14_ASC-S5 TestRpt DSS p2

FCC ID: 2AO5FASC-S5

Test Report

Download: PDF
FCCID_4451505

® A\GC Report No.: AGC02150190601FEO3 Page 56 of 76 14. FCC LINE CONDUCTED EMISSION TEST 14.1. LIMITS OF LINE CONDUCTED EMISSION TEST Maximum RF Line Voltage Frequency Q.P.( dBuV) Average( dBuV) 150kHz~500kHz 66—56 56—46 500kHz~5MHz 56 46 5SMHz~30MHz 60 50 Note: 1. The lower limit shall apply at the transition frequency. 2. The limit decreases linearly with the logarithm of the frequency in the range 0.15 MHz to 0.50 MHz. 14.2. BLOCK DIAGRAM OF LINE CONDUCTED EMISSION TEST EUT & Support \ socm =80em 40em aofm LSN Attestation of Global Compliance(Shenzhen)Co.,Ltd. Add: 2/F., Building 2,Sanwei Chaxi Industrial Park, Sanwei Community, Hangcheng Street, Bao‘an District, Shenzhen, Guangdong, China Tel: +86—755 2523 4088 E—mail: agc@age—cert.com Service Hotline:400 089 2118

Report No.: AGC02150190601FE03 Page 57 of 76 14.3. PRELIMINARY PROCEDURE OF LINE CONDUCTED EMISSION TEST 1. The equipment was set up as per the test configuration to simulate typical actual usage per the user’s manual. When the EUT is a tabletop system, a wooden table with a height of 0.8 meters is used and is placed on the ground plane as per ANSI C63.10 (see Test Facility for the dimensions of the ground plane used). When the EUT is a floor-standing equipment, it is placed on the ground plane which has a 3-12 mm non-conductive covering to insulate the EUT from the ground plane. 2. Support equipment, if needed, was placed as per ANSI C63.10. 3. All I/O cables were positioned to simulate typical actual usage as per ANSI C63.10. 4. All support equipments received AC120V/60Hz power from a LISN, if any. 5. The EUT received DC charging voltage by adapter which received AC120V/60Hz power by a LISN. 6. The test program was started. Emissions were measured on each current carrying line of the EUT using a spectrum Analyzer / Receiver connected to the LISN powering the EUT. The LISN has two monitoring points: Line 1 (Hot Side) and Line 2 (Neutral Side). Two scans were taken: one with Line 1 connected to Analyzer / Receiver and Line 2 connected to a 50 ohm load; the second scan had Line 1 connected to a 50 ohm load and Line 2 connected to the Analyzer / Receiver. 7. Analyzer / Receiver scanned from 150 kHz to 30MHz for emissions in each of the test modes. 8. During the above scans, the emissions were maximized by cable manipulation. 9. The test mode(s) were scanned during the preliminary test. Then, the EUT configuration and cable configuration of the above highest emission level were recorded for reference of final testing. 14.4. FINAL PROCEDURE OF LINE CONDUCTED EMISSION TEST 1. EUT and support equipment was set up on the test bench as per step 2 of the preliminary test. 2. A scan was taken on both power lines, Line 1 and Line 2, recording at least the six highest emissions. Emission frequency and amplitude were recorded into a computer in which correction factors were used to calculate the emission level and compare reading to the applicable limit. If EUT emission level was less –2dB to the A.V. limit in Peak mode, then the emission signal was re-checked using Q.P and Average detector. 3. The test data of the worst case condition(s) was reported on the Summary Data page.

Report No.: AGC02150190601FE03 Page 58 of 76 14.5. TEST RESULT OF LINE CONDUCTED EMISSION TEST Line Conducted Emission Test Line 1-L

Report No.: AGC02150190601FE03 Page 59 of 76 Line Conducted Emission Test Line 2-N RESULT: PASS Note: All the test modes had been tested, the mode 1 was the worst case. Only the data of the worst case would be record in this test report.

Report No.: AGC02150190601FE03 Page 60 of 76 APPENDIX A: PHOTOGRAPHS OF TEST SETUP RADIATED EMISSION TEST SETUP BELOW 1GHZ RADIATED EMISSION TEST SETUP ABOVE 1GHZ

Report No.: AGC02150190601FE03 Page 61 of 76 CONDUCTED EMISSION TEST SETUP

Report No.: AGC02150190601FE03 Page 62 of 76 APPENDIX B: PHOTOGRAPHS OF EUT ALL VIEW OF EUT

Report No.: AGC02150190601FE03 Page 63 of 76 TOP VIEW OF EUT BOTTOM VIEW OF EUT

Report No.: AGC02150190601FE03 Page 64 of 76 FRONT VIEW OF EUT BACK VIEW OF EUT

Report No.: AGC02150190601FE03 Page 65 of 76 LEFT VIEW OF EUT RIGHT VIEW OF EUT

Report No.: AGC02150190601FE03 Page 66 of 76 OPEN VIEW -1 OF EUT OPEN VIEW -2 OF EUT

Report No.: AGC02150190601FE03 Page 67 of 76 OPEN VIEW -3 OF EUT INTERNAL VIEW-1 OF EUT WIFI 1 Antenna BT 1 Antenna WIFI 2 Antenna

Report No.: AGC02150190601FE03 Page 68 of 76 INTERNAL VIEW-2 OF EUT INTERNAL VIEW-3 OF EUT

Report No.: AGC02150190601FE03 Page 69 of 76 INTERNAL VIEW-4 OF EUT INTERNAL VIEW-5 OF EUT

Report No.: AGC02150190601FE03 Page 70 of 76 INTERNAL VIEW-6 OF EUT INTERNAL VIEW-7 OF EUT

Report No.: AGC02150190601FE03 Page 71 of 76 INTERNAL VIEW-8 OF EUT INTERNAL VIEW-9 OF EUT

Report No.: AGC02150190601FE03 Page 72 of 76 INTERNAL VIEW-10 OF EUT INTERNAL VIEW-11 OF EUT

Report No.: AGC02150190601FE03 Page 73 of 76 INTERNAL VIEW-12 OF EUT INTERNAL VIEW-13 OF EUT

Report No.: AGC02150190601FE03 Page 74 of 76 INTERNAL VIEW-14 OF EUT INTERNAL VIEW-15 OF EUT

Report No.: AGC02150190601FE03 Page 75 of 76 INTERNAL VIEW-16 OF EUT INTERNAL VIEW-17 OF EUT

Report No.: AGC02150190601FE03 Page 76 of 76 INTERNAL VIEW-18 OF EUT INTERNAL VIEW-19 OF EUT ----END OF REPORT----


Document Created: 2019-09-20 07:48:49
Document Modified: 2019-09-20 07:48:49
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC