14_BS222GB TestRpt_p2

FCC ID: 2AIXN-BS222GB

Test Report

Download: PDF
FCCID_4269584

GC 7 Hs # Attestation of Global Compliance 1 W Report No.: AGC01082190204FEO2 Page 56 of 69 TEST PLOT OF HIGH CHANNEL s Keysight Spectrum Analyzer — Swept 5A _ RL RF 50e aC |__SeNSEITNT] | ALTGN AUTO _| P th 7 Avg Type: Log—Pwr PNO: Fast +»— T‘ig: Free Run IFGain:Low Atten: 30 dB Next Peak AMkr1 2.882 ms) 10 gBIdw Ref 20.00 dBm —1.26 dBJ Mkr—RefLvl Center 2.480000000 Lc 'WIMWMIWWWlll Res BW 1.0 MHz #VBW 3.0 MHz Sweep 10.00 ms (30000 pts IMSG status s Keysight Spectrum Analyzer — Swept 5A § L RF 500 aC |__Sense—mN] | ALTGN AUTO _| ente Je 480000000 Avg Type: Log—Pwr PNO: Fast +»— T‘ig: Free Run IFGain:Low Atten: 30 dB Auto Tune 10 dBidiv Ref 20.00 dBm has} CenterFreq 2.480000000 GHz StartFreq 2480000000 GHz Stop Freq 2.480000000 GHz CF Step 1000000 MHz Auto Man Freq Offset Center 2480000000 GHz #VBW 3.0 MHz Sweep 7.902 s (30000 pts IM so STATUS The results shbwuivin thisftestreport refer only to the sample(s) tested unless otherwise stated and the sample(s) are retained for 30 days only. The document is issued by/AGC, this docufgeht cannot be reproduced except in full with our prior written permission. The more details and the authenticity of the report will be confirmed Athittp://www.agc@eit.com. Attestatiqitof Global Compliance Tel: +86—755 2908 1955 Fax: +86—755 2600 8484 E—mail: agc@age—cert.com 400 089 2118 Add: 2/F. , Building 2, No.1—4, Chaxi Sanwei Technical Industrial Park, Gushu, Xixiang, Bacan District, Shenzhen, Guangdong China

Report No.: AGC01082190204FE02 Page 57 of 69 13. FREQUENCY SEPARATION 13.1. MEASUREMENT PROCEDURE The EUT shall have its hopping function enabled. Use the following spectrum analyzer settings: 1. Span: Wide enough to capture the peaks of two adjacent channels. 2. RBW: Start with the RBW set to approximately 30% of the channel spacing; adjust as necessary to best identify the center of each individual channel. 3. Video (or average) bandwidth (VBW) ≥ RBW. 4. Sweep: Auto. e) Detector function: Peak. f) Trace: Max hold. g) Allow the trace to stabilize. Use the marker-delta function to determine the separation between the peaks of the adjacent channels. 13.2. TEST SETUP (BLOCK DIAGRAM OF CONFIGURATION) Same as described in section 6.2 13.3. MEASUREMENT EQUIPMENT USED The same as described in section 6.3 13.4. LIMITS AND MEASUREMENT RESULT CHANNEL LIMIT RESULT CHANNEL SEPARATION KHz KHz Pass CH01-CH02 1000 >=25 KHz or 2/3 20 dB BW TEST PLOT FOR FREQUENCY SEPARATION Note: The 8-DPSK modulation is the worst case and recorded in the report.

Report No.: AGC01082190204FE02 Page 58 of 69 APPENDIX A: PHOTOGRAPHS OF TEST SETUP RADIATED EMISSION TEST SETUP BELOW 1GHZ RADIATED EMISSION TEST SETUP ABOVE 1GHZ

Report No.: AGC01082190204FE02 Page 59 of 69 APPENDIX B: PHOTOGRAPHS OF EUT ALL VIEW OF EUT TOP VIEW OF EUT

Report No.: AGC01082190204FE02 Page 60 of 69 BOTTOM VIEW OF EUT FRONT VIEW OF EUT

Report No.: AGC01082190204FE02 Page 61 of 69 BACK VIEW OF EUT LEFT VIEW OF EUT

Report No.: AGC01082190204FE02 Page 62 of 69 RIGHT VIEW OF EUT OPEN VIEW OF EUT-1(Left)

Report No.: AGC01082190204FE02 Page 63 of 69 OPEN VIEW OF EUT-2 INTERNAL VIEW OF EUT-1

Report No.: AGC01082190204FE02 Page 64 of 69 INTERNAL VIEW OF EUT-2 Chip Antenna INTERNAL VIEW OF EUT-3

Report No.: AGC01082190204FE02 Page 65 of 69 INTERNAL VIEW OF EUT-4 OPEN VIEW OF EUT-1(Right)

Report No.: AGC01082190204FE02 Page 66 of 69 OPEN VIEW OF EUT-2 INTERNAL VIEW OF EUT-1

Report No.: AGC01082190204FE02 Page 67 of 69 INTERNAL VIEW OF EUT-2 INTERNAL VIEW OF EUT-3

Report No.: AGC01082190204FE02 Page 68 of 69 INTERNAL VIEW OF EUT-4 Series Model: BS188GB ALL VIEW OF EUT

Report No.: AGC01082190204FE02 Page 69 of 69 TOP VIEW OF EUT BOTTOM VIEW OF EUT ----END OF REPORT----


Document Created: 2019-05-09 22:24:28
Document Modified: 2019-05-09 22:24:28
© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC