User Manual

FCC ID: 2ATSN-ROCKY1

Users Manual

Download: PDF
FCCID_4406968

USER MANUAL Rocky Talkie Radio System ■ 1/////////////////////////////////////////////////////////////////////////////////////////////h

FCC&RSS Warning Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. SAR tests are conducted using standard operating positions accepted by the FCC/ISEDC with the device transmitting at its highest certified power level in all tested frequency bands, although the SAR is determined at the highest certified power level, the actual SAR level of the device while operating can be well below the maximum value. Before a new model is a available for sale to the public, it must be tested and certified to the FCC/ISEDC that it does not exceed the exposure limit established by the FCC/ISEDC. Tests for each product are performed in positions and locations as required by the FCC/ISEDC. For body worn operation, this device has been tested and meets the FCC/ISEDC RF exposure guidelines when used with an accessory designated for this product when used with an accessory that Contains no metal. To maintain compliance with the FCC/ISEDC’s RF exposure guidelines, hold the transmitter and antenna at least 1 inch(2.5 centimeters) for your face and speak in a normal voice, with the antenna pointed up and away from the face. This equipment complies with FCC/ISDC radiation exposure limits set forth for an uncontrolled environment. In order to comply with the FCC/ISEDC RF exposure requirements, the antenna installation must comply with following: Users must be fully aware of the hazards of the exposure and able to exercise control over their FC exposure to qualify for the higher exposure limits. Your wireless hand-held portable transceiver contains a low power transmitter. This product sends out radio frequency(RF) signals when the Push-to-Talk(PTT)button is pressed. The device is authorized to operate at a duty factor not to exceed 50%. The device complies with FCC/ISEDC license - exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent areil est conforme aux CNR d’ISEDC licables aux areils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes: (1) I’areil ne doit pas produire de brouillage, et (2) I’utilisateur de l’appareil doit accepter tout brouillage radio é lectrique subi, m ê me si le brouillage est susceptible d’en compromettre le fonctionnement.

Antenna Totransmit and —— Status indicator Lights red while transmitting. lights green while receiving a signal. J ~—~—Microphone Voice input PTT switch (push—to—talk) Press, thenspeak into the microphone £ to call a station. & Earphone jack = Side button 1 Side button 1 ~~~ )

LCD Display Screen

Technical Specifications General Frequency Range 462.5500-462.7250MHz; 467.5625-467.7125MHz Channel capacity 22 channels Working voltage DC 4.2V Antenna impedance 50 Frequency Stability +-2.5ppm Working mode Simple Battery capacity 1550 mAh Working temperature 0 to 120 F Weight 133g (not containing antenna) Dimensions 179mm(L)*61mm(W)*30mm(H) Transmitter Output power High Power: 28.68dBm Low Power:21.63dBm Modulation mode F3E Maximum deviation <2.5KHz Spurious radiation <7.5uW Adjacent Channel Power <-60db Receiver RF sensitivity (12db SINAD) .25uV / 12.5 KHz Audio Distortion <10% Audio Power <1W

Battery Information Charging Li-ion Battery Please charge the battery before using. Completing a charge-discharge cycle two times can make the battery capacity achieve its maximum high-point. When the battery power is low, please recharge the battery. Applicable Battery Type Please use the designated battery only. Using other batteries may result in accidents or injury. The procedure of charging: Use only the charger and battery. The charger LED indicator light will indicate the charging process. Warning: For safety, the lithium battery is not charged before shipment. 1. When charging, it is recommended to tum off the radio. 2. Charge directly with USB plug. 3. While charging, the indicator light will turn red. 4. The battery will take approximately 4 to 5 hours to achieve a full charge. When the charging is completed, the indicator light will turn green.


Document Created: 2019-08-21 20:38:10
Document Modified: 2019-08-21 20:38:10
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC