USERS MANUAL

FCC ID: ZRQ-K2

Users Manual

Download: PDF
FCCID_1733421

www.penclic.se 1 2

Penclic wireless Keyboard Quick guide EN Quick guide 2 Smile.


EN Penclic wireless Keyboard setup Welcome to the quick guide. Insert the rechargeable batteries and start charging with the included USB charging Penclic wireless Keyboard combines ergonomically cable, the USB port supports only charging function. Num Lock actives the numpad functions which is the smaller orange numbers. sound design with modern keyboard technology then set the keyboard power switch on the bottom of the keyboard to ON. Special functions (blue text) activated by holding Driver installation starts automatically. to bring you comfort and efficiency. The wireless connection activates automatically. the Fn key and then pressing: How to use your Penclic wirelessss Keyboard Fn + Function Penclic wireless Keyboard K2 (wireless) has 1 LED F2 Mute indicating battery status. F3 Lower volume F4 Higher volume LED behavior Indication F9 Pause/Break 1 red flash The keyboard on/ off switch was set F10 Scroll Lock to on. F11 Num Lock LED flashes red Recharge your repeatedly battery. (NOTE:Do F12 Print Screen not recharge Delete Insert non-rechargeable batteries.) Up arrow Page Up LED flashes Battery is currently Left arrow Home green repeatedly being recharged. Down Arrow Page Down LED is Battery is currently constantly green being recharged. Right Arrow End 2 3

Technical specifications · The supported platforms for Penclic wireless Keyboard are all operating systems that support HID 1.1. These include Windows XP or later, Mac OSX version 10.1 or later and most Linux/BSD flavors. No extra software/driver Troubleshooting installation is needed. · Make sure the Penclic wireless Keyboard USB · Connection USB. connector is firmly attached to the computer’s · AAA 1.2V NiMH Recharging battery (Everyday USB port. use last approximately 2 months before · Un-plug and re-plug the USB receiver. charging is needed). · Connect to another USB port. -Charging via USB . · LR 03/AAA/1.5V Alkaline None rechargeable · Connect to another computer. battery can be used. NOTE: DO NOT · Check the battery. RECHARGE. · USB-receiver 2,4GHz. -Wireless reach, minimum 5 metres Technical support -Connection via USB . · Energy saving mode starts after 10 min, press Should you require additional technical support a button to start. with your Penclic®, please use our Web site (www.penclic.se) for further information or contact · MAC operating systems do not support all the our support group through e-mail. Call Technical special functions. Support during business hours, Central European time (UTC+1). Measurements · Height: 6 mm (21 mm at top), Contact Base: 285 x 162 mm. + 46 8 544 98 995 · Weight: 381g including 1.4m cable. contact@penclic.se 5

commme EOE [ ELL CC 1J

FCC Warning This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.


Document Created: 2012-06-27 17:56:29
Document Modified: 2012-06-27 17:56:29
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC