FCC LMA letter

FCC ID: W2Z-02100002

Cover Letter(s)

Download: PDF
FCCID_1926852

FUJiFILM 7—8,AKASAKA 9—CHOME MINATO—KU, TOKYO 107—005%, JAPAN March 27, 2013 ECC ID : W2Z—02100002 Model : DWMWO92 Applicant : Fuji Film Corporation Request for Limited Modular Transmitter Approval This WLAN Module (Model: DWM WO92) is designed by Fuji Film Corporation. This modular transmitter complies with the modular transmitters basic requirements (Item 1 to 8) in FCC Part 15 Subpart C Section 15.212 as indicated below: Modular Approval Checklist: Modular approval requirement Yes No (1) Haveits own RF shielding. HX O (2) Have buffered modulation/data inputs. X O (3) Have its own power supply regulation. H O (4) Comply with the antenna and transmission systemrequirements of § 15.203, []] O 15.204(b) and 15.204(c). (5) Tested in a stand—alone configuration. KX C Unless the transmitter module will be battery powered, it must comply with the AC line conducted requirements found in FCC § 15.207. AC or DC power lines and data input/output lines connected to the module must not contain ferrites, unless they will be marketed with the module. The length ofthese lines shall be the length typical of actual use or, if that length is unknown, at least 10 centimeters to insure that there is no coupling betweenthe case ofthe module and supporting equipment. Any accessories, peripherals, or support equipment connected to the module during testing shall be unmodified and commercially available. (6) Equipped with either a permanently affixed label or must be capable of electronically displaying its FCC ID. If the FCC ID is not visible when the module is installed inside another device, then the outside of the device into which the module is installed must also display a label referring to the enclosed module. (7) Comply with any specific rules or operating requirements that ordinarily apply to a complete transmitter and the manufacturer must provide adequate jnstructions along with the module to explain any such requirements. (8) Comply with any applicable RF exposure requirements in its final This module complies with any configuration: The modular transmitter complies with FCC radiation exposure

FUJIFILM 7—3,AKASAKA 9—CHOME MINATO—KU, TOKYO 107—0052, JAPAN applicable RF exposure requirements in requirement. its final configuration. However this module applies for limited module approval because SAR testing was performed in the specific host product. Therefore this will be installed the limited product that meets this SAR value, (Body SAR<0.4 W/kg) Please refer to SAR Test Report. Mitsuyuki Komiya Fuji Film Corporation


Document Created: 2013-03-27 13:06:14
Document Modified: 2013-03-27 13:06:14
© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC