MPE Prediction

FCC ID: XWX-LOS5000

RF Exposure Info

Download: PDF
FCCID_1393612

the wireless lab 9th December 2010 FCC, Part 15 Subpart C §15.407(f) Industry Canada RSS-Gen §5.5 Calculations for Maximum Permissible Exposure Levels Power Density = Pd (mW/cm2) = EIRP/(4πd2) EIRP = P * G P = Peak output power (mW) G = Antenna numeric gain (numeric) d = Separation distance (cm) Numeric Gain = 10 ^ (G (dBi)/10) The peak power in the table below is calculated by assuming a worst case scenario where all of the EUT transmitters are operating simultaneously in the same band. The Peak Power in mW is the highest transmitter power measured and summed across all transmitters. Because the EUT belongs to the General Population/Uncontrolled Exposure the limit of power density is 1.0 mW/cm2 Calculated Peak Peak Minimum Numeric Safe Freq. Band Antenna Output Output Separation Gain Distance @ (MHz) Gain (dBi) Power Power Distance (numeric) 1mW/cm2 (dBm) (mW) (cm) Limit(cm) 2400 – 2500 3.0 2.0 18.52 71.12 3.4 20.00 *Note: for mobile or fixed location transmitters the minimum separation distance is 20cm, even if calculations indicate the MPE distance to be less. Specification Maximum Permissible Exposure Limits §15.247(i) Systems operating under the provisions of this section shall be operated in a manner that ensures that the public is not exposed to radio frequency levels in excess of the Commission’s guidelines. FCC §1.1310 Limit = 1mW / cm2 from 1.310 Table 1 RSS-Gen §5.5 Before equipment certification is granted, the application requirements of RSS-102 shall be met. MiCOM Labs, 440 Boulder Court, Suite 200, Pleasanton, CA 94566 Tel: +1 (925) 462-0304, Fax: +1 (925) 462-0306, Web: www.micomlabs.com


Document Created: 2010-12-09 20:16:24
Document Modified: 2010-12-09 20:16:24
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC