Annex to User manual

FCC ID: XAM300011GR04

Users Manual

Download: PDF
FCCID_2043613

Communication Mobile Computing Portable Lighting Measurement & Calibration FCC Compliance Statement for RFID-Reader Model No.TLB 30, LID, UNI 13 This Statement is part of the User Manual Caution: This marking indicates that the user should read all included documentation before use. Retain this supplement for future reference Users of this product are cautioned to use accessories and peripherals approved by ecom instruments GmbH. The use of accessories other than those recommended, or changes to this product that are not approved by ecom instruments GmbH, may void the compliance of this product and may result in the loss of the user’s authority to operate the equipment. Laser Compliance and Precaution The SN-SE955 is registered with the CDRH as a Class II Laser Product (21 CRF Subchapter J, Part 1040). This product has a maximum output of 1 mW at 630 to 670 nm. Caution: There are no user serviceable parts inside the SE955. Use of controls or adjustments, or performance of procedures other than those specified herein, may result in hazardous laser light exposure of up to mW at 630 to 670 nm. Complies with 21CFR1040.10 and 1040.11 except for deviations pursuant to Laser Notice No. 50,0 dated July 26, 2001. EN60825-1:1994+A1:2002+A2:2001 IEC60825-1:1993+A1:1997+A2:2001 Caution: Use of controls, adjustments or performance of procedures other than those specified herein may result in hazardous laser light exposure. Class 2 laser scanners use a low power, visible light diode. As with many very bright light source, such as the sun, the user should avoid staring directly into the light beam. Momentary exposure to a Class 2 laser is not known to be harmful. U.S.A. Digital Emissions Compliance For a Class A digital device or peripheral, the user instructions shall include the following or similar statement, placed in a prominent location in the text of the manual: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment

Communication Mobile Computing Portable Lighting Measurement & Calibration is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. FCC § 15.19 labeling requirements This device complies with part 15 of the FCC Rules and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. FCC § 15.21 Information to user Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Canadian Digital Apparatus Compliance This device complies with Industry Canada license-exempt RSS standards. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Industry Canada Statements Le present appareil est conforme aux CNR d’Industrie Canada applicaables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes: 1) L’appareil ne doit pas produire de brouillage, et 2) l’utilisat de l’appareil doit accepter tout brouillage radioélectrique sui, meme si le brouillage est susceptible d’en compromettre le fonctionnement.

Communication Mobile Computing Portable Lighting Measurement & Calibration CE Compliance Statement Caution: This marking indicates that the user should read all included documentation before use. Retain this supplement for future reference Users of this product are cautioned to use accessories and peripherals approved by ecom instruments GmbH. The use of accessories other than those recommended, or changes to this product that are not approved by ecom instruments GmbH, may void the compliance of this product and may result in the loss of the user’s authority to operate the equipment. Caution: For use with ecom AM Ci70 -Ex only. See battery instructions. No user-serviceable parts. Charge only with the charging devices mentioned in section 4. “Safety Regulations”. Use of incorrect charger may present a risk of fire or explosion. 802.11 Radio Precaution Statement Caution: Users are responsible for configuring the channels of operation that comply with their country regulatory standards. A Wireless Network Administrator should review the operating restrictions detailed within the Access Point installation manual. Radiation Exposure Statement Warning: This equipment complies with International Commission on Non-Ionizing Radiation Protection (ICNIRP), IEEE C95.1, Federal Communications Commission Office of Engineering and Technology (OET) Bulletin 65, Canada RSS-102, and European Committee for Electrotechnical Standardization (CENELEC) limits for exposure to radio frequency (RF) radiation. If a body worn accessory is not purchased from ecom, the accessory must contain no metal.

Communication Mobile Computing Portable Lighting Measurement & Calibration Laser Compliance and Precaution This product complies with the following standards for laser safety: IEC 60825-1:2007/EN 60825-1:2008-05: Class 2 (1 mW, 630 – 670 nm) EU – R&TTE Declaration ecom instruments GmbH declares that this device is in accordance with the essential requirements and other provisions of R&TTE Directive (1995/5/EC). 0700 This product is marked with this logo and uses radio frequency bands that are not harmonized throughout the European Union and other countries as noted in the table below. This equipment may be operated in the following countries without restriction: AT, BE, CY, CZ, DK, EE, FI, DE, GR, HU, IE, IT, LV, LT, LU, MT, NL, PL, PT, SK, SI, ES, SE, GB, IS, LI, CH, BG, RO, TR Copyright© 2013 ecom instruments GmbH. Der Inhalt dieses Dokuments darf ohne vorherige schriftliche Genehmigung durch die ecom instruments GmbH in keiner Form, weder ganz noch teilweise ver- vielfältigt, weitergegeben, verbreitet oder gespeichert werden. Der Inhalt dieses Dokuments wird so präsentiert, wie er aktuell vorliegt. Die ecom instruments GmbH übennimmt weder ausdrücklich noch stillschweigend irgendeine Gewährleistung für die Richtigkeit oder Vollständigkeit des Inhalts dieses Dokuments, einschließlich, aber nicht beschränkt auf die stillschweigende Garantie der Markttauglichkeit und der Eignung für einen bestimmten Zweck, es sei denn, anwendbare Gesetze oder Rechtsprechungen schreiben zwingend eine Haftung vor. Die ecom instruments GmbH behält sich das Recht vor, jederzeit ohne vorherige Ankündigung Änderungen an diesem Dokument vorzunehmen oder das Dokument zurückzuziehen. Copyright© 2013 ecom instruments GmbH. The contents of this document, either in part or in their entirety, may not be reproduced, forwarded, distributed or saved in any way without ecom instruments GmbH prior written consent. The contents of this document are presented as they currently exist. ecom instruments GmbH does not provide any express or tacit guarantee for the correctness or com- pleteness of the contents of this document, including, but not restricted to, the tacit guarantee of market suitability or fitness for a specific purpose unless applicable laws or court decisions make liability mandatory. ecom instruments GmbH reserves the right to make changes to this document or to withdraw it any time without prior notice. WEEE-Reg.-Nr. DE 934 99306 300011AL15E00 Änderungen vorbehalten. Subject to change. ecom instruments GmbH · Industriestr. 2 · 97959 Assamstadt · Germany Phone: + 49 (0) 62 94 / 42 24 0 · Fax: + 49 (0) 62 94 / 42 24 100 E-Mail: sales@ecom-ex.com · www.ecom-ex.com


Document Created: 2013-08-14 16:34:01
Document Modified: 2013-08-14 16:34:01
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC