User Manual

FCC ID: W8U49S517

Users Manual

Download: PDF

FCCID_3694982

Hi! Let’s get started.

S-Series
S517

DO NOT RETURN TO STORE

WE ARE
READY TO TCL SUPPORT:
www.tclusa.com/support
HELP contact us ﬁrst
with any questions 1-877-300-8837

TAKE CARE WHEN
REMOVING THE TV

VISIT US AT WWW.TCLUSA.COM

Important Safety Instructions
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus
(including ampliﬁers) that produce heat.
9. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles,
and the point where they exit from the apparatus.
10. WARNING: Please refer the information on exterior bottom enclosure for electrical and safety
information before installing or operating the apparatus.
11. WARNING: The mains plug is used as disconnect device, the disconnect device shall remain readily
operable.
12. When not in use and during movement, please take care of the power cordset, e.g. tie up the power
cordset with cable tie or something like that. It shall be free from sharp edges and the like that can cause
abrasion of the power cordset. When put into use again, please make sure the power cordset being not
damaged, If any damages found, please look for the service person to replace the power cordset speciﬁed
by the manufacturer or have the same characteristics as the original one.
13. No naked ﬂame sources, such as lighted candles, should be placed on the apparatus.
14. Unplug this apparatus during lightning storms or when unused for long periods of time.
15. Only use attachments/accessories speciﬁed by the manufacturer.
16. Use only with the cart, stand, tripod, bracket, or table speciﬁed by the manufacturer,
or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus
combination to avoid injury from tip-over.
17. Refer all servicing to qualiﬁed service personnel. Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate
normally, or has been dropped.
18. For safe operation of the apparatus, observe these installation requirements:
Keep at least 2 inches of ventilation space between the rear cover of the apparatus and the wall.
Keep at least 1 inch of ventilation space between the apparatus and all other surfaces. Do not allow any
of the apparatus’ ventilation openings to be blocked by objects that might obstruct them, such as;
newspapers, curtains, table-cloths or any other objects. Do not expose the apparatus to any external heat
sources. Do not place any heat sources such as candles, lamps, etc. on the apparatus. Do not expose the
device to high levels of humidity or to any possible sources of moisture. When disposing of used batteries
rom the remote control, consult local regulations regarding proper disposal.
19. If an outside antenna or cable system is connected to the product, be sure the antenna or cable system
is grounded so as to provide some protection against voltage surges and built-up static charges. Section
810 of the National Electrical Code, ANSI/NFPA No. 70-2011 (Section 54 of Canadian Electrical Code,
Part 1) provides information with respect to proper grounding of the mast and supporting structure,
grounding of the lead in wire to an antenna-discharge unit, size of grounding conductors, location of
antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.
See following example:

ANTENNA LEAD IN WIRE

GROUND CLAMP

ANTENNA DISCHARGE UNIT
(NEC SECTION 810-20)

GROUNDING CONDUCTORS
(NEC SECTION 810-21)
GROUND CLAMPS
ELECTRIC SERVICE POWER SERVICE GROUNDING
EQUIPMENT ELECTRODE SYSTEM (NEC ART
250, PARTH)

2

What’s in the box

TCL Roku TV AV Input cable adapter TV stands

4 x Stands screws 2 x VESA mount spacers 4 x VESA screws
M5X25mm for models of 49” 2 PCs: M6X30mm
M5X18mm for models of 43” 2 PCs: ST3X10mm

TVremote 2 x AAA batteries
for remote

What you need
Make the most of your Smart TV

Phillips head
screwdriver Router + Internet Connection
(needed for streaming)

For additional support , please see User Manual at: www.TCLUSA.com/support
Key things to know: A paid subscription or other payments may be required for some streaming channels.
Channel availability subject to change and varies by country.

3

Step 1 Set up your TV
Ready for the step-by-step? You’re only minutes away from TV bliss!
Remove your TV from the box
Be careful, it’s heavy!
To use the stand
A To prevent damage to the screen, carefully
place your TV on a soft, cushioned surface.
B Put the column of the stands into the TV, align the
stands with the screw holes located on the TV.
C Secure the stands to the TV with four (4) screws.

TV TV

Stand Screws Stand
(M5 X 25mm)

Warning:
Never place a television set in an unstable location. A television set may fall, causing serious
personal injury or death. Many injuries, particularly to children, can be avoided by taking simple
precautions such as:
- Using cabinets or stands recommended by the manufacturer of the television set.
- Only using furniture that can safely support the television set.
- Ensuring the television set is not overhanging the edge of the supporting furniture.
- Not placing the television set on tall furniture (for example, cupboards or bookcases)
without anchoring both the furniture and the television set to a suitable support.
- Not placing the television set on cloth or other materials that may be located between
the television set and supporting furniture.
- Educating children about the dangers of climbing on furniture to reach the television
set or its controls.
If your existing television set is being retained and relocated, the same considerations as
above should be applied.

4

Step 1 Set up your TV
To mount on a wall
Preparation must be done before mounting your TV on a wall.
First, connect all the cables, ﬁx the AV terminal cover onto the TV (refer to page 4).

VESA mount spacers

Screw off the 2 screws on the Put the plastic VESA mount spacers into
back of the TV. the VESA holes in the back cover.

Screw the VESA bracket tightly
onto the back cover with the VESA
screws attached in the accessary bag.

If you are mounting your TV to the wall, don’t attach the stands.
To mount your TV to the wall, purchase a VESA wall mount
Purchase a VESA 200x200, 2 M6x30 screws
Models of 49” and 43”
and 2 ST3X10mm screws

Note: you can use the VESA screws attached in the accessory bag.

The VESA number is the horizontal and vertical measurement of the mounting holes. For
example, 200X200 refers to the fact that the mounting measurements are 200mm horizontally
and 200mm vertically.
Follow the instructions that come with the wall mount.
Your wall mount must be able to bear a minimum of ﬁve times the TV’s net weight to avoid
causing damage.

5

Step 5 Complete guided setup

It’s the ﬁnal stretch—hurray!
Let’s Connect
Your TV will automatically detect wireless networks in your area. Have your network name and
password handy and follow the easy on-sceen instructions. You can also connect using an
Ethernet cable.

Your Roku account: Once connected, your TV will walk you through
a guided setup, where you'll be prompted to create (or sign into) your
free Roku account online at roku.com/link. Your TV will generate a
unique code that links your TV to your account.
Roku accounts are free, and while a valid credit card is recommended, it is not
required. If you choose to register with a credit card, you will be able to
seamlessly rent movies, TV shows and download apps without having to enter
in your credit card information each time. A unique PIN can be added to the
account to prevent unauthorized purchases.

Once you’re connected, your TV will automatically update with the latest software—plus you can
/0.0ƫ/0.!)%*#ƫ0$!ƫ!*0!.0%*)!*0ƫ5+1ƫ'*+3ƫ* ƫ(+2!ċƫ*(%'!ƫ+0$!.ƫ/Čƫ5+1.ƫ*!3ƫ ƫđƫ+'1ƫƫ
automatically receives regular software updates in the background when it’s connected to the
internet. This allows it to give you a better and better experience.

If you aren’t ready to connect your TV to a wireless network, you can still use it as a regular TV.

And setup is done…congratulations!
Continue using the remote to personalize your Home screen and channel line-up, stream movies,
and so much more.
If you have an antenna or cable connected, just click the tuner tile to watch broadcast TV channels.
The fun has just begun!

8

TTE Technology, Inc. (“TTE”) Limited Warranty
LIMITATION OF WARRANTY
THE WARRANTY STATED ABOVE IS THE ONLY WARRANTY APPLICABLE TO THIS PRODUCT. NO
VERBAL OR WRITTEN INFORMATION GIVEN BY TTE TECHNOLOGY, INC., ITS AGENTS OR EMPLOYEES
SHALL CREATE A GUARANTEE OR IN ANY WAY INCREASE OR MODIFY THE SCOPE OF THIS WARRANTY.
REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF
THE CONSUMER. TTE TECHNOLOGY, INC. SHALL NOT BE LIABLE FOR SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THIS PRODUCT OR ARISING OUT OF ANY
BREACH OF ANY EXPRESS OR IMPLIED WARRANTY ON THIS PRODUCT. THIS DISCLAIMER OF
WARRANTIES AND LIMITED WARRANTY ARE GOVERNED BY THE LAWS OF THE STATE OF
CALIFORNIA. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ANY IMPLIED WARRANTY
OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ON THIS PRODUCT IS LIMITED TO
THE APPLICABLE WARRANTY AND WARRANTY PERIOD SET FORTH ABOVE. THIS WARRANTY IS
SUBJECT TO CHANGE WITHOUT NOTICE. PLEASE VISIT WWW.TCLUSA.COM TO VIEW THE MOST
CURRENT VERSION.

How State Law relates to this warranty:
Some states do not allow the exclusion or limitation of incidental or consequential damages, or limitations
on how long an implied warranty lasts, so the above limitations or exclusions may not apply to you.
This warranty gives you speciﬁc legal rights, and you also may have other rights that vary from state to
state.

If you purchased your unit outside the United States or seek warranty coverage
outside the United States:
This warranty does not apply. Contact your dealer for warranty information.

Service calls which do not involve defective materials or workmanship are not
covered by this warranty. Costs of such service calls are the sole responsibility
of the purchaser.

Broadcasting & Operating Environment
Broadcasting system US System NTSC-M
ATSC standard (8VSB), QAM

Receiving Channels VHF2-13
UHF14-69
CATV 14-36 (A)-(W)
37-59 (AA)-(WW)
60-85 (AAA)-(ZZZ)
86-94 (86)-(94)95-99 (A-5)-(A-1)
100-135 (100)-(135)
01 (4A)

Tuner type Frequency synthesized

Operating Temperature 5°C to 35°C (41°F to 95°F)

Operating Humidity 20% to 80%, non-condensing

Storage Temperature -15°C to 45°C (5°F to 113°F)

Storage Humidity 10% to 90%, non-condensing

11

Document Created: 2017-12-22 13:31:55
Document Modified: 2017-12-22 13:31:55

© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC