Operational Description

FCC ID: Y7A-WPEA127NI

Operational Description

Download: PDF
FCCID_1747441

FCC ID: Y7A-WPEA127NI




                   Operational Description
This device which operates in both of the 5GHz and 2.4GHz bands, the maximum
data rate could be up to 450Mbps which OFDM technique. If the signal to noise ratio
is too poor which could not support 450Mbps, the 11Mbps data rate with DSSS
technique will be applied.


The transmitter of the EUT is powered by 3.3Vdc from host equipment. The antenna
is an Omnidirectional antenna with UFL antenna connector.


The other instruction, please have a look at the users manual.


FCC 15.407(c) states: The device shall automatically discontinue transmission in
case of either absence of information to transmit or operational failure. These
provisions are not intended to preclude the transmission of control or signaling
information or the use of repetitive codes used by certain digital technologies to
complete frame or burst intervals.


Applicants shall include in their application for equipment authorization a description
of how this requirement is met”

Data transmission is always initiated by software, which is then pass down through
the MAC, through the digital and analog baseband, and finally to the RF chip.
Several special packets (ACKs, CTS, PSPoll, etc…) are initiated by the MAC. There
are the only ways the digital baseband portion will turn on the RF transmitter, which
it then turns off at the end of the packet. Therefore, the transmitter will be on only
while one of the aforementioned packets are being transmitted.




Report No.: RF120424C46



Document Created: 2012-07-13 15:44:55
Document Modified: 2012-07-13 15:44:55

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC