Modular Approval Letter

FCC ID: ZMOL830EB11

Cover Letter(s)

Download: PDF

FCCID_3576796

Fibocom Wireless Inc.
5/F, Tower A, Technology Building II, 1057 Nanhai Blvd, Nanshan, Shenzhen, China

Modular Approval Request FCC (KDB 996369 D01 & Part 15.212)
FCC ID: ZMOL830EB11 Date: 07 September 2017

Items to be covered by Single modular transmitters. Answer from applicant
1. The modular transmitter must have its own RF shielding. The radio portion of this
module has been shielded,
please see exhibition external
photos.
2. The modular transmitter must have buffered modulation/data inputs (if such inputs Buffered data inputs stage has
are provided) to ensure that the module will comply with Part 15 requirements been integrated in chip
under conditions of excessive data rates or over-modulation. PMB5747+PMB9933D
3. The modular transmitter must have its own power supply regulation. The part number of the power
regulator is PMB9933D.
Please see the schem.pdf
4. The modular transmitter must comply with the antenna requirements of Section The requirements of antenna
15.203 and 15.204(b)(c). The antenna must either be permanently attached or connector and spurious
employ a “unique” antenna coupler (at all connections between the module and the emission have been fulfilled,
antenna, including the cable). please refer to the Test
Report exhibition.
5. The modular transmitter must be tested in a stand-alone configuration, i.e., the Please refer to the Setup Photo
module must not be inside another device during testing. This is intended to exhibition for the stand-alone
demonstrate that the module is capable of complying with Part 15 emission limits test configuration.
regardless of the device into which it is eventually installed.

6. The modular transmitter must be equipped with either a permanently affixed label The LTE Module will be
or must be capable of electronically displaying its FCC identification number in labeled with its own FCC ID,
accordance with 15.212 (a)(1)(vi)(A) / (B). and the instruction on the
labeling rule of the end
product has been
stated in the User Manual of
this module. Please refer to
the Label and User Manual
exhibition.
7. The modular transmitter must comply with any specific rule or operating The required FCC rule has
requirements applicable to the transmitter and the manufacturer must provide been fulfilled and all the
adequate instructions along with the module to explain any such requirements. A instructions for maintaining
copy of these instructions must be included in the application for equipment compliance have been clearly
authorization. For example, there are very strict operational and timing stated in the User Manual.
requirements that must be met before a transmitter is authorized for operation under
Section 15.231. For instance, data transmission is prohibited, except for operation
under Section 15.231(e), in which case there are separate field strength level and
timing requirements. Compliance with these requirements must be assured.

8. The modular transmitter must comply with any applicable RF exposure Please refer exhibition RF
requirements. For example, FCC Rules in Sections 1.1310, 2.1091, 2.1093, and Exposure for the compliance
specific Sections of Part 15, including 15.319(i), 15.407(f), 15.253(f) and of MPE RF exposure rule.
15.255(g), require that Unlicensed PCS, UNII and millimeter wave devices
perform routine environmental evaluation for RF Exposure to demonstrate
compliance. In addition, spread spectrum transmitters operating under Section
15.247 are required to address RF Exposure compliance. Modular transmitters
approved under other Sections of Part 15, when necessary, may also need to
address certain RF Exposure concerns, typically by providing specific
installation and operating instructions for users, installers and other interested
parties to ensure compliance.

Document Created: 2017-09-08 11:49:27
Document Modified: 2017-09-08 11:49:27

© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC