MPE_WiFi

FCC ID: XNAWPM04

RF Exposure Info

Download: PDF
FCCID_4403882

CERPASS TECHNOLOGY CORP. Report No.: TEFI1903241 12. Radio Frequency Exposure 12.1 Applicable Standards The measurements shown in this test report were made in accordance with the procedures given in FCC Part 2 (Section 2.1093) KDB 447498 IEEE C95.1:2005 LIMIT KDB 447498 D01 § 4.3(a) For 100 MHz to 6 GHz and test separation distances ≤ 50 mm, the 1-g and 10-g SAR test exclusion thresholds are determined by the following: [(max. power of channel, including tune-up tolerance, mW) / (min. test separation distance, mm)] · [√f(GHz)] ≤ 3.0 for 1-g SAR, and ≤ 7.5 for 10- *f(GHz) is the RF channel transmit frequency in GHz * Power and dis *The values 3.0 and 7.5 are referred to as numeric thresholds in step b) below The test exclusions are applicable only when the minimum test separation distance is ≤ 50 mm, and for transmission frequencies between 100 MHz and 6 GHz. When the minimum test separation distance is < 5 mm, a distance of 5 mm according to 4.1 f) is applied to determine SAR test exclusion 12.2 EUT Specification Frequency band WLAN: 2412MHz ~ 2462MHz (Operating) Bluetooth: 2402MHz ~ 2480MHz Portable (<20cm separation) Device category Mobile (>20cm separation) Exposure Occupational/Controlled exposure classification General Population/Uncontrolled exposure Single antenna Multiple antennas Antenna diversity Tx diversity Rx diversity Tx/Rx diversity MPE Evaluation* Evaluation applied SAR Evaluation N/A Remark: 1. The maximum conducted output power is 4dBm (2.512mW) at 2462MHz (with 2.8 dBi antenna gain.) 2. DTS device is not subject to routine RF evaluation; MPE estimate is used to justify the compliance. 3. For mobile or fixed location transmitters, no SAR consideration applied. Cerpass Technology Corp. Issued date : May. 27, 2019 T-FD-509-0 Ver 1.0 Page No. : 60 of 61 FCC ID. : XNAWPM04

CERPASS TECHNOLOGY CORP. Report No.: TEFI1903241 12.3 Test Results No non-compliance noted. According to the KDB447498: The SAR test exclusion thresholds Level: [(max. power of channel, including tune-up tolerance, mW) /(min. test separation distance, mm)] * sqrt (freq. in GHz) < 3 Calculation Max. Max. SAR test Channel Conducted Conducted Distance exclusion Frequency output output (mm) thresholds (MHz) power(dBm) power(mW) (mW) 2412-2462 4.00 2.51 5 10.00 Since the source-based time-averaging conducted output power is well below the SAR low threshold level, so the EUT is considered to comply with SAR requirement without testing Cerpass Technology Corp. Issued date : May. 27, 2019 T-FD-509-0 Ver 1.0 Page No. : 61 of 61 FCC ID. : XNAWPM04


Document Created: 2019-06-04 10:43:31
Document Modified: 2019-06-04 10:43:31
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC