FCC LMA letter

FCC ID: VIYARC0517

Cover Letter(s)

Download: PDF
FCCID_1845527

November 12, 2012 FCC ID : VIYARCO517 Model : ARCO517 Applicant : Hosiden Corporation Request for Limited Modular Transmitter Approval This Bluetooth Module (Model: ARCQO517) is designed by Hosiden Corporation. This modular transmitter complies with the modular transmitters basic requirements (Item 1 to 8) in FCC Part 15 Subpart C Section 15.212 as indicated below: Modular Approval Checklist: Modular approval requirement Yes No (1) Have its own RF shielding. 0A M Although this module does not bave RF shielding, this modular transmitter will be equipped 3D active eyewear, complies with FCC/IC requirements. Please refer to the FCC/IC Test reports and External Photo. (2) Have buffered modulation/data inputs. M C (3) Have its own power supply regulation. [X m (4) Comply with the antenna and transmission system requirements of § [X O 15.203, 15.204(b) and 15.204(c). (5) Tested in a stand—alone configuration. 0A M Unless the transmitter module will be battery powered, it must comply with The modular transmitter has not the AC line conducted requirements found in FCC § 15.207. AC or DC been performed the testing in a power lines and data input/output lines connected to the module must not stand—alone, has been performed contain ferrites, unless they will be marketed with the module. The length of the testing in the 3D active these lines shall be the length typical of actual use or, if that length is eyewear, because this module does unknown, at least 10 centimeters to insure that there is no coupling between not have RF shielding. Therefore the case of the module and supporting equipment. Any accessories, this modular transmitter will be peripherals, or support equipment connected to the module during testing equipped only the 3D active shall be unmodified and commercially available. eyewear. (6) Equipped with either a permanently affixed label or must be capable of X] C electronically displaying its FCC ID. If the FCC ID is not visible when the module is installed inside another device, then the outside of the device into which the module is installed must also display a label referring to the enclosed module. (7) Comply with any specific rules or operating requirements that ordinarily [X] D apply to a complete transmitter and the manufacturer must provide adequate

e HOSIDEN &3 instructions along with the module to explain any such requirements. (8) Comply with any applicable RF exposure requirements in its final configuration: The modular transmitter complies with FCC radiation exposure requirement. /zif/\//(%f, Keiji Mine Section Manager Hosiden Corporation


Document Created: 2012-11-15 13:08:39
Document Modified: 2012-11-15 13:08:39
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC