User Manual Show Cmd

FCC ID: X27-FS-V200

Users Manual

Download: PDF

FCCID_4007808

Sheet1

CLI show command
show ms bsid it should display the mac address of the BS. cross checked with HW addr in BS.
it should display the mac and phy load
currently used.
HW version, mac FW and phy FW version phy and mac load is fine. Others needs
show ms version given in the msconfig should be displayed. clarification

ip configurations set in the msconfig should be
displayed irrespective of STATIC_IP_CONFIG
show ms ipconfig enabled or disabled in the config file. cross checked with config file
it should display all the configurations in the ms
show ms sysconfig config file exept for ip config. cross checked with config file
it should display radio configurations set in the
show ms radioconfig ms config file. cross checked with config file
it should display scan configurations set in the cross checked with config file and
show ms scanconfig ms config file. changes are reflected upon soft reboot.
it should display phy configurations set in the
show ms phyconfig ms config file. cross checked with config file
it should display the current state of the MS.
When NE is happened it should display as
MS_OPERATIONAL.
When BS is switched off it shows DCD_UCD MS_OPERATION and DCD_UCD
show ms state acquired acquired state is verified.
it should display all the basic capabilities
show ms capabilities supported by the MS.
upon giving this command consecutively the
number of sdus in and out should keep
show ms con statistics increasing when the NE is successful
it should display the dcd configurations set in
the ucddcd config file for BS EIRP,
show ms dcd EIRxPirmax, TTG, RTG, BSID. BSID needs to be clarified
clarrified ms state, ms mac addr, ms ip
addr, ms peer addr others needs to be
show ms info clarified.

Page 1

Sheet1
it should display all the l1If statistics like
number of DL Burst received from l1if , UL
show ms l1if statistics burst sent to l1If.

it should display maximum buffer available,
used and freed and also number of enqueued,
dequeued, totally available and free msgs in a
show ms memory statistics msg queue.

show ms rf statistics it should display rf antenna statistics.
it should display maximum sdu nodes
show ms sdu pool statistics available, used and freed
it should display informations of each service
flows like: phs rule supporting a SF, cid of a
shwo ms sfinfo SF
it should display the number of sdus received,
sent, dropped, memory allocated, errors
show ms statistics occured in the system.
it should display the numbers of timers created,
show ms timer statistics started, deleted, expired.
it should display ucd configurations :number of
init ranging codes, periodic ranging codes, BW
ranging codes, HO ranging codes from the
show ms ucd UCDDCD config file. cross checked with config file
it should display CINR, Rx Gain, RSSI, fec
show ms measurement report code used values.
show ms ulmap burst <count>
show ms ulmap error <count>
show ms ulmap rcvd <count>
show ms csm statistics
show ms timing
show ms transmitted packet
show ms trigger metrics

show ms tx power it should display MS tx power to the serving BS
show ms sainfo

Page 2

Sheet1
show ms dlmap error <count>
show ms dlmap rcvd <count>
show ms decoded burst <count>
show ms encoded burst <count>
show ms received packet <count>

Page 3

Document Created: 2018-08-09 12:12:07
Document Modified: 2018-08-09 12:12:07

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC