User manual

FCC ID: VYY-DM35LE-S

Users Manual

Download: PDF
FCCID_2824953

Note：When the battery power is low,you can hear the alarm ten "beep" every time the motor runs. It indicates the battery needs to be charged. Then plug in the charger with red light.The light turns green when the battery is fully charged. Signal wire Tubular Motor- DM35LE/S Functional featuresᱶ 85 Integrated radio control Jogging&tilt function Specification Setting up+add emitter+delete emitter Motor direction setting option Resistance stop function Set electronic limit Set /delete the third limit position Low standby power -10 Operating temperature Parameter Rechargeable Description The motor has a built-in battery,using the charger to Type DM35LE/S recharge.You can also use solar panels to charge;when the battery is low, insert thecharge,charger light shows Rated Torque(N.m) 3N.m red light.batteries isfull when the red light turns to green. （A-OO） Rated speed(RPM) 28RPM Rated Voltage(V) 12V Emission frequency(MHz) 433.925MHz 1. Please charge the battery and make sure it is fully charged before the first use 2. Don’t operate motors wheuin low wltage alarm: ᰷Motor stop running When the supply voltage is lower than 7 v， and it will restart again when the voltage is greater than 7.5V ᰸If the voltage is less than 10v, the motor will alarm for 10 times to prompt it needs to be charged every timewhen the motor is working. 3. Optratingᱶ ᰷The valid interval of the emitter button is 10s,the emitter will quit the set after 10s ᰸The motor will run or beep for hint,please do the next step after the hint. 4. Set limit positionᱶ ᰷After the up limit and down limit setting,and the up limit down limit and third limit position are at the same location ᰸After limit setting，with power and memory function; ᰹Into the match-code status 2 minutes later, it will quit out the setting limits status automatically ᰺It will delete every memory and restore the factory settings 5. When the motor running without any operation, the maximum running time is 6 minutes,it will stop automatically 6. If the emitterlost,please set up again with new emitter


Document Created: 2019-09-29 13:46:45
Document Modified: 2019-09-29 13:46:45
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC