User manual

FCC ID: VA5SBDH10-2WLE

Users Manual

Download: PDF
FCCID_4506263

              User Manual

Model Name        FCC ID Number         IC Number

AB-BLE-550       VA5SBDH10-2WLE      7087A-2WSBDH10LE




             www.aquabedwarmer.com


FCC / IC Compliance


FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that

   may cause undesired operation.

CAUTION: Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate this device.

This equipment should be installed and operated with minimum 20 cm between the radiator and your
body.

IC
This device complies with Industry Canada license-exempt RSS standard(s).

Operation is subject to the following two conditions:

(1) this device may not cause interference, and

(2) this device must accept any interference, including interference that may

   cause undesired operation of the device.



Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence.

L’exploitation est autorisée aux deux conditions suivantes :

(1) l’appareil ne doit pas produire de brouillage, et

(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi,

   même si le brouillage est susceptible d’en compromettre le fonctionnement.

Cet appareil doit être installé et utilisé avec un minimum de 20 cm entre le radiateur et votre corps.


Table of Contents

Welcome         ....................................................................................................................... 03

USB Connector                       .................................................................................................. 03

Important Safety Precautions                             ............................................................................. 04

Standard Components                        ........................................................................................... 05

Getting Started             ........................................................................................................... 05

Initial Setup             ............................................................................................................. 05

System Operation                  ..................................................................................................... 06

Temperature Units (Fahrenheit/Celsius)                          ...................................................................... 07

Setting Operating Time             .................................................................................................... 07

Time Options                   ......................................................................................................... 07

Setting Operating Temperature                                 ......................................................................... 08

Temperature Options                           ......................................................................................... 08

Safety Features                  ...................................................................................................... 08

Cleaning and Storage                      ............................................................................................. 09

Water Replacement                          ............................................................................................ 09

Troubleshooting                ........................................................................................................ 09

Error Codes                ............................................................................................................ 09

Product Registration                         .......................................................................................... 10

Warranty Policy                   ..................................................................................................... 10

Aqua BedWarmer Support                               .................................................................................. 11


Welcome
The Aqua Bed Warmer provides outstanding comfort by adding warmth to
your night's rest. Find relaxation with your Aqua Bed Warmer using the water
you already have at home. The Aqua Bed Warmer utilizes a system of sturdy
tubing that distributes heated water evenly throughout the connected pad.
With a wide range of temperature selections, the bed warmer offers control
over the level of warmth at your disposal.


USB connector

ATTENTION

This unit features a USB connector. This unit is not for a PC product.
To reduce damage to this product, do not attempt to insert the USB connector
into Personal Computer.
Do not attempt to modify the USB connector.
Serious damage to the appliance and household electrical system can occur.


Important Safety Precautions
1. Carefully read all instructions before handling product.
2. Do not handle system when hands are wet.
3. Do not immerse system or any system component in water.
4. Plug the USB connector in an aqua bed warmer controller only.
5. Do not pull the cord at the USB cable, pull at the grip.
6. Do not operate with damaged cord or any other damaged component(s).
7. Take off the product when cleaning and/or replacing unit water.
8. Do not place sharp objects near any component.
9. Shutoff the system immediately if any water is found near any component.
10. Use the system indoors only.
11. Place unit on firm, flat surface.
12. Do not move unit around electrical systems.
13. Keep away from children.


Getting Started
Before First Use
1. Read and review all safety information and product guidelines.

2. Inspect all product components for factory defects.

3. Dispose of product packaging components properly.




Initial Setup
1. Turn off the Aqua Bed Warmer Controller

2. Connect the usb cable to the USB connector at the rear of the Aqua Bed Warmer
   Controller.

3. Connect the usb cable to the USB connector at the rear of AB-BLE-550.

4. Attach the AB-BLE-550 to the back of the Aqua Bed Warmer Controller.

5. Turn on the Aqua Bed Warmer Controller


System Operation
Temperature Units (Fahrenheit/Celsius)

1.   To change the unit of
     temperature on the display,
     press the POWER button to
     deactivate the system.

2. Press Settings.

3. Press TEMP to switch
   between degrees Fahren-heit
   or Celsius.

4. Press Save and POWER to
   reactivate the system.



Setting Operating Time

1. With the unit ON, the display will indicate the
   current temperature of the system.

2. To view the set operating time, press TIME.

     The display will indicate the number of hours
     the system will continue to operate at the set
     temperature.

3. To change the operating time, press TIME
   until the projected operating time is
   displayed and then the UP or DOWN arrows until the desired number of hours is
   reached.



Time Options

           Minimum                         Default           Maximum
            1 Hour                         8 Hours           24 Hours


Setting Operating Temperature
1. With the unit ON, the display will indicate the
   current temperature of the system.

2. To view the set operating temperature, press
   TEMP. The display will indicate the projected
   temperature in either Fahrenheit or Celsius,
   according to the current setting.

3. To change the operating temperature, press
   TEMP     until   the   projected   operating
   temperature is displayed and then the UP or
   DOWN arrows until the desired temperature is
   reached.




Temperature Options
          Minimum                         Default                   Maximum
             50 ℉                           90 ℉                      158 ℉
          ( 10 ℃ )                       ( 32 ℃ )                   ( 70 ℃ )



Safety Features
1. Automatic shut-off when the unit is tipped over

2. Display indicates when the water level has reached full level.

3. System automatically indicates when internal temperature falls below 39 ℉ to prevent
   freezing.


Cleaning and Storage

Cleaning
1. Clean the appliance with a dry cloth.

2. IMPORTANT – Do not wipe the product with wet cloth.




Storage
1. IMPORTANT – Disconnect the power from the unit before removing from the system.

2. Place system directly above a large, open container.

3. Remove the USB cable from the Aqua Bed warmer controller

4. Separate the AB-BLE-550 from the Aqua Bed warmer controller.




Troubleshooting
Error Codes

            Code                       Description                 Troubleshoot
             E1                     Low Water Level                Insert Water
             E2                    Temperature Sensor             Contact Support
             E3                     Circulation Pump              Contact Support
             E4                            Heater                 Contact Support
             E5                     System Overheat               Contact Support
             E6                    Water Level Sensor             Contact Support


RF Specification
1. Supported protocols : Bluetooth® Low Energy

2. RF Transmitter Characteristics : 2.4GHz Band, 1 Mbps Data Rate




Product Registration
This product must be registered within 10 days of purchase to validate war -ranty. To register,
complete and return the included warranty registration card or register online at
www.aquabedwarmer.com.




Warranty Policy
Aqua BedWarmer comes with a 2year limited warranty from the date of purchase for the
original owner. The product must be registered within 10 days to validate warranty. If a
defect in the heater unit and/or mat arises, the item(s) may be replaced under warranty.
Unit(s) exhibiting damage and/or evidence of unauthorized modification will be void of
warranty coverage.




Aqua BedWarmer Support
21903 68th Avenue South

Kent, WA USA 98032

Phone: (888) 820-3690 #112

Email: warranty@aqua-bedwarmer.com

Web: www.aqua-bedwarmer.com


            Published By
             Firstech, LLC
      21903 68th Avenue South
         Kent, WA 98032U.S.
         Tel: 1-888-820-3690
     www.aqua-bedwarmer.com
© 2012 Firstech LLC. All rights reserved.



Document Created: 2019-11-04 17:34:51
Document Modified: 2019-11-04 17:34:51

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC