.400              V            Quasi-peak            23.5           ±3.8 dB
                86.600              H            Quasi-peak            17.2           ±3.8 dB
                161.900             V            Quasi-peak            19.3           ±3.8 dB
                164.300             H            Quasi-peak            22.3           ±3.8 dB
                212.900             H            Quasi-peak            20.0           ±3.8 dB
                213.100             V            Quasi-peak            21.5           ±3.8 dB




 Frequency range 1 GHz-25 GHz.

 No spurious signals were found for the channels lowest, middle and highest in all the range
 (including at the harmonics frequencies).

 Additionally, no spurious signals were found inside the restricted bands 2310-2390 MHz
 and 2483.5-2500 MHz


 Verdict: PASS.




Report No:                                                                               Page: 30 of 46
19807RET.101


                                                                                         Annex A
Date: 2004-05-31
 FET45_00.DOC


 FREQUENCY RANGE 30 MHz-1000 MHz.




 Resolution bandwidth = 100 kHz.
 Video bandwidth = 100 kHz.

 (This plot is valid for all three channels).


Report No:                                      Page: 31 of 46
19807RET.101


                                                Annex A
Date: 2004-05-31
 FET45_00.DOC


 FREQUENCY RANGE 1 GHz to 2.9 GHz.
 CHANNEL: Lowest (2402 MHz).




 Note: The peak above the limit is the carrier frequency.




Report No:                                                  Page: 32 of 46
19807RET.101


                                                            Annex A
Date: 2004-05-31
 FET45_00.DOC



Document Created: 2004-09-16 17:33:57
Document Modified: 2004-09-16 17:33:57

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC