Cover letter - Modular Approval Letter

FCC ID: XXMJN5179M16

Cover Letter(s)

Download: PDF
FCCID_3148680

NXP Semiconductors
2, Esplanade Anton Philips, Campus Effiscience, Colombelles
BP 20 000, 14906 Caen Cedex 9, France



                                                             To: Curtis—Straus LLC TCB
                                                                 One Distribution Center Circle, #1
                                                                 Littleton, MA 02702




                                  Single Modular approval letter

Dear application examiner,

NXP Semiconductors, would like to have your authorization as a modular approval on the
JN5179—001—M16 module, with FCC ID: XXMINS179M16 and IC: 8764A—JN5179M16. The
requirements of CFR 47 part 15.212 and RSP—100 part 5.3 have been checked and shown in
the following statement,

Modular transmitter requirement                                       Yes   No    Comment
(i) The radio elements of the modular transmitter must have their
own shielding. The physical crystal and tuning capacitors may be      X
located external to the shielded radio elements.
(ii) The modular transmitter must have buffered modulation/data
inputs (if such inputs are provided) to ensure that the module will   x
comply with Part 15 requirements under conditions of excessive
data rates or over—modulation.
(iii) The modular transmitter must have its own power supply           x
regulation.
(iv) The modular transmitter must comply with the antenna and
transmission system requirements of Sections 15.203, 15.204(b)
and 15.204(c). The antenna must either be permanently
attached or employ a "unique" antenna coupler (at all                  x
connections between the module and the antenna, including the
cable). The "professional installation" provision of Section 15.203
is not applicable to modules but can apply to limited modular
approvals under paragraph (b) of this section.
(v) The modular transmitter must be tested in a stand—alone
configuration, i.e., the module must not be inside another device      X
during testing for compliance with Part 15 requirements....
(vi) The modular transmitter must be equipped with either a
permanently affixed label or must be capable of electronically
displaying its FCC identification number.

If the FCC ID is not visible when the module is installed inside
another device, then the outside of the device into which the
module is installed must also display a label referring to the         X
enclosed module. This exterior label can use wording such as
the following: "Contains Transmitter Module FCC ID:
XXMIN5179M16 " or "Contains FCC ID: XXMJINS5179M16"
The exact wording is not specified in our Rules (since modules
are not specifically addressed), so you may use similar wording
which expresses the same meaning.


(vii) The modular transmitter must comply with any specific rules
or operating requirements that ordinarily apply to a complete
transmitter and the manufacturer must provide adequate
instructions along with the module to explain any such
requirements. A copy of these instructions must be included in
the application for equipment authorization.

(viii) The modular transmitter must comply with any applicable
RF exposure requirements in its final configuration.

(Shall provide a detailed explanation if the answer is "No.")



The module shall comply with the provisions for external power
amplifiers and antennas detailed in the applicable RSS standard.
The equipment certification submission shall contain a detailed
description of the configuration of all antennas that will be used
with the module.
The module shall comply with applicable RSS—102 exposure
requirements, which are based on the intended
use/configurations
Is the modular device for an Industry Canada licence—exempt
service?
(Shall provide a detailed explanation if the answer is "No.")




Best regards,


Jean LE TOUSEY
Application Engineer



Document Created: 2019-09-22 19:59:09
Document Modified: 2019-09-22 19:59:09

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC