Modular Approval Request

FCC ID: XMR201906EM06A

Cover Letter(s)

Download: PDF

FCCID_4229624

RF_734_02
04 April 16

Modular Approval Request FCC (KDB 996369 D01 & Part 15.212)
FCC ID: XMR201906EM06A

Items to be covered by Single modular transmitters. Answer from applicant
1. The modular transmitter must have its own RF shielding. Yes, please see exhibition
external photos
2. The modular transmitter must have buffered modulation/data inputs (if such inputs Yes, The modular has buffer
are provided) to ensure that the module will comply with Part 15 requirements modulation /data inputs
under conditions of excessive data rates or over-modulation.
3. The modular transmitter must have its own power supply regulation. Yes, please see the schem.pdf

4. The modular transmitter must comply with the antenna requirements of Section Yes, The requirements of
15.203 and 15.204(b)(c). The antenna must either be permanently attached or antenna connector and
employ a “unique” antenna coupler (at all connections between the module and the spurious emission have been
antenna, including the cable). fulfilled. Please refer to the
test report exhibition.
5. The modular transmitter must be tested in a stand-alone configuration, i.e., the Yes, Please refer to the setup
module must not be inside another device during testing. This is intended to photo exhibition for the
demonstrate that the module is capable of complying with Part 15 emission limits stand-alone configuration
regardless of the device into which it is eventually installed.

6. The modular transmitter must be equipped with either a permanently affixed label Yes, The Module will be label
or must be capable of electronically displaying its FCC identification number in with its own FCC ID ,and the
accordance with 15.212 (a)(1)(vi)(A) / (B). instruction on the labelling
rule of the end product has
been stated in the user
manual of this module .please
refer to the label and user
manual exhibition.
7. The modular transmitter must comply with any specific rule or operating Yes, The required FCC rule
requirements applicable to the transmitter and the manufacturer must provide has been fulfilled and all the
adequate instructions along with the module to explain any such requirements. A instruction for maintaining
copy of these instructions must be included in the application for equipment compliance have been clearly
authorization. For example, there are very strict operational and timing stated in the user manual.
requirements that must be met before a transmitter is authorized for operation under
Section 15.231. For instance, data transmission is prohibited, except for operation
under Section 15.231(e), in which case there are separate field strength level and
timing requirements. Compliance with these requirements must be assured.

8. The modular transmitter must comply with any applicable RF exposure Yes, Please refer exhibition
requirements. For example, FCC Rules in Sections 1.1310, 2.1091, 2.1093, and RF exposure for the
specific Sections of Part 15, including 15.319(i), 15.407(f), 15.253(f) and compliance of MPE RF
15.255(g), require that Unlicensed PCS, UNII and millimeter wave devices exposure rule.
perform routine environmental evaluation for RF Exposure to demonstrate
compliance. In addition, spread spectrum transmitters operating under Section
15.247 are required to address RF Exposure compliance. Modular transmitters
approved under other Sections of Part 15, when necessary, may also need to
address certain RF Exposure concerns, typically by providing specific
installation and operating instructions for users, installers and other interested
parties to ensure compliance.

Document Created: 2019-03-31 18:30:59
Document Modified: 2019-03-31 18:30:59

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC