RF Exposure

FCC ID: TV7R11E4G

RF Exposure Info

Download: PDF
FCCID_4039595

RF EXPOSURE EVALUATION 1. PRODUCT INFORMATION Product Description Mini-pcie card R11e-4G Model Name R11e-4G FCC ID TV7R11E4G 2. EVALUATION METHOD AND LIMIT Human exposure to RF emissions from mobile devices (47 CFR §2.1091) may be evaluated based on the MPE limits adopted by the FCC for electric and magnetic field strength and/or power density, as appropriate, since exposures are assumed to occur at distances of 20 cm or more from persons. LIMITS FOR GENERAL POPULATION / UNCONTROLLED EXPOSURE Frequency E-field Strength Magnetic Field Power Density Averaging Time Range (E) Strength (H) (S) |E|2, |H|2 or S (MHz) (V/m) (A/m) (mW/cm2) (Minutes) 0.3 -- 1.34 614 1.63 (100)* 30 1.34 -- 30 824/f 2.19/f (180/f2)* 30 30 -- 300 27.5 0.073 0.2 30 300 -- 1500 -- -- f/1500 30 1500 -- 100,000 -- -- 1.0 30 *Note: 1. f= Frequency in MHz * Plane-wave Equivalent Power Density 2. The averaging time for General Population/Uncontrolled exposure to fixed transmitters is not applicable for mobile and portable transmitters. See 47 CFR §§2.1091 and 2.1093 on source-based time-averaging requirement for mobile and portable transmitters. S=PG/4πR² Where: S=power density P=power input to antenna G=power gain of the antenna in the direction of interest relative to an isotropic radiator R=distance to the center of radiation of the antenna

AGg 23 2 2.3 ® Attestation of Global Compliance CALCULATION A minimum test separation distance > 20 cm is required between the antenna and radiating structures of the device and nearby persons to apply mobile device exposure limits. The distance must be at least 20 cm and fully supported by the operating and installation configurations of the transmitter and its antenna(s), according to the source—based time—averaged maximum power requirements of § 2.1091(d)(2). In cases where cable losses or other attenuations are applied to determine compliance, the most conservative operating configurations and exposure conditions must be evaluated. Test F requenc Output Output Antenna Antenna Power berelly y Power Power Gain Gain Mode (mW/cm*) ( MHz) ( dBm) ( mwW) (dBi) (Linear) 2510 22.60 181.97 0.79 1.20 0.0278 LTE BAND 7 (20MHz) 2535 22.49 177.42 0.79 1.20 0.0271 2560 21.55 142.89 0.79 1.20 0.0218 2507.5 22.52 178.65 0.79 1.20 0.0273 LTE BAND 7 (15MHz) 2535 22.38 172.98 0.79 1.20 0.0264 2562.5 21.87 153.82 0.79 1.20 0.0235 2505 22.58 181.13 0.79 1.20 0.0277 LTE BAND 7 (10MHz) 2535 22.19 165.58 0.79 1.20 0.0253 2565 21.88 154.17 0.79 1.20 0.0236 2502.5 22. 42 174.58 0.79 1.20 0.0267 MEMNE! (5BMH2z) 2s§e 2214 163.68 0.79 1.20 0.0250 2567.5 21.52 141.91 0.79 1.20 0.0217 The results s& virl fiifisfi" report refer only to the sample(s) tested unless otherwise stated and the sample(s) are retained for 30 days only. The document is issued by/A this doct& it cannot be reproduced except in full with our prior written permission. The more details and the authenticity of the report will be confirmed t;!?ttp://www.agc-«drS t.com. o Tel: +86—755 2908 1955 Fax: +86—755 2600 8484 E—mail: agc@age—cert.com @ 400 089 2118 Add: 2/F. , Building 2, No.1—4, Chaxi Sanwei Technical Industrial Park,Gushu, Xixiang, Bacan District, Shenzhen, Guangdong China

Freque Output Output Antenna Antenna Test Power Density ncy Power Power Gain Gain Mode ( mW/cm2) ( MHz) ( dBm) ( mW) (dBi) (Linear) 2506 24.26 266.69 0.64 1.16 0.0394 LTE BAND 41 2593 23.14 206.06 0.64 1.16 0.0304 (20MHz) 2680 22.94 196.79 0.64 1.16 0.0290 2503.5 23.11 204.64 0.64 1.16 0.0302 LTE BAND 41 2593 22.52 178.65 0.64 1.16 0.0264 (15MHz) 2682.5 22.45 175.79 0.64 1.16 0.0259 2501 23.74 236.59 0.64 1.16 0.0349 LTE BAND 41 2593 23.12 205.12 0.64 1.16 0.0303 (10MHz) 2685 23.30 213.80 0.64 1.16 0.0316 2498.5 23.66 232.27 0.64 1.16 0.0343 LTE BAND 41 2593 22.89 194.54 0.64 1.16 0.0287 (5MHz) 2687.5 22.33 171.00 0.64 1.16 0.0252 Note: 1. Only the worst case recorded.


Document Created: 2018-09-17 15:36:23
Document Modified: 2018-09-17 15:36:23
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC