User Manual

FCC ID: VYY-DC6010

Users Manual

Download: PDF
FCCID_3689034

A Matchable R tubular motor setting up Delete all the datas of the motor and the new emitter has been programmed. Additional function DC6010 During the settings,the time between Up×1 Run or beep two operation must be shorter than for hint 4s,otherwise it will quit the setting 1 2 OK Emitter Specification 3 P2×1 P2×1 4 5 Set up is ok. STOP Sound from motor The up button control hear long sound Beep once Beep once the motor clockwise Version NO. : A/00 Down×1 Run or beep Power on T 1 2 3 for hint OK Type specification When you press the Setting button, the required use of tools,don’t be too sharp tool. 4 Set up is ok. 5 STOP The down button control the motor clockwise A Matchable DC1680 setting up During the settings,the time between two operation must be shorter than } LED 1 Additional 6s,otherwise it will quit the setting 2 function 3 Channel Press (up+down)×1 Indicator Stop×1 Indicator long Up×1 Indicator flashing selection at the same time flashing flashing then extinguished 4 5 Setting 1 button 2 (P2) OK 3 STOP 4 5 Up button Down button STOP Setting is ok Power on DC1680 DC1680 DC1680 DC1680 DC1680 Bracket 5-channel emitter Back A Matchable DC136 setting up During the settings,the time between two operation must be shorter than 10s,otherwise it will quit the setting Additional function Setting button×1 Indicator Stop×1 Indicator long Up×1 Indicator flashing flashing flashing then extinguished T Technical support 1 2 3 4 OK 5 Setting STOP is ok Power on DC136 DC136 DC136 DC136 DC136 Technical specification Fucntion instruction Input voltage：3V(CR2430) DC6010 is 5-channel emitter,red light represents the currently selected channel, press the current channel again, cancel selected channel, Transmitting frequency：433MHz when all the red light is bright, on behalf of the group control state. Transmitting power：10 milliwatt Press stop, up, down key when the red light fast flash tips. Operating temperature：-100C—500C Transmssion distance：200 meters open office， CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED 35 meters on two walls BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS Notice: transmitter do not exposed to moisture and strike, so as not to affect life.When you use transmitter, if found emission distance obviously short or less sensitive, please change another same new battery. Please have batteries for recycling.

FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.


Document Created: 2017-12-05 09:20:58
Document Modified: 2017-12-05 09:20:58
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC