Test Setup Photos

FCC ID: EO924GZRB

Test Setup Photos

Download: PDF
FCCID_1363072

Test Setups Figure 1: Test setup for radiated spurious between 9kHz and 30MHz with Loop Antenna.

Figure 2: Test setup for radiated spurious between 9kHz and 30MHz with Loop Antenna shown and Remote in upright position.

Figure 3: Test setup for radiated spurious between 9kHz and 30MHz with Loop Antenna shown and Remote in upright position. Figure 4: Test setup for radiated spurious between 9kHz and 30MHz with Loop Antenna and Remote in upside down position.

Figure 5: Test Setup for Radiated Spurious measurements between 30MHz and 300MHz using Biconical antenna shown here in vertical orientation

Figure 6: Test Setup for Radiated Spurious measurements between 30MHz and 300MHz using Biconical antenna shown here in horizontal orientation and Remote in upside down position. Figure 7: Test Setup for Radiated Spurious measurements between 30MHz and 300MHz using Biconical antenna shown here in vertical orientation and Remote in upright position.

Figure 8: Test setup for RX radiated spurious between 200MHz and 2GHz with Log Periodic in horizontal orientation.

Figure 9: Test setup for RX radiated spurious between 200MHz and 2GHz with Log Periodic in horizontal orientation shown with Remote in upside down position. Figure 10: Test setup for TX radiated spurious between 200MHz and 2GHz with Log Periodic in vertical orientation shown with remote in upright position.

Figure 11: Test setup for TX radiated spurious between 200MHz and 2GHz with Log Periodic in vertical orientation.

Figure 12: Test setup for TX radiated spurious emissions between 3 and 18GHz (Horizontal polarity shown) with high pass filter.

Figure 13: Test setup for radiated spurious emissions below 18GHz with horn in horizontal polarity and Remote in upside down position.

Figure 14: Test setup for radiated spurious emissions below 18GHz with horn antenna in vertical polarity and Remote in upright position. Figure 15: Test setup for TX radiated spurious emissions between 1 and 3GHz (Vertical polarity shown)

Figure 16: Test setup for TX fundemental radiated emission without high pass filter horn in vertical polarity.

Figure 17: Test setup for RX spurious emission measurements between 1 and 18 GHz with horn in vertical polarity.

Figure 21: Test setup for radiated spurious emissions above 18GHz (Vertical polarity shown). Figure 20: Test setup for radiated spurious emissions above 18GHz (horizontal polarity) shown with Remote in upright position.

Figure 21: Test setup for radiated spurious emissions above 18GHz (vertical polarity) shown with Remote in upside down position.

Figure 22: Test Setup for TX conducted power out, 6dB Bandwidth, Bandwidth of Momentary signals (99%BW), TX power spectral density, TX conducted band edge, measurements.


Document Created: 2010-10-19 19:20:59
Document Modified: 2010-10-19 19:20:59
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC