LMA Letter

FCC ID: XXMOM12000

Cover Letter(s)

Download: PDF
FCCID_1329373

Modular Approval Request Letter Dear Application Examiner, NXP request modular approval for licensed transmitter module [850/900/1800/1900, GSM/ /GPRS Module] with FCC ID: XXMOM12000 Items to be covered Answer from applicant 1. The modular transmitter must have its own RF Yes, The EUT does provide a RF shielding. shielding Refer to EUT Picture. 2. The modular transmitter must have buffered Modulation and generation of data modulation/data inputs (if such inputs are provided) to sent to RF power amplifier is under ensure that the module will comply with Part 15 control of STE PNX4902 baseband. requirements under conditions of excessive data rates or Its design ensures that no over-modulation overmodulation or excessive data rate will occur 3. The modular transmitter must have its own power Power supply regulation is integrated supply regulation. The EUT has its own into baseband PNX4902 and RF power supply regulation power amplifier SKY77531 for mobile communications. For NFC, it is also integrated into NXP PN532, whereas discrete LDOs are used for GPS and microcontroller 4. The modular transmitter must comply with the Only applies to Part 15 Unlicensed antenna requirements of Section 15.203 and 15.204(c). Transmitters. EUT is licensed The antenna must either be permanently attached or transmitter module (22H/24E). employ a “unique” antenna coupler (at all connections between the module and the antenna, including the cable) 5. The modular transmitter must be tested in a stand- The EUT was tested in a stand-alone alone configuration, i.e., the module must not be inside configuration via a test kit. another device during testing. Please see section photographs of test configuration in the test report. 6. The modular transmitter must be labeled with its own Please see exhibition label sample FCC ID number, and, if the FCC ID is not visible when for the FCC ID of this module; and the module is installed inside another device, then the also in the exhibition users outside of the device into which the module is installed manual, there are instructions given must also display a label referring to the enclosed to the OEM on how to label the module. This exterior label can use wording such as the end product. following: “Contains Transmitter Module FCC ID: XXMOM12000o 7. The modular transmitter must comply with any The EUT is compliant with all specific rule or operating requirements applicable to the applicable FCC rules. Details transmitter and the manufacturer must provide adequate instructions for maintaining instructions along with the module to explain any such compliance are give in the user requirements. A copy of these instructions must be manual. included in the application for equipment authorization. 8. The modular transmitter must comply with any The EUT complies with RF exposure applicable RF exposure requirements. requirement - MPE report is submitted


Document Created: 2010-08-19 15:12:17
Document Modified: 2010-08-19 15:12:17
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC