User Manual

FCC ID: VYY-DC1670

Users Manual

Download: PDF
FCCID_2720790

A Matchable R tubular motor set up Delete all the datas of the motor and the new emitter has been programmed. Additional function During the settings,the time between DC1670 two operation must be shorter than 4s,otherwise it will quit the setting Up×1 EmitterSpecification Run or beep P2 ×1 P2 ×1 for hint OK Sound from motor Set up is ok. hear long sound Beep once Beep once The up button control the motor clockwise Version NO. : B/01 T Type specification Power on Down×1 Run or beep for hint OK Set up is ok. The down button control LED the motor clockwise Setting 3 Up button button (P2) A Matchable DC1680 set up Stop button Additional function Down During the settings,the time between button two operation must be shorter than 6s,otherwise it will quit the setting DC1670 Press (up+down)×1 Indicator Stop×1 Indicator long Up×1 Indicator flashing at the same time flashing flashing then extinguished Single - channel emitter OK Setting is ok Power on DC1680 DC1680 DC1680 DC1680 DC1680 T Technical support A Matchable DC136 set up Additional function During the settings,the time between Technical specification Fucntion instruction two operation must be shorter than 10s,otherwise it will quit the setting Input voltage碋3V (CR2430) DC1670 single channel emitter;Size:80mmX80mm; Transmitting frequency碋433MHz Transmitting power碋10 milliwatt Setting button×1 Indicator Stop×1 Indicator long Up×1 Indicator flashing Operating temperature碋-100C—500C flashing flashing then extinguished Transmssion distance碋200 meters open office硽 Notice: transmitter do not exposed to moisture and strike, so as not to affect life. When you use transmitter, if found emission distance obviously short or less sensitive, 35 meters on two walls please change another same new battery. Please have batteries for recycling. OK Setting is ok Power on DC136 DC136 DC136 DC136 DC136

FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ǂ Reorient or relocate the receiving antenna. ǂ Increase the separation between the equipment and receiver. ǂ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ǂ Consult the dealer or an experienced radio/TV technician for help.


Document Created: 2015-08-13 08:47:20
Document Modified: 2015-08-13 08:47:20
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC