Test report

FCC ID: WWEIHQI2114

Test Report

Download: PDF

FCCID_4453655

Page 2 of 29 Report No.: A1908188-C01-R01

TABLE OF CONTENTS

1. Test Result Summary .............................................................................. 5
2. General Information................................................................................. 6
2.1. DESCRIPTION OF DEVICE (EUT) ............................................................................................................. 6
2.2. ACCESSORIES OF DEVICE (EUT)............................................................................................................ 7
2.3. TESTED SUPPORTING SYSTEM DETAILS ................................................................................................. 7
2.4. BLOCK DIAGRAM OF CONNECTION BETWEEN EUT AND SIMULATORS ....................................................... 7
2.5. DESCRIPTION OF TEST MODES ............................................................................................................... 7
2.6. TEST CONDITIONS ................................................................................................................................. 7
2.7. TEST FACILITY ...................................................................................................................................... 8
2.8. MEASUREMENT UNCERTAINTY ............................................................................................................... 8
2.9. TEST EQUIPMENT LIST ........................................................................................................................... 9

3. Test Results and Measurement Data ................................................... 10
3.1. CONDUCTED EMISSION ........................................................................................................................ 10
3.2. RADIATED SPURIOUS EMISSION MEASUREMENT ................................................................................... 13
3.3. TEST SPECIFICATION ........................................................................................................................... 19

4. Antenna Requirements ......................................................................... 21
4.1. LIMIT................................................................................................................................................... 21
4.2. RESULT .............................................................................................................................................. 21

5. Photos of test setup .............................................................................. 22
6. Photographs of EUT .............................................................................. 24

Page 4 of 29 Report No.: A1908188-C01-R01

Revision History
Revision Issue Date Revisions Revised By
V0 September 02, 2019 Initial released Issue Simple Guan

Page 5 of 29 Report No.: A1908188-C01-R01

1. Test Result Summary

Requirement CFR 47 Section Result

Antenna requirement §15.203 PASS

AC Power Line Conducted
§15.207 PASS
Emission

Spurious Emission §15.209(a)(f) PASS

Occupied Bandwidth §15.215 (c) PASS
Note:
1. PASS: Test item meets the requirement.

2. Fail: Test item does not meet the requirement.

3. N/A: Test case does not apply to the test object.

4. The test result judgment is decided by the limit of test standard.

Page 6 of 29 Report No.: A1908188-C01-R01

2. General Information
2.1. Description of Device (EUT)
EUT Name : Airstand Wireless Charging

Model No. : IHQI2114B-WM, IHQI2114N-WM, IHQI2112, IHQI2114,
IHQI2114-WM, IHQI2115, IHQI2115-AZ
All model’s the function, software and electric circuit are the
same, except the color and model number are different, the
DIFF. : color is divided into black, Navy, Brown, White, Coral and
Pastel Green. this report performs the model
IHQI2114B-WM.

Trademark : iHome

Power supply : Input : 5V/2.0A, 9V/1.67A
Wireless Output : 5W/7.5W/10W

Operation frequency : 125-205KHz

Modulation : MSK

Antenna Type : Coil Antenna

Software version : V1.0

Hardware version : S01D190719

Page 8 of 29 Report No.: A1908188-C01-R01

2.7. Test Facility
Shenzhen Alpha Product Testing Co., Ltd
Building i, No.2, Lixin Road, Fuyong Street, Bao'an District, 518103, Shenzhen, Guangdong,
China

June 21, 2018 File on Federal Communication Commission
Registration Number: 293961

July 15, 2019 Certificated by IC
Registration Number: CN0085

2.8. Measurement Uncertainty
(95% confidence levels, k=2)
Item MU Remark
Uncertainty for Conducted Emission Test 2.74dB

Uncertainty for Radiation Emission test in 3m chamber 2.13 dB Polarize: V
(below 30MHz) 2.57dB Polarize: H
Uncertainty for Radiation Emission test in 3m chamber 3.77dB Polarize: V
(30MHz to 1GHz) 3.80dB Polarize: H

Uncertainty for Radiation Emission test in 3m chamber 4.16dB Polarize: H
(1GHz to 25GHz) 4.13dB Polarize: V
Uncertainty for radio frequency 5.4×10-8
Uncertainty for conducted RF Power 0.37dB

Page 11 of 29 Report No.: A1908188-C01-R01

3.1.2. Test data

Please refer to following diagram for individual

Test Mode : Full Load, Half Load, Empty Load
Test Results : PASS
Note: The test results are listed in next pages.
This mode is worst case mode, so this report only reflected the worst mode.
If the limits for the measurement with the average detector are met when using a
receiver with a peak detector, the test unit shall be deemed to meet both limits
and the measurement with the average detector and quasi-peak detector need
not be carried out.
If the limits for the measurement with the average detector are met when using a
receiver with a quasi-peak detector, the test unit shall be deemed to meet both
limits and the measurement with the average detector need not be carried out.

Page 15 of 29 Report No.: A1908188-C01-R01

maximizes the emissions. The measurement
antenna elevation for maximum emissions shall be
restricted to a range of heights of from 1 m to 4 m
above the ground or reference ground plane.
2. Corrected Reading: Antenna Factor + Cable Loss +
Read Level - Preamp Factor = Level
3. For measurement below 1GHz, If the emission level
of the EUT measured by the peak detector is 3 dB
lower than the applicable limit, the peak emission
level will be reported. Otherwise, the emission
measurement will be repeated using the quasi-peak
detector and reported.
4. Use the following spectrum analyzer settings:
(1) Span shall wide enough to fully capture the
emission being measured;
(2) Set RBW=100 kHz for f < 1 GHz; VBW ≥ RBW;
Sweep = auto; Detector function = peak; Trace =
max hold;
(3) Set RBW = 1 MHz, VBW= 3MHz for f  1 GHz
for peak measurement.
For average measurement: VBW = 10 Hz, when
duty cycle is no less than 98 percent. VBW ≥1/T,
when duty cycle is less than 98 percent where T is
the minimum transmission duration over which the
transmitter is on and is transmitting at its maximum
power control level for the tested mode of operation.
Test results: PASS

Page 16 of 29 Report No.: A1908188-C01-R01

3.2.2. Test Data
Please refer to following diagram for individual
Frequency
: 9KHz~30MHz
Range
Test Mode : TX: channel low, channel mid, channel high (Full Load)
Test Results : PASS
Note: 1. The test results are listed in next pages.
2. This mode is worst case mode, so this report only reflected the worst mode.
3. If the limits for the measurement with the average detector are met when using
a receiver with a peak detector, the test unit shall be deemed to meet both limits
and the measurement with the quasi-peak detector need not be carried out.

Antenna Cable Amp
Freq. Reading Result Limit Margin State
Factor loss Factor Detect
(dBuV/m) or
(MHz) (dBuV/m) dB/m dB dB (dBuV/m) (dB) P/F
at 3 m
0.125 44.57 48.34 0.16 29.87 63.20 126.77 -63.57 PK PASS
0.125 33.06 48.34 0.16 29.87 51.69 106.77 -55.08 AV PASS
0.175 43.94 48.34 0.16 29.87 62.57 122.95 -60.38 PK PASS
0.175 35.84 48.34 0.16 29.87 54.47 102.95 -48.48 AV PASS
0.205 45.99 48.38 0.17 29.89 64.65 120.76 -56.11 PK PASS
0.205 35.64 48.38 0.17 29.89 54.30 100.76 -46.46 AV PASS
0.35 40.87 48.44 0.19 29.89 59.61 117.78 -58.17 PK PASS
0.35 33.60 48.44 0.19 29.89 52.34 97.78 -45.44 AV PASS
0.45 40.00 48.47 0.19 29.89 58.77 115.35 -56.58 PK PASS
0.45 32.25 48.47 0.19 29.89 51.02 95.35 -44.33 AV PASS
1.928 17.68 49.12 0.2 29.94 37.06 60 -22.94 QP PASS
1.920 21.98 49.12 0.2 29.94 41.36 60 -18.64 QP PASS

Page 17 of 29 Report No.: A1908188-C01-R01

Frequency
: 30MHz~1000MHz
Range
Test Mode : Full Load, Half Load, Empty Load
Test Results : PASS
Note: 1. The test results are listed in next pages.
2. This mode is worst case mode, so this report only reflected the worst mode.
3. If the limits for the measurement with the average detector are met when using
a receiver with a peak detector, the test unit shall be deemed to meet both limits
and the measurement with the quasi-peak detector need not be carried out.

Frequency
: Above 1GHz
Range
EUT : / Test Date : /
M/N : / Temperature : /
Test Engineer : / Humidity : /
Test Mode : /
Test Results : N/A
1. The highest frequency of the internal sources of the EUT is less than 108 MHz,
Note: the measurement shall only be made up to 1 GHz. So the frequency rang above
1GHz radiation test not applicable.

Page 21 of 29 Report No.: A1908188-C01-R01

4. Antenna Requirements
4.1. Limit
15.203 requirement:
An intentional radiator shall be designed to ensure that no antenna other than that
furnished by the responsible party shall be used with the device. The use of a
permanently attached antenna or of an antenna that uses a unique coupling to the
intentional radiator, the manufacturer may design the unit so that a broken antenna can
be replaced by the user, but the use of a standard antenna jack or electrical connector
is prohibited.
4.2. Result
The antenna is coil antenna which permanently attached. It complies with the standard
requirement.

Document Created: 2019-09-16 08:53:41
Document Modified: 2019-09-16 08:53:41

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC