User manual

FCC ID: 2AOW4KTX433-USB

Users Manual

Download: PDF
FCCID_3749312

433MHz TRANSCEIVER UserGuide . KTX433-USB Interface &Cable

Technica al Specific cations: RFChanne els(MHz) 432.7 700, 433.100, 433.50 00, 433.600 0 434.0 000, 434.300, 434.60 00, 434.900 0 ModulationMode GFSK K Baud Rate e 9600 0bps Interface Data D Format USB,8E1/8N1 data d forma at Power Sup pply DC 5V 5 Overall Dimensions 60 X 42 X 21 mm m Commun nication Ap pplication n：

There is a channel setting switch as shown in the Figure, defined as A1, A2, and A3 respectively, where A1~A3 is for channel setting. Switch A1 A2 A3 Frequency Channel 1 0 0 0 432.700Mhz 2 1 0 0 433.100Mhz 3 0 1 0 433.500Mhz 4 1 1 0 433.600Mhz 5 0 0 1 434.000Mhz 6 1 0 1 434.300Mhz 7 0 1 1 434.600Mhz 8 1 1 1 434.900Mhz FCC Notices This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. FCC Radiation Exposure Statement This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.


Document Created: 2018-02-02 16:10:02
Document Modified: 2018-02-02 16:10:02
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC