User Manual

FCC ID: VW7-SE80AC

Users Manual

Download: PDF
FCCID_4264354

SE80 Quick Start Guide

Details To minimize unwanted AC line noise that may degrade the performance of your SE80, take advantage of the filtered outlet on the unit for powering your AC devices - especially USB and other cell phone chargers, dimmer-capable lamps, plasma TVs and other devices employing switching power supplies. Plug a power strip into the SE80 for additional filtered capacity. The bottom of the unit has a reset button and a gigabit Ethernet port.

Installing your SE80ac Connect one end of an Ethernet cable into the Ethernet port of the SE80ac and the other end to a LAN port on a SmartOS router. Plug the SE80ac into a nearby electrical outlet. The LED flashes red. Wait for the LED to flash white. This pro- cess may take about 2 minutes. Once the LED stays white, you can unplug the SE80ac and move it to the location where you want it. The LEDs repeat the colors and flashing. When the light glows solid white again, connection is accomplished and you can log into your network. 3

FCC Interference Statement This device complies with Part 15 of the Federal Communication Commission Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio fre- quency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: l Reorient or relocate the receiving antenna. l Increase the separation between the equipment and receiver. l Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. l Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for com- pliance could void the user's authority to operate this equipment.

This transmitter must not be co-located or operating in conjunction with any other antenna or trans- mitter. Operations in the 5.15-5.25GHz band are restricted to indoor usage only. Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with greater than 20cm between the radiator & your body. Industry Canada statement This device complies with ISED’s licence-exempt RSSs. Operation is subject to the following two con- ditions: (1) This device may not cause harmful interference, and (2) this device must accept any inter- ference received, including interference that may cause undesired operation. Le présent appareil est conforme aux CNR d’ ISED applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) le dispositif ne doit pas produire de brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y compris un brouillage susceptible de provoquer un fonctionnement indésirable. 5

Caution : (i) the device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems; (iii) where applicable, antenna type(s), antenna models(s), and worst-case tilt angle(s) necessary to remain compliant with the e.i.r.p. elevation mask requirement set forth in section 6.2.2.3 shall be clearly indicated. Avertissement: (i) les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement pour une util- isation à l’intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux; (iii) lorsqu’il y a lieu, les types d’antennes (s’il y en a plusieurs), les numéros de modèle de l’antenne et les pires angles d’inclinaison nécessaires pour rester conforme à l’exigence de la p.i.r.e. applicable au masque d’élévation, énoncée à la section 6.2.2.3, doivent être clairement indiqués. Radiation Exposure Statement This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with greater than 20cm between the radiator & your body.

Déclaration d'exposition aux radiations Cet équipement est conforme aux limites d'exposition aux rayonnements ISED établies pour un environ- nement non contrôlé. Cet équipement doit être installé et utilisé à plus de 20cm entre le radiateur et votre corps. 7


Document Created: 2019-04-12 14:36:52
Document Modified: 2019-04-12 14:36:52
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC