User Manual 1

FCC ID: JQU801660B

Users Manual

Download: PDF
FCCID_3994972

Kapsch TrafficCom North America G4 Interior Transponder Mounting Instructions G4 interior transponders mount to the inside of the vehicle windshield. The preferred mounting location is between the roofline and the rear view mirror post. If adequate space is not available in the preferred mounting location, the transponder can be mounted beside the rear view mirror post. The transponder is secured using 3M™ Dual Lock™ fasteners. Requirements Transponder Mounting Instructions  For reliable operation of the transponder, the vehicle should not be 3M Dual Lock adhesive pads on the back of the transponder are used equipped with more than one transponder of similar design while to mount the transponder. Choose the correct mounting location passing through a toll facility. Other transponders present in or on of the transponder (preferred or alternative) before affixing it to the the vehicle must be switched off or enclosed in an RF shield. windshield.  The mounting location must provide direct line-of-sight communication between the transponder and the toll facility Preferred Mounting Location overhead antenna. The transponder should be mounted between the roofline and the rear  Do not mount the interior transponder in vehicles: view mirror mounting post, such that the top of the transponder is ½”  with non-metallic roofs. (1¼ cm), but no more than 2” (5 cm) from the roofline, and the bottom  with windshields covered in RF-blocking material (ex. metal oxide). of the transponder is a minimum of ½” (1¼ cm) from the rear view mirror  with a metallic center windshield dividing post. post.  without center-mounted rear view mirrors. (see diagram for preferred mounting location)  Handheld mobile communication devices must not be located within 12” (30 cm) of the transponder. Alternative Mounting Location  Metal objects (except for the rear view mirror and the roof) must not If there is insufficient space in the preferred location, select an alter- be located within 6” (15cm) of the transponder. nate mounting location beside the rear view mirror post.  G4 Interior transponders cannot be used where local regulations (see diagram for alternative mounting location) prohibit mounting transponders on the windshield.  Apply the 3M Dual Lock fasteners in accordance with 3M document 70-0709-4029-4.

©Kapsch TrafficCom. All rights reserved. Subject to alteration without notice. Preferred Mounting Location - Side View Preferred Mounting Location - Front View windshield ½” (1¼ cm) preferred 2” (5 cm) maximum roofline roofline orientation ½” (1¼cm) preferred arrow 2” (5cm) maximum transponder transponder ½” (1¼cm) minimum ½” (1¼ cm) minimum rear view mirror post rear view mirror post Alternative Mounting Location - Front View Transponder - Rear View ½” (1¼ cm) preferred 3M Dual Lock fasteners 2” (5 cm) maximum roofline orientation arrow transponder rear view mirror post ½” (1¼ cm) minimum 1½” (7 cm) maximum Mounting Procedure 1. Select the appropriate mounting location for the transponder. 2. Prepare the area on the windsheild where the transponder will be mounted (affixed) in accordance with 3M document 70-0709-4029-4. 3. Remove the protective backing from the two 3M Dual Lock fasteners. 4. Firmly press the transponder against the windshield in the mounting location choosen, confiming the orientation arrows are pointing upwards. Maintain pressure for 15 seconds to ensure a good bond. 5. If required, you may remove the transponder from the fastener by lifting any corner with sufficient force to separate the Dual Lock strips. Do not reuse the Dual Lock strips if the strips are removed from the windshield or transponder. Obtain new strips as required. FCC License Notice - This device complies with part 15 of the FCC rules. Operation is subject to the condition that this device does not cause harmful interference. Kapsch Group Kapsch is one of Austria‘s most successful technology corporations, specialized in the future-oriented market segments of Intelligent Transportation Systems (ITS), Railway and Public Operator Telecommunications, as well as Information and Communications Technology (ICT). Kapsch. Always one step ahead. 801850-008 rev D. Kapsch TrafficCom North America | 8201 Greensboro Drive | Suite 1002 | McLean, VA 22102 | USA | Phone +1 703 885 1976 E-Mail ktc.us.info@kapsch.net | www.kapschtraffic.com | www.kapsch.net


Document Created: 2014-06-18 12:15:10
Document Modified: 2014-06-18 12:15:10
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC