User manual

FCC ID: 2AP6I-BZ600

Users Manual

Download: PDF
FCCID_4038014





                     @§®


                                             ©




                                                                   0"~~p o
                                             Qg?
o Receiverx 1              & 0c conversion Cable (LEMO 4—pin Male to D—tap) x 2
9 Transmitter x 1          6 MagicArmx 1
0 5GHz Antennasx 3         0 Crab Clamp x1
9 User Manual x 1          0 Mushroom Antenna x 2




INTRODUCTION

   The wireless high—definition video transmission system, using today‘s highest level of wireless communication technology, transmits
   broadcast—quality uncompressed, non—delayed 3G SDI or HDMILOBOP HD signals. Transmitter supports SDI ,HDML and SDI loopout;
   receiver support dual SDI output and HDMI output. Both transmitter and receiver working in broadcast mode, the transmission distance
   can reach 600ft.




                                          Transmitter                                  Recelver




                        Camera                                                                              Monitor




Copyright © Hollyland Technology Co.Ltd


THE APPLICATION OF MUSHROOM ANTENNA

   When the height difference between the transmitter and the receiver is large, the mushroom antenna is recommended to enhance the
   stability of the wireless transmission.




     The comera is shooting ahigh alffude, while the                       e ese erents
     montor is onthe ground.                                               the moritoris used at higher place.




Copyright © Hollyland Technology Co.Ltd






PRODUCT
   INTRODUCTION


                       Screen Instruction




    We3           l1
                       o    Link Indlicator, Green

                       o Channel Selection
                       9 TX Source Display, RX VIDEO Source Display
                       o    Signal Access Format

                       9 Temperature Display




      —e






OPERATION
    INSTRUCTION


        N Installation details and cautions


             Connectthe fransmitter audio                                    @



                                                                                   3.5mm




                                                                                                 Transmitter
             Set up connection
                                                                             ©
             @ When the receiver does not receive the signal                 Transmitter   Recever
               the display shows the status of No Video‘,no format display




 Copyright © Hollyland Technology Co.,Ltd                                                                      10






�圆圆·

     l This device compli臼with阳同15 of the FCC Rules. Operation is subject to the following two conditions:
     由This d酬cemaynot 臼use harmful in恒巾陀nee.
     。)This d制ice must 缸ceptanyinte巾rence received, including int暨南憎nee阳t may cause und笛ir回operation.
     2, Changes or   『nodi币cations   not e宜pressly approv回by the阳rty responsible b『 compliance could void由e user's authority to opera恒the
     equipm凹t


     • NOTE
     This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Pa同15 of the FCC Rules.
     These limits are designed to provide r回so『,able protection against harmful inte『ference in a residential installation.
     This equipment generates uses and can radiate radio frequency ene『gyand, if not installed and used in accordance with the instructions,
     may cause harmful inte『ference to radio communications. However, there is no gua『-antee that interference will not occur in a particular
     installation. If this equipment does cause ha『mful inte「ference to radio or television reception. which can be determined by turning the
     equipment off and on, the user is encouraged to try to correct the interference by one or more ofthe following measures:
        Reorient or relocate the receiving antenna
        Increase the separation between the equipment and receiver
        Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
        Consult the dealer or an experienced radio/Tv technician for help.


     • RF WARNING STATEMENT
     To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum 20cm
     distance between the radiator and your body: Use only the supplied antenna.


Copyright © Hollyland Technology Co.,Ltd                                                                                                        13





Document Created: 2018-08-21 11:48:44
Document Modified: 2018-08-21 11:48:44

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC