Modular Approval Justification

FCC ID: XPYBMD341

Cover Letter(s)

Download: PDF
FCCID_4473846

u—blox AG Zurcherstrasse 68, Thalwil, Switzerland, Ch—8800 RE FCC ID: XPYBMD341 To the certification reviewer: We are hereby applying for [full] modular approval of the above—referenced FCC ID, based on compliance with [all] of the criteria as detailed below. Sincerely, _z & %‘ c /Z‘// [Cam Nichols] [Senior Engineer] Part 15 Unlicensed Single Modular Transmitter Approval Justification per 15.212 Requirement per 15.212 reference ) The radio elements of the modular Shielding is provided by a metal cover over the transmitter must have their own RF circuitry. shielding. (ii) The modular transmitter must have buffered All modulation and data inputs are buffered by modulation/data inputs (if such inputs are circuitry on the transmitter chip. provided. (ii) The modular transmitter must have its own Power supply regulation is provided by circuitry on power supply regulation. the transmitter chip. (iv) The modular transmitter must comply with External Antenna (Comply with requirements of the the antenna and transmission system FCC part 15.203) requirements of §§ 15.203, 15.204(b) and 15.204(c). (v) The modular transmitter must be tested in a Testing was performed in a stand—alone stand—alone configuration, ie., the module configuration as shown in the test setup photos. must not be inside another device during testing for compliance with Part 15 parameters. (vi) The modular transmitter must be equipped The modular was labeled with its own FCC ID. The with either a permanently affixed label or outside of device in to which the module is installed must be capable of electronically displaying will labeled Contains TX FCC ID: XPYBMD341, its FCC identification number. If the FCC Please refer to User Manual. ID is not visible when the module is installed inside another device, then the outside of the device into which the module is installed must also display a label referring to the enclosed module.

u-blox AG Zürcherstrasse 68, Thalwil, Switzerland, Ch-8800 (vii) The modular transmitter must comply with The modular is comply with all applicable FCC any specific rules or operating requirements rules. that ordinarily apply to a complete transmitter and the manufacturer must Any modifications, not expressly approved by the provide adequate instructions along with the manufacturer could void the authority to operate in module to explain any such requirements. these regions. A copy of these instructions must be included in the application for equipment authorization. (viii) The modular transmitter must comply with This module operates under Part 15 .247 which is any applicable RF exposure requirements in exempt from RF exposure evaluation owing to the its final configuration. very low operating power.


Document Created: 2019-10-10 13:38:16
Document Modified: 2019-10-10 13:38:16
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC