FCC LMA Letter

FCC ID: VPYLBYD

Cover Letter(s)

Download: PDF
FCCID_2181998

Murata Manufacturing Co., Ltd. Request for Limited Modular Transmitter Approval January 22, 2014 FCCID : VPYLBYD Applicant : Murata Manufacturing Co., Ltd. This transmitter, model: TypeYD is designed by us. It complies with the modular transmitters basic requirements (Item 1 to 8) in FCC Part 15 Subpart C Section 15.212 as indicated below: Modular Approval Checklist: Modular approval requirement Yes No (1) Have its own RF shielding. [ [] (2) Have buffered modulation/data inputs. [ [] (3) Have its own power supply regulation. MX This module has the power supply regulator. However the one of input voltages to RF part don‘t go through the regulator. The stable voltage will be supplied by end product. Therefore end product will be required to have the power supply regulator. (4) Comply with the antenna and transmission system requirements C K of § 15.203, 15.204(b) and 15.204(c). (5) Tested in a stand—alone configuration. [X Unless the transmitter module will be battery powered, it must The modular transmitter has been comply with the AC line conducted requirements found in FCC § performed the testing in a state of being 15.207. AC or DC power lines and data input/output lines installed on a test jig board simulating connected to the module must not contain ferrites, unless they will the board of the installed end product, therefore has not been performed the be marketed with the module. The length of these lines shall be the testing as a stand alone and then length typical of actual use or, if that length is unknown, at least 10 confirmed the compliance. The module centimeters to insure that there is no coupling between the case of and antenna will be mounted on a board the module and supporting equipment. Any accessories, similar to the one shown in the test set peripherals, or support equipment connected to the module during photo, and the board will be installed in testing shall be unmodified and commercially available. the end product. (6) Equipped with either a permanently affixed label or must be [X capable of electronically displaying its FCC ID. Since there is no space which indicates If the FCC ID is not visible when the module is installed inside FCC ID, FCC ID is not indicated on the another device, then the outside of the device into which the module label. So FCC ID is indicated in the manual, then the outside of the device is installed must also display a label referring to the enclosed into which the module is installed also module. displays a label referring to the enclosed module. (7) Comply with any specific rules or operating requirements that _1 ordinarily apply to a complete transmitter and the manufacturer must provide adequate instructions along with the module to explain any such requirements. (8) Comply with any applicable RF exposure requirements in its L final configuration: The modular transmitter complies with FCC radiation exposure requirement. Tabal.are EerckaTzu Takaharu Kawakatsu Technology Management Department General Manager Murata Manufacturing Co., Ltd.


Document Created: 2014-01-22 17:00:02
Document Modified: 2014-01-22 17:00:02
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC