14_XHT-6B16 TestRpt DTS p3

FCC ID: 2AKC6XHT-WF6D

Test Report

Download: PDF
FCCID_4345537

                         ®

A\GC                                                                                             Report No.: AGC00742190601FEO5
                                                                                                                              Page 81 of 99


   13.3. PRELIMINARY PROCEDURE OF LINE CONDUCTED EMISSION TEST
   1.        The equipment was set up as per the test configuration to simulate typical actual usage per the user‘s
             manual. When the EUT is a tabletop system, a wooden table with a height of 0.8 meters is used and is
             placed on the ground plane as per ANSI C63.10 (see Test Facility for the dimensions of the ground plane
             used). When the EUT is a floor—standing equipment, it is placed on the ground plane which has a 3—12
             mm non—conductive covering to insulate the EUT from the ground plane.
             Support equipment, if needed, was placed as per ANSI C63.10.
o n m J ND




             All 1/O cables were positioned to simulate typical actual usage as per ANSI C63.10.
             All support equipments received AC120V/60Hz power from a LISN, if any.
             The EUT received DC 5V power from PC which received AC120V/60Hz power from a LISN.
             The test program was started. Emissions were measured on each current carrying line of the EUT using a
             spectrum Analyzer / Receiver connected to the LISN powering the EUT. The LISN has two monitoring
             points: Line 1 (Hot Side) and Line 2 (Neutral Side). Two scans were taken: one with Line 1 connected to
             Analyzer / Receiver and Line 2 connected to a 50 ohm load; the second scan had Line 1 connected to a
             50 ohm load and Line 2 connected to the Analyzer / Receiver.
   7.        Analyzer / Receiver scanned from 150 kHz to 30MHz for emissions in each of the test modes.
             During the above scans, the emissions were maximized by cable manipulation.
co




   9.        The test mode(s) were scanned during the preliminary test.

  Then, the EUT configuration and cable configuration of the above highest emission level were recorded for
   reference of final testing.


  9.4. FINAL PROCEDURE OF LINE CONDUCTED EMISSION TEST
   1.        __EUT and support equipment was set up on the test bench as per step 2 of the preliminary test.
   2.        Ascan was taken on both power lines, Line 1 and Line 2, recording at least the six highest emissions.
             Emission frequency and amplitude were recorded into a computer in which correction factors were used
             to calculate the emission level and compare reading to the applicable limit. If EUT emission level was
             less —2dB to the A.V. limit in Peak mode, then the emission signal was re—checked using Q.P and Average
             detector.
  3.         The test data of the worst case condition(s) was reported on the Summary Data page.




                                               Attestation of Global Compliance(Shenzhen)Co.,Ltd.

                                               Add: 2/F., Building 2, No.1—4, Chaxi Sanwei Technial Industrial Park, Gushu,
                                                      Xixiang, Bao‘an District, Shenzhen, Guangdong, China
                                               Tel:   +86—755 2523 4088       E—mail: agc@ageo—cert.com       Service Hotline:400 089 2118


                                                                   Report No.: AGC00742190601FE05
                                                                                      Page 82 of 99


9.5. TEST RESULT OF LINE CONDUCTED EMISSION TEST
                           Line Conducted Emission Test Line 1-L


                                                                           Report No.: AGC00742190601FE05
                                                                                              Page 83 of 99


                                       Line Conducted Emission Test Line 2-N




RESULT: PASS
Note: All the test modes had been tested, the mode 1 was the worst case. Only the data of the worst case
would be record in this test report.


                                    Report No.: AGC00742190601FE05
                                                       Page 84 of 99


APPENDIX A: PHOTOGRAPHS OF TEST SETUP
FCC RADIATED EMISSION TEST SETUP BELOW 1GHZ




FCC RADIATED EMISSION TEST SETUP ABOVE 1GHZ


                                 Report No.: AGC00742190601FE05
                                                    Page 85 of 99


FCC LINE CONDUCTED EMISSION TEST SETUP


                             Report No.: AGC00742190601FE05
                                                Page 86 of 99


APPENDIX B: PHOTOGRAPHS OF EUT
       TEST MODE -XHT-6B16

         ALL VIEW OF EUT


                     Report No.: AGC00742190601FE05
                                        Page 87 of 99


 TOP VIEW OF EUT




BOTTOM VIEW OF EUT


                    Report No.: AGC00742190601FE05
                                       Page 88 of 99


FRONT VIEW OF EUT




BACK VIEW OF EUT


                    Report No.: AGC00742190601FE05
                                       Page 89 of 99


LEFT VIEW OF EUT




RIGHT VIEW OF EUT


                     Report No.: AGC00742190601FE05
                                        Page 90 of 99


OPEN VIEW OF EUT 1




OPEN VIEW OF EUT 2


                                                   Report No.: AGC00742190601FE05
                                                                      Page 91 of 99


                          INTERNAL VIEW OF EUT-1

         Antenna connector 0




Antenna connector 1




                          INTERNAL VIEW OF EUT-2


                  Report No.: AGC00742190601FE05
                                     Page 92 of 99


VIEW OF PORT -1




VIEW OF PORT -2


                         Report No.: AGC00742190601FE05
                                            Page 93 of 99


Series Model- XHT-6B18

  ALL VIEW OF EUT


                     Report No.: AGC00742190601FE05
                                        Page 94 of 99


 TOP VIEW OF EUT




BOTTOM VIEW OF EUT


                    Report No.: AGC00742190601FE05
                                       Page 95 of 99


FRONT VIEW OF EUT




BACK VIEW OF EUT


                    Report No.: AGC00742190601FE05
                                       Page 96 of 99


LEFT VIEW OF EUT




RIGHT VIEW OF EUT


                         Report No.: AGC00742190601FE05
                                            Page 97 of 99


 OPEN VIEW OF EUT 1




INTERNAL VIEW OF EUT-1




INTERNAL VIEW OF EUT-2


                 Report No.: AGC00742190601FE05
                                    Page 98 of 99




VIEW OF PORT-1


                       Report No.: AGC00742190601FE05
                                          Page 99 of 99


   VIEW OF PORT-2




----END OF REPORT---



Document Created: 2019-07-05 08:46:59
Document Modified: 2019-07-05 08:46:59

© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC