Modular approval

FCC ID: XXMOM12001100

Cover Letter(s)

Download: PDF
FCCID_1773919

FCC Federal Communications Commission Patrick Lomax 07.08.2012 Phone +49 (0) 2102 749 308 Fax +49 (0) 2102 749 350 Email: Patrick.lomax@7Layers.de request for a modular approval - FCC ID XXMOM12001100 Dear Application Examiner, the NXP Semiconductors module OM12001 is seeking FCC authorization as a modular transmitter. The requirement of the FCC part 15.212 are met. The following requirements are fulfilled: 1. The radio portion of the module is contained in its own RF shielding. Yes, The EUT does provide a RF shielding Refer to EUT Picture 2. The modular transmitter must have buffered modulation/data inputs Modulation and generation of data sent to RF power amplifier is under control of STE PNX4902 baseband. Its design ensures that no over modulation or excessive data rate will occur 3. The modular transmitter must have its own power supply regulation Power supply regulation is integrated into baseband PNX4902 and RF power amplifier SKY77531 for mobile communications. For NFC, it is also integrated into NXP PN532, whereas discrete LDOs are used for GPS and microcontroller 4. The modular transmitter must comply with the antenna requirements of Section 15.203 and 15.204c Yes. This module does not contain a standard RF connection and the antenna must be professionally installed by the end product integrator. Additionally, this device has been tested with a representative antenna. Registergericht registered in: Vorstand Board of Directors: 7 layers AG, Borsigstrasse 11 Ratingen, HRB 3264 Dr. Wolfgang Dahm 40880 Ratingen, Germany Aufsichtsratsvorsitzende Dr. Hans-Jürgen Meckelburg Phone: +49 (0) 2102 749 0 Chairman of the Supervisory Board: Fax: +49 (0) 2102 749 350 Dr. Sabine Grobecker www.7Layers.com

-2- 5. The modular transmitter must be tested in a stand-alone configuration The EUT was tested in a stand-alone configuration via a test kit. Please see section photographs of test configuration in the test report. 6. The modular transmitter must be labelled with its own FCC ID number Please see exhibition label sample for the FCC ID of this module; and also in the exhibition users manual, there are instructions given to the OEM on how to label the end product. 7. The modular transmitter must comply with any specific rule or operating requirements applicable to the transmitter and the manufacturer must provide adequate instructions along with the module to explain any such requirements. The EUT is compliant with all applicable FCC rules. Details instructions for maintaining compliance are give in the user manual. 8. The modular transmitter must comply with any applicable RF exposure requirements. The EUT complies with RF exposure requirement - MPE report is submitted Please contact us if you have any additional questions. Best Regards 7layers AG


Document Created: 2012-08-15 09:15:15
Document Modified: 2012-08-15 09:15:15
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC