05 User Manual

FCC ID: VPYLXRF052

Users Manual

Download: PDF
FCCID_4159993

User Manual

Since this module is not sold to general end users directly, there is no user manual of module.


For the details about this module, please refer to the specification sheet of module.


This module should be installed in the host device according to the interface specification (installation
procedure).


The following information must be indicated on the host device of this module;


 [for FCC]

 Contains Transmitter Module FCC ID: VPYLXRF052
or
 Contains FCC ID: VPYLXRF052


  This device complies with part 15 of the FCC Rules. Operation is subject to the following two
  conditions: (1) This device may not cause harmful interference, and (2) this device must accept
  any interference received, including interference that may cause undesired operation.
*If it is difficult to describe this statement on the host device due to the size, please describe in the user's
manual and also either describe on the device packaging or on a removable label attached to the device.




 [for ISED(IC)]

 Contains IC: 772C-LXRF052


The following statements must be described on the user manual of the host device of this module;


[for FCC]


 FCC CAUTION
 Changes or modifications not expressly approved by the party responsible for compliance
 could void the user’s authority to operate the equipment.

 This transmitter must not be co-located or operated in conjunction with any other antenna or
 transmitter.

 This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
 environment and meets the FCC radio frequency (RF) Exposure Guidelines. This equipment
 should be installed and operated keeping the radiator at least 20cm or more away from person’s
 body.


[for ISED(IC)]


 This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
 Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to
 the following two conditions:
 1.This device may not cause interference.
 2.This device must accept any interference, including interference that may cause undesired
 operation of the device.
 L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
 d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio
 exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
 1.L’appareil ne doit pas produire de brouillage;
 2.L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
 susceptible d’en compromettre le fonctionnement.

 This equipment complies with ISED radiation exposure limits set forth for an uncontrolled
 environment and meets RSS-102 of the ISED radio frequency (RF) Exposure rules. This
 equipment should be installed and operated keeping the radiator at least 20cm or more away
 from person’s body.
 Cet équipement est conforme aux limites d’exposition aux rayonnements énoncées pour un
 environnement non contrôlé et respecte les règles d’exposition aux fréquences radioélectriques
 (RF) CNR-102 de l’ISDE. Cet équipement doit être installé et utilisé en gardant une distance de
 20 cm ou plus entre le radiateur et le corps humain.


The following notice is not for end users but for the manufacturer of the host device.
Therefore it isn’t described on the user manual of the host device.

 This radio transmitter (772C-LXRF052) has been approved by Innovation, Science and Economic
 Development Canada to operate with the antenna types listed below, with the maximum
 permissible gain indicated. Antenna types not included in this list that have a gain greater than
 the maximum gain indicated for any type listed are strictly prohibited for use with this device.
           Antenna type                        Gain                          Impedance
        LXRFZZUCCA-034                       -1.6 dBi                          50 ohm
        LXRFZZUCCA-036                      -16.0 dBi                          50 ohm
 Le présent émetteur radio (772C-LXRF052) a été approuvé par Innovation, Sciences et
 Développement économique Canada pour fonctionner avec les types d'antenne énumérés ci‑
 dessous et ayant un gain admissible maximal. Les types d'antenne non inclus dans cette liste, et
 dont le gain est supérieur au gain maximal indiqué pour tout type figurant sur la liste, sont
 strictement interdits pour l'exploitation de l'émetteur.
          Type d’antenne                           Gain                  l'impédance
         LXRFZZUCCA-034                          -1.6 dBi                   50 ohm
        LXRFZZUCCA-036                          -16.0 dBi                   50 ohm



Document Created: 2019-01-08 11:32:54
Document Modified: 2019-01-08 11:32:54

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC