User Manual

FCC ID: TUV3763

Users Manual

Download: PDF

FCCID_1749907

ET- 3763Wireless keyboard and mouse combo user manual
Product features
Adopt general 2.4 G wireless solutions
Meet the appearance of the principle of human body engineering design idea
Multimedia standard three key area keyboard, splash-proof design, special osculum can smooth liquid
discharge, avoid splash damage,High life injection silica gel and feel good.
Installation
1.Wireless keyboard and receiver removed from the box
2.Put the Nano receiver into a USB interface
3.1 AA alkaline battery polarity keyboard in the correct in internal, LED blink a few seconds, now you can
use the product

Senior product function
1.The battery is low voltage remind function
With the use of the keyboard for longer, the battery voltage will slowly lower, below the set remind
voltage, in the process of use, LED light flashing red instructions appeared to remind you to replace new
batteries.
Note: you can only use AA alkaline battery type

2.Receiver collection function

This product is the use of ultra micro (Nano) receiver, usually can be prolonged PC or Notebook USB
mouth, does not have any influences to the computer.

3.CAPS LOCK instruction function
This product increases the CAPS LOCK instruction function, users to identify whether has opened the
CAPS LOCK. When LED light after the use of the keyboard, LED will be put out. The use of the keyboard
again when press any key LED to light.

Reconnect
The wireless set respectively transmit and receive a group of built-in identification number, easy to use
of products when using one-on-one. High temperature, high magnetic field, vibration, etc may make this
group of code disappear, they need to connect only can be used, the method is as follows:
1.Re-plug in the receiver;；
2.Hold the ESC key on the keyboard and K key for a few seconds, and then to loosen, the low voltage LED
shining to code namely after success. You also can use wireless keyboard.

Note
When the CAPS LOCK LED light power consumption will be when too large, it normally please switch to LED
out of the state. To extend battery life

Warning

Without the approval of the authorities responsible for any change or correction of clear users shall have
the right to prohibit the equipment
Remark

FCC STATEMENT

1. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.

Document Created: 2012-07-17 18:48:22
Document Modified: 2012-07-17 18:48:22

© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC