Correspondence 2

FCC ID: XAYWHD310V1

Cover Letter(s)

Download: PDF
FCCID_1361561

Tri M. Luu
From:                          Victor H Kee [vic@ultratech-labs.com]
Sent:                          Tuesday, October 05, 2010 3:40 PM
To:                            'Tri M. Luu'; Weili3@aol.com
Subject:                       RE: 10FCC034_TELT-004Q - letter of findings from FCCIC Certifier


Gentlemen

I cannot certify an application that has incomplete or inappropriate test data. The User’s manual clearly states that the
device is connected to a personal computer and specialized software for the personal computer is provided to interact
with the device. This device does fall under Computer Peripheral device and is subject to DoC requirements including
the DoC labeling. Please refer to ANSI C63.4‐2003 Section 11.1.2 for proper EUT operating conditions. Also note that
ANSI C63.4‐2003 procedures do not provide for excluding certain emissions from a tested system.

In addition, ANSI C63.4‐2003 Section 12.1.1.2 requires both receivers be tested with a received CW signal. A statement
or some other indication must be provided in the test report to satisfy this requirement.


Best Regards,

Victor H. Kee, P.Eng
VP Marketing & Business Development
Chief Certificaiton Officer TCB Program
Ultratech Group of Labs
www.ultratech-labs.com
========================================================================
CONFIDENTIALITY NOTICE
‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐
This message, together with any attachments, may be legally privileged and is confidential information intended only for the use of
the individual or entity to which it is addressed. It is exempt from disclosure under applicable law including court orders. If you are
not the intended recipient, you are hereby notified that any use, dissemination, distribution or copy of this message, or any
attachment, is strictly prohibited. If you have received this message in error, please notify the original sender and delete this
message, along with any attachments, from your computer




From: Weili3@aol.com [mailto:Weili3@aol.com]
Sent: Tuesday, October 05, 2010 11:59 AM
To: tri@ultratech-labs.com
Subject: Re: 10FCC034_TELT-004Q - letter of findings from FCCIC Certifier

Hi, Tri.

Thanks for the input.

We normally follow the setup requirements in C63.4 for FCC testing on PC peripherals. However, this EUT is not qualified
as PC peripheral ( in the "restricted" definition), especially for IC Transceiver certification. The PC in the picture will be for
one of receiving mode configuration. Therefore, minizing "additional " emissions is the proper way to go. Also the monitor
and printer will not affect this EUT's EMC performance based on our investigation except their own emissions which were
identified before and can be excluded. I think this configuration shall be applicable to this application.

Regards,

                                                                   1


Wei

In a message dated 10/5/2010 10:00:28 A.M. Eastern Daylight Time, tri@ultratech-labs.com writes:

Hi Wei:



Refer to ANSI C63.4 test procedure, when the EUT is connected to the PC, the PC must be
set up with minimum configuration: 1 monitor, 1 key board, 1 mouse, 1 printer. Your photos of
test setup does not show this MINIMUM configuration for testing a PC peripheral device per
ANSI C63.4.



Tri Luu




From: Weili3@aol.com [mailto:Weili3@aol.com]
Sent: Monday, October 04, 2010 6:57 PM
To: tri@ultratech-labs.com
Subject: Re: 10FCC034_TELT-004Q - letter of findings from FCCIC Certifier




Hi, Tri.




Please see the revised report with DoC data ( PC mode) integrated and findings addressed ( in data sections).
All pages are included in this attachment.




Hopefully, this will be the last run for this filing.




Best regards,




Wei


                                                           2


In a message dated 10/1/2010 1:48:46 P.M. Eastern Daylight Time, tri@ultratech-labs.com writes:

Gentlemen:



Please find the letter of findings from the FCC/IC certifier as below:




From: Victor H Kee [mailto:vic@ultratech-labs.com]
Sent: Friday, October 01, 2010 1:38 PM
To: 'Tri M. Luu'; 'Dharmajit'
Subject: 10FCC034_TELT-004Q




Gentlemen,



I have the following items to address before proceeding with the certification;



Certifier’s Report:

 Item     Certifier’s findings & comments:                                                                  Problems
   #                                                                                                        resolved?
   1      FCC-IC-RPT-data-F AC Conducted emissions table showing at least 6 measurement points of
          QP/AVG measurements not present.
   2      FCC-IC-RPT-data-F Receiving mode – there is no evidence that a stimulating signal for both
          receivers were used to stimulate receiver during radiated and conducted emissions measurements.
          The frequency range of receive mode emissions measurement should be specified. There is no
          indication if the receive mode tests were conducted while connected to the USB cable. Block
          diagram would be helpful.
   3      User Manual and operating description specifies USB port “WZRDchat™ uses a
          USB connection to provide a user-friendly PC interface for text messaging and
          network monitoring. WZRDchat also allows uploading of GPS

          coordinates and modification of node settings. The WZRDchat application serves
          as a gateway to a local Personal Computer (PC) and the Internet where
          available”. Connection to personal computers require DoC to be applied and the
          device should be tested in that mode.
   4      FCC-IC-RPT-data-F Table of contents lists setup photos and appendix page 27
          &29 yet report. Last page of report states 25 of 37. The report appears
          incomplete.

                                                               3


Best Regards,




Victor H. Kee, P.Eng

VP Marketing & Business Development

Chief Certificaiton Officer TCB Program

Ultratech Group of Labs

www.ultratech-labs.com

========================================================================

CONFIDENTIALITY NOTICE
----------------------------------------

This message, together with any attachments, may be legally privileged and is confidential information intended
only for the use of the individual or entity to which it is addressed. It is exempt from disclosure under applicable
law including court orders. If you are not the intended recipient, you are hereby notified that any use,
dissemination, distribution or copy of this message, or any attachment, is strictly prohibited. If you have received
this message in error, please notify the original sender and delete this message, along with any attachments, from
your computer




                                                                   4



Document Created: 2010-10-05 15:46:20
Document Modified: 2010-10-05 15:46:20

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC