colocation report

FCC ID: 2ACTO-AP100

Test Report

Download: PDF
FCCID_2400955

FCC Test Report Report No. : FR462324 1 CO-LOCATION 1.1 Transmitter Radiated Unwanted Emissions 1.1.1 Transmitter Radiated Unwanted Emissions Limit Restricted Band Emissions Limit Frequency Range (MHz) Field Strength (uV/m) Field Strength (dBuV/m) Measure Distance (m) 0.009~0.490 2400/F(kHz) 48.5 - 13.8 300 0.490~1.705 24000/F(kHz) 33.8 - 23 30 1.705~30.0 30 29 30 30~88 100 40 3 88~216 150 43.5 3 216~960 200 46 3 Above 960 500 54 3 Note 1: Test distance for frequencies at or above 30 MHz, measurements may be performed at a distance other than the limit distance provided they are not performed in the near field and the emissions to be measured can be detected by the measurement equipment. When performing measurements at a distance other than that specified, the results shall be extrapolated to the specified distance using an extrapolation factor of 20 dB/decade (inverse of linear distance for field-strength measurements, inverse of linear distance-squared for power-density measurements). Note 2: Test distance for frequencies at below 30 MHz, measurements may be performed at a distance closer than the EUT limit distance; however, an attempt should be made to avoid making measurements in the near field. When performing measurements below 30 MHz at a closer distance than the limit distance, the results shall be extrapolated to the specified distance by either making measurements at a minimum of two or more distances on at least one radial to determine the proper extrapolation factor or by using the square of an inverse linear distance extrapolation factor (40 dB/decade). The test report shall specify the extrapolation method used to determine compliance of the EUT. Un-restricted Band Emissions Limit RF output power procedure Limit (dB) Peak output power procedure 20 Average output power procedure 30 Note 1: If the peak output power procedure is used to measure the fundamental emission power to demonstrate compliance to requirements, then the peak conducted output power measured within any 100 kHz outside the authorized frequency band shall be attenuated by at least 20 dB relative to the maximum measured in-band peak PSD level. Note 2: If the average output power procedure is used to measure the fundamental emission power to demonstrate compliance to requirements, then the power in any 100 kHz outside of the authorized frequency band shall be attenuated by at least 30 dB relative to the maximum measured in-band average PSD level. 1.1.2 Measuring Instruments Refer a test equipment and calibration data table in this test report. SPORTON INTERNATIONAL INC. Page No. : 1 of 8 TEL : 886-3-327-3456 Report Version : Rev. 02 FAX : 886-3-327-0973

FCC Test Report Report No. : FR462324 1.1.3 Test Procedures Test Method Measurements may be performed at a distance other than the limit distance provided they are not performed in the near field and the emissions to be measured can be detected by the measurement equipment. When performing measurements at a distance other than that specified, the results shall be extrapolated to the specified distance using an extrapolation factor of 20 dB/decade (inverse of linear distance for field-strength measurements, inverse of linear distance-squared for power-density measurements). Measurements in the frequency range 10 GHz - 18GHz are typically made at a closer distance 1m, because the instrumentation noise floor is typically close to the radiated emission limit. Measurements in the frequency range above 18 GHz - 25GHz are typically made at a closer distance 0.5m, because the instrumentation noise floor is typically close to the radiated emission limit. The average emission levels shall be measured in [duty cycle ≥ 98 or duty factor]. For the transmitter unwanted emissions shall be measured using following options below: Refer as FCC KDB 558074, clause 10.1 for unwanted emissions into non-restricted bands. Refer as FCC KDB 558074, clause 10.2 for unwanted emissions into restricted bands. Refer as FCC KDB 558074, clause 10.2.3.3 and 8.2.1 Option 1 (spectral trace averaging) Refer as FCC KDB 558074, clause 10.2.3.3 and 8.2.1 Option 2 (slow sweep speed). Refer as ANSI C63.10, clause 4.2.3.2.3 (Reduced VBW). VBW ≥ 1/T, where T is pulse time. Refer as ANSI C63.10, clause 4.2.3.2.4 average value of pulsed emissions. Refer as FCC KDB 558074, clause 10.2.3.2 and 8.1.1 measurement procedure peak limit. Refer as FCC KDB 558074, clause 10.2.3.1 measurement procedure Quasi-Peak limit. For radiated measurement, refer as FCC KDB 558074, clause 10.2.1. Refer as ANSI C63.10, clause 6.4 for radiated emissions from below 30 MHz. Test distance is 3m. Refer as ANSI C63.10, clause 6.5 for radiated emissions from 30 MHz to 1000 MHz. Test distance is 3m. Refer as ANSI C63.10, clause 6.6 for radiated emissions from above 1 GHz. Test distance is 3m. For conducted and cabinet radiation measurement, refer as FCC KDB 558074, clause 10.2.2. For conducted unwanted emissions into non-restricted bands (relative emission limits). Devices with multiple transmit chains: Refer as FCC KDB 662911, when testing out-of-band and spurious emissions against relative emission limits, tests may be performed on each output individually without summing or adding 10 log(N) if the measurements are made relative to the in-band emissions on the individual outputs. For conducted unwanted emissions into restricted bands (absolute emission limits). Devices with multiple transmit chains using options given below: (1) Measure and sum the spectra across the outputs or (2) Measure and add 10 log(N) dB FCC KDB 558074 SPORTON INTERNATIONAL INC. Page No. : 2 of 8 TEL : 886-3-327-3456 Report Version : Rev. 02 FAX : 886-3-327-0973

FCC Test Report Report No. : FR462324 1.1.4 Test Setup Transmitter Radiated Unwanted Emissions Below 1GHz Magnetic field tests shall be performed in the frequency range of 9 kHz to 30 MHz using a calibrated loop antenna. Electric field tests shall be performed in the frequency range of 30 MHz to 1000 MHz using a calibrated bi-log antenna. Transmitter Radiated Unwanted Emissions Above 1GHz Electric field tests shall be performed in the frequency range of 1 GHz to 10th harmonic of highest fundamental frequency or 40 GHz using a calibrated horn antenna. 1.1.5 Transmitter Radiated Unwanted Emissions (Below 30MHz) All amplitude of spurious emissions that are attenuated by more than 20 dB below the permissible value has no need to be reported. SPORTON INTERNATIONAL INC. Page No. : 3 of 8 TEL : 886-3-327-3456 Report Version : Rev. 02 FAX : 886-3-327-0973

FCC Test Report Report No. : FR462324 1.1.6 Results of Radiated Emissions (30MHz~1GHz) Transmitter Radiated Unwanted Emissions Operating Mode PoE mode & Wi Fi Transmit Polarization V Operating Function 2.4GHz 3TX 11n(HT20) (2437MHz) + 5GHz 3TX 11n(HT20) (5200MHz) Note 1: “>20dB” means spurious emission levels that exceed the level of 20 dB below the applicable limit. Note 2: “N/F” means Nothing Found spurious emissions (No spurious emissions were detected.) Note 3: Measurement receive antenna polarization: H (Horizontal), V (Vertical) SPORTON INTERNATIONAL INC. Page No. : 4 of 8 TEL : 886-3-327-3456 Report Version : Rev. 02 FAX : 886-3-327-0973

FCC Test Report Report No. : FR462324 Transmitter Radiated Unwanted Emissions Operating Mode PoE mode & Wi Fi Transmit Polarization H Operating Function 2.4GHz 3TX 11n(HT20) (2437MHz) + 5GHz 3TX 11n(HT20) (5200MHz) Note 1: “>20dB” means spurious emission levels that exceed the level of 20 dB below the applicable limit. Note 2: “N/F” means Nothing Found spurious emissions (No spurious emissions were detected.) Note 3: Measurement receive antenna polarization: H (Horizontal), V (Vertical) SPORTON INTERNATIONAL INC. Page No. : 5 of 8 TEL : 886-3-327-3456 Report Version : Rev. 02 FAX : 886-3-327-0973

FCC Test Report Report No. : FR462324 1.1.7 Results for Radiated Emissions (1GHz~10th Harmonic) Transmitter Radiated Unwanted Emissions Operating Mode Adapter mode & Wi Fi Transmit Polarization V Operating Function 2.4GHz 3TX 11n(HT20) (2437MHz) + 5GHz 3TX 11n(HT20) (5200MHz) Note 1: “>20dB” means spurious emission levels that exceed the level of 20 dB below the applicable limit. Note 2: “N/F” means Nothing Found spurious emissions (No spurious emissions were detected.) Note 3: Measurement receive antenna polarization: H (Horizontal), V (Vertical) Note 4: For restricted bands, the peak measurement is fully sufficient, as the max field strength as measured with the Peak-Detector meets the AV-Limit so that the AV level does not need to be reported in addition. Note 5: For un-restricted bands, unwanted emissions shall be attenuated by at least 20 dB relative to the maximum measured in-band level. SPORTON INTERNATIONAL INC. Page No. : 6 of 8 TEL : 886-3-327-3456 Report Version : Rev. 02 FAX : 886-3-327-0973

FCC Test Report Report No. : FR462324 Transmitter Radiated Unwanted Emissions Operating Mode Adapter mode & Wi Fi Transmit Polarization H Operating Function 2.4GHz 3TX 11n(HT20) (2437MHz) + 5GHz 3TX 11n(HT20) (5200MHz) Note 1: “>20dB” means spurious emission levels that exceed the level of 20 dB below the applicable limit. Note 2: “N/F” means Nothing Found spurious emissions (No spurious emissions were detected.) Note 3: Measurement receive antenna polarization: H (Horizontal), V (Vertical) Note 4: For restricted bands, the peak measurement is fully sufficient, as the max field strength as measured with the Peak-Detector meets the AV-Limit so that the AV level does not need to be reported in addition. Note 5: For un-restricted bands, unwanted emissions shall be attenuated by at least 20 dB relative to the maximum measured in-band level. SPORTON INTERNATIONAL INC. Page No. : 7 of 8 TEL : 886-3-327-3456 Report Version : Rev. 02 FAX : 886-3-327-0973

FCC Test Report Report No. : FR462324 2 TEST EQUIPMENT AND CALIBRATION DATA Radiated Emission Instrument Manufacturer Model No. Serial No. Characteristics Calibration Date Remark Spectrum R&S FSP40 100593 9kHz ~ 40GHz Oct. 03, 2013 Radiation Analyzer 3m Semi Anechoic 30MHz ~ 1GHz SIDT FRANKONIA SAC-3M 03CH02-HY May 11, 2014 Radiation Chamber 3m Amplifier Agilent 8447D 2944A11146 100kHz ~ 1.3GHz Jul. 15, 2014 Radiation Amplifier Agilent 8449B 3008A02373 1GHz ~ 26.5GHz Aug. 28, 2013 Radiation Horn Antenna ETS-LINDGREN 3117 00091920 1GHz ~ 18GHz Nov. 25, 2013 Radiation Horn Antenna SCHWARZBECK BBHA9170 BBHA9170154 15GHz ~ 40GHz Jan. 10, 2014 Radiation RF Cable-R03m Jye Bao RG142 CB021 9kHz ~ 1GHz Nov. 09, 2013 Radiation RF Cable-high SUHNER SUCOFLEX106 03CH02-HY 1GHz ~ 40GHz Mar. 05, 2014 Radiation Bilog Antenna SCHAFFNER CBL61128 2723 30MHz ~ 2GHz Oct. 10, 2013 Radiation Chaintek Turn Table 3000 MF7802058 0~ 360 degree N/A Radiation Instruments Antenna Mast MF MF7802 MF780208205 1~4m N/A Radiation Note: Calibration Interval of instruments listed above is one year. Instrument Manufacturer Model No. Serial No. Characteristics Calibration Date Remark Amplifier MITEQ AMF-6F-260400 9121372 26.5GHz ~ 40GHz Apr. 19, 2013 Radiation Loop Antenna TESEQ HLA 6120 31244 9 kHz - 30 MHz Dec. 02, 2012 Radiation Note: Calibration Interval of instruments listed above is two year. SPORTON INTERNATIONAL INC. Page No. : 8 of 8 TEL : 886-3-327-3456 Report Version : Rev. 02 FAX : 886-3-327-0973


Document Created: 2014-09-25 14:00:59
Document Modified: 2014-09-25 14:00:59
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC