Users Manual

FCC ID: M45-4610

Users Manual

Download: PDF
FCCID_2470680

Manufacturer: Proto X / SYNCRO Shenzhen Hubsan Technology Co., Ltd. Model: ESTES 4610 FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

How To FLY FORWARD FORWARD ; ; BAGKWARD RIGHT CORRECTINQG DRIFT REPLACEMENT BLADES It is normal for the Proto X to drift slightly. Howeverif it drifts in any FRONT direction consistently press the trim button opposite the movement Gray Blades, Blue LEDs as many times a needed to eliminate the drift. REAR Black Blades, Red LEDs LANDINQ SAFELY LINK THE TRANSMITTER When the battery voltage begins to run low, the LEDs will begin Hold the throttle stick at full down and turn on the controller. .. to flash. It is time to land before the built in low voltage cut off Wait until the red LED turns green. reduces power to the motors. ())kU TROUBLESHOOTING PROBLEM: Controller cannot be linked to the ProtoX. SOLUTION: Throttle position needs to be at zero. PROBLEM: Controller LED flashing after binding. SOLUTION: Replace batteries. PROBLEM: Proto X shaking. SOLUTION: Check if the canopy, chassis and rotors are damaged. PROBLEM: Will not take off. SOLUTION: Check that the rotor blades are properly installed.


Document Created: 2013-09-30 16:09:45
Document Modified: 2013-09-30 16:09:45
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC