FCC LMA Letter

FCC ID: VPYLBYR650

Cover Letter(s)

Download: PDF
FCCID_1986416

Murata Manufacturing Co., Ltd. June 5, 2013 FCC ID : VPYLBYR650 Model : LBWAIUSYRL Applicant : Murata Manufacturing Co., Ltd. Request for Limited Modular Transmitter Approval This WLAN Module (Model: LBWA1IUSYR1) is designed by Murata Manufacturing Co., Ltd.. This modular transmitter complies with the modular transmitters basic requirements (Item 1 to 8) in FCC Part 15 Subpart C Section 15.212 as indicated below: Modular Approval Checklist: Modular approval requirement Yes No (1) Have its own RF shielding. M 1 (2) Have buffered modulation/data inputs. X C (3) Have its own power supply regulation. HX C (4) Comply with the antenna and transmission system requirements of § [X] J 15.203, 15.204(b) and 15.204(c). (5) Tested in a stand—alone configuration. [X J Unless the transmitter module will be battery powered, it must comply with the AC line conducted requirements found in FCC § 15.207. AC or DC power lines and data input/output lines connected to the module must not contain ferrites, unless they will be marketed with the module. The length of these lines shall be the length typical of actual use or, if that length is unknown, at least 10 centimeters to insure that there is no coupling between the case of the module and supporting equipment. Any accessories, peripherals, or support equipment connected to the module during testing shall be unmodified and commercially available. (6) Equipped with either a permanently affixed label or must be capable of [] [X electronically displaying its FCC ID. Since there is no space which indicates If the FCC ID is not visible when the module is installed inside another FCC ID, FCC ID is not indicated on device, then the outside of the device into which the module is installed the label. So FCC ID is indicated in the must also display a label referring to the enclosed module. manual, then the outside of the device into which the module is installed also displays a label referring to the enclosed module. (7) Comply with any specific rules or operating requirements that ordinarily [ J apply to a complete transmitter and the manufacturer must provide adequate instructions along with the module to explain any such requirements.

Murata Manufacturing Co., Ltd. (8) Comply with any applicable RF exposure requirements in its final configuration: The modular transmitter complies with FCC radiation exposure requirement. TAKAHARU KAWAKATSU Technology Management Department General Manager Murata Manufacturing Co., Ltd.


Document Created: 2019-07-17 01:59:19
Document Modified: 2019-07-17 01:59:19
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC