Users Manual

FCC ID: X3A-MG321356M

Users Manual

Download: PDF
FCCID_2050416

Keypad & Proximity Flash Mount Reader Installation Manual Mounting: 1. Install the metal plate on the wall with two or four screws, which depends on different kinds of Recommendation: gang box being installed1. 1. Linear DC Power Supply; 2. The cover shall clip on the upper edge 2 the push in the bottom part as show in 2. 22AWG shielded cable; it’s required to do “one-point” ground. (As shown in the diagram) diagram3. 3. Tighten the secure non-dropout screw, which located underneath of the reader to fix the reader and the back plate4, installation is completed. Color Label Description Red +12V dc Power Supply to the reader Black GND Signal GND Green Data0 Wiegand Output data, D0 White Data1 Wiegand Output data, D1 Specification: Yellow RED LED RED LED control, active low. Blue Green LED Green LED control, active low Input Voltage (at Typical Read DC10V~15V > 5cm Brown Buzzer input, active low Reader end) range Buzzer Maximum Cable Orange Tamper Tamper output (open collector, Active low, max 100mA) Operating Current 160mA (max) 150m Length Wiring: Operating Number pad 4 bits burst by default -30ºC~70 ºC Temperature format Power up Sequences: 1. When reader is powered up, the Green back will flicker for 5 seconds. The reader will beep

Keypad & Proximity Flash Mount Reader Installation Manual once and the reader is in Ready mode. Troubleshooting: 2. Present the card. The Blue LED will flicker once; buzzer will beep once. Trouble List Solution 3. When card is present and read by the reader, blue back lit will flash once; and buzzer will z Discount the power and confirm that the power supply cable is beep once as well. The card data will then transmit to the controller. After, weather the back lit No Response correctly connected (See “Wiring” above). of the reader will remain ON or Flash or change to Green or Red color, this shall depend on when Power Up z Check the input voltage is sufficient (See “Specifications” above). the Green and Red LED inputs. 4. For number pad reader, when a number is pressed and successfully detected, the back lit Auto Restart z Check the input voltage is sufficient (See “Specifications” above). under the number will flash 1 time and the buzzer will beep once. The number being pressed z Check the format setting on the controller if it is the same as the card will burst out by default (4 bits burst). Cannot read card format. Use approved card (known format and Facility Code) to test. number correctly z Check if the shield cable is correctly connected to Classis Ground at Physical Dimension: ONE point only. z Check if data 0 & data 1 cable is correctly connected (See “Wiring” Reader beeps but above). No card data info z Check the input voltage at the card reader end is correct (See “Specifications” above). Buzzer error z Check if the buzzer cable is correctly connected (See “Wiring” above). z Check the Led cable is correctly connected (See “Wiring” above). Back Lit Error z Use Default Configuration Card to set it back to normal.


Document Created: 2019-07-14 08:25:13
Document Modified: 2019-07-14 08:25:13
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC