FCC Modular Approval Request Rev 2.1

FCC ID: TV7R11ELTE6

Cover Letter(s)

Download: PDF
FCCID_4191384

SIA "Mikrotīkls" Aizkraukles iela 23, Rīga, LV-1006, Latvia Phone: +371 67317700 Fax: +371 67317701 Modular Transmitter Approval Request Federal Communications Commission Equipment Authorization Division 7435 Oakland Mills Road Columbia, MD 21046 USA Company name: Mikrotikls SIA FCC ID: TV7R11ELTE6 Dear Sir/Madam, In accordance with 47CFR 15.212 Modular Transmitters and KDB 996369 D01 ‘Module Equip Auth Guide v02’. FCC ID:TV7R11ELTE6 has been examined against the following requirements. Requirement per 15.212 and KDB 996369 D01 Explanation from Grantee (do not write yes/no, but explain why product complies/how it is achieved) The radio elements must have the radio frequency circuitry The product is produced with permanently shielded. Physical components and tuning capacitor(s) may be attached RF shield during production. located external to the shield, but must be on the module assembly. The module must have buffered modulation/data inputs to ensure The product buffers the modulation and data that the device will comply with Part 15 requirements with any type inputs ensuring compliance with regulations. of input signal. The product incorporates regulators to ensure The module must contain power supply regulation on the module. operation in specified range. The module must contain a permanently attached antenna, or This product incorporates specific antenna contain a unique antenna connector, and be marketed and connectors and is therefore subject to limited operated only with specific antenna(s), per §§ 15.203, 15.204(b), module authorisation. 15.204(c), 15.212(a), 2.929(b). The product was tested in a stand-alone The module must demonstrate compliance in a stand-alone configuration (placed on configuration. development/interface fixture) without enclosure. The product has required labeling placed on The module must be labeled with its permanently affixed FCC ID the module and instruction for placement on label, or use an electronic display (see KDB Publication 784748). exterior of end product. The module must comply with all specific rules applicable to the The product fully complies with all specific transmitter, including all the conditions provided in the integration applicable rules and regulatory precautions instructions by the grantee. are addressed in manual. The product complies with applicable RF exposure requirements. Installation and RF The module must comply with RF exposure requirements exposure precautions are addressed in manual. FCC Modular Approval Request Rev 2.1

SIA "Mikrotīkls" Aizkraukles iela 23, Rīga, LV-1006, Latvia Phone: +371 67317700 Fax: +371 67317701 Name: Edmunds Zvegincevs Date: 25.02.2019 Title: Compliance Engineer Signature of applicant: FCC Modular Approval Request Rev 2.1


Document Created: 2019-06-08 23:49:02
Document Modified: 2019-06-08 23:49:02
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC