User Manual

FCC ID: XHT-1009456

Users Manual

Download: PDF

FCCID_4367233

JUMPING CAR 14+

CONTENTS BATTERIES AND CHARGING
1x Jumping Car The remote control requires 2 “AAA 1.5V alkaline batteries (not included).
1x Remote Control
1x USB Charging Cable REMOTE CONTROL:
• Use a Phillips head or Cross screwdriver to open the battery compartment at
1x 300mAh 3.7V Rechargeable Battery
the base of the remote.
• Insert the AAA 1.5V batteries according to the diagram inside the battery tray.
• Replace battery cover and tighten screw.

CAR:
• The charging port is located on the underside of the vehicle.
• ONLY use the included USB cable.
300mAh
• Useable with standard 5V USB port or charger.

RECHARGEABLE BATTERY WARNING SAFETY PRECAUTIONS
• There is a risk of fire and personal injury if battery is punctured, damaged, • Avoid water when operating.
or misused. • Do not submerge car or controller in water.
• Do not dismantle, crush, incinerate or short-circuit battery. • Do not use people or animals as obstacles.
• Never expose battery to extreme temperatures or moisture. • Do not run car into furniture objects or hard surfaces as this will cause damage
• Keep away from flammable materials and direct sunlight. to both the objects and car.
• Only charge using the provided charger, cable, and/or adapters. • Keep fingers, hair and loose clothing away from the tires, gears and motor while
• Rechargeable battery is only to be charged by an adult. car is switched to “ON’.
• Adult Supervision of the battery while it is charging is required. • Do not leave car or transmitter near sources of heat or under direct sunlight for
• Allow battery to cool to room temperature before charging. long periods of time.
• Charge on a non-flammable surface and keep away from flammable products. • Remove all batteries when not in use to avoid accidental operation.
• Discontinue charging if battery becomes hot, swells, smokes, or gives off a strong odor. • Adult supervision is recommended when operating car.
• Battery chargers used with the product are to be regularly examined for damage to • Thoroughly inspect products before every use. If the product appears worn,
the cord, plug, enclosure, and other parts, and in the event of such damage, they frayed/splintered, cracked, or broken in any manner, discontinue use and discard
must not be used until the damage has been repaired. immediately.
• Remove batteries before storing.
• Recycle or dispose of battery according to federal, state, and local laws.
• Keep these instructions for future reference. WARNING: Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
BATTERY WARNING
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
• Do not mix old and new batteries. protection against harmful interference in a residential installation. This equipment
• Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries. generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
• Alkaline batteries are recommended. Use only the specified voltage. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
• Insert batteries using the correct polarity. Always use, replace, and recharge determined by turning the equipment off and on, the user is encouraged to try to correct the
(if applicable) batteries under adult supervision. interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
• Do not charge with non-rechargeable batteries.
— Increase the separation between the equipment and receiver.
• Do not short-circuit the battery supply terminals. — Connect the equipment into an outlet on a circuit different from that to which the receiver
• Do not dispose of batteries in fire, batteries may explode or leak. is connected.
— Consult the dealer or an experienced radio/ TV technician for help.
• Remove batteries before storing.
• Recycle or dispose of batteries according to federal, state, and local laws.
• Keep these instructions for future reference.
KEEP THIS INSTRUCTION MANUAL AS IT CONTAINS IMPORTANT INFORMATION
FOR FUTURE REFERENCE.
Due to continuous product improvements, the picture on the manual may differ
slightly from the actual product.

© 2019 MerchSource, LLC. Irvine, CA 92618. All rights reserved. FOR TECHNICAL SUPPORT,
PLEASE CALL

1-800-374-2744
Printed in China

Document Created: 2019-04-04 10:24:35
Document Modified: 2019-04-04 10:24:35

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC