SAR photos

FCC ID: U4GJX2W

Test Setup Photos

Download: PDF
FCCID_2455797

The Testcenter facility ‘Dosimetric Test Lab’ within IMST GmbH is accredited by the German National ‘Deutsche Akkreditierungsstelle GmbH (DAkkS)’ for testing according to the scope as listed in the accreditation certificate: D-PL-12139-01-00. Appendix for the SAR Test Report Dosimetric Assessment of the Portable Device Datalogic Joya X2 PLUS (FCC ID: U4GJX2WB / IC: 3862E-JX2WB) According to the FCC Requirements November 20, 2014 IMST GmbH Carl-Friedrich-Gauß-Str. 2 - 4 D-47475 Kamp-Lintfort Customer 7layers AG Borsigstrasse 11 D-40880 Ratingen The test results only relate to the items tested. This report shall not bereproduced except in full without the written approval of the testing laboratory. SAR_Report_7layers_60320_6140261_FCC_WiFi_Body_Joya_X2PLUS_Pictures_V2 Page 1 of 5

SAR_Report_7layers_60320_6140261_FCC_WiFi_Body_Joya_X2PLUS_Pictures_V2 Page 2 of 5 Compliance Statement The Datalogic Joya X2 PLUS handheld is in compliance with the following standards for uncontrolled exposure:  47 CFR § 2.1093 [47CFR],  IEEE Std. C95.1 - 1999 [C95.1-1999],  The latest version of all relevant FCC OET KDB Procedures SAR assessment in body worn configuration was conducted with a closest distance of 0 mm between the housing of the device and the flat phantom. According to manufacturer information the assessed Datalogic Joya X2 PLUS (FCC: U4GJX2WB / IC: 3862E-JX2WB) is technical identical with the Joya X2 (FCC: U4GJX2W / IC: 3862E-JX2W) except of the integrated Bluetooth module. Both device variants use identical motherboards but in case of Datalogic Joya X2 PLUS the components related to Bluetooth are assembled and in case of Joya X2 not. Accordingly the Datalogic Joya X2 PLUS was selected as worst case hardware configuration. Since the output power for Bluetooth module is below the threshold, SAR assessment for Bluetooth is not applicable. Therefore, it is deemed that the Joya X2 is also in compliance with the above mentioned measurements standards. Subject of Investigation SAR_Report_FCC_DECT_WiFI_Head_Body_1.0/10.12.2013/AR Fig. 1: Pictures of the device under test.

SAR_Report_7layers_60320_6140261_FCC_WiFi_Body_Joya_X2PLUS_Pictures_V2 Page 3 of 5 The maximum result of SAR for the Joya X2 PLUS is as follows: WORST CASE SAR RESULTS Frequency Phantom Fig Measured Reported SAR Limit CH [MHz] Config. No. SAR1g [W/kg] SAR1g [W/kg] [W/kg] IEEE 802.11 b 2462 11 Pos. 4 1 0.714 0.748 1.6 PASS prepared by: ........................................ reviewed by: ..................................... Alexander Rahn André van den Bosch test engineer quality assurance engineer 7.9 Pictures of the Device under Test Figure 7 shows the device under test. SAR_Report_FCC_DECT_WiFI_Head_Body_1.0/10.12.2013/AR Fig. 7: Device under test Datalogic Joya X2 PLUS.

SAR_Report_7layers_60320_6140261_FCC_WiFi_Body_Joya_X2PLUS_Pictures_V2 Page 4 of 5 7.10 Test Positions for the Device under Test Fig. 8 – 11 show the test positions for the SAR measurements. Fig. 8: Body worn configuration, position 1, front side towards the phantom. SAR_Report_FCC_DECT_WiFI_Head_Body_1.0/10.12.2013/AR Fig. 9: Body worn configuration, position 2, back side towards the phantom.

SAR_Report_7layers_60320_6140261_FCC_WiFi_Body_Joya_X2PLUS_Pictures_V2 Page 5 of 5 Fig. 10: Body worn configuration, position 3, left side towards the phantom. SAR_Report_FCC_DECT_WiFI_Head_Body_1.0/10.12.2013/AR Fig. 11: Body worn configuration, position 4, right side towards the phantom.


Document Created: 2014-11-21 15:26:16
Document Modified: 2014-11-21 15:26:16
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC