User Manual

FCC ID: TFJA20GV

Users Manual

Download: PDF
FCCID_3991120

180mm




                Asante GarageViewer Lights and Ports



                                                                                                             150mm
                                                                                    Mounting hole
                                                                                    Fastening wheel
                                                                                    This wheel is meant to
                                                                                    move freely to be able
                                                                                    to remove and install
                                                                                    camera while the wires
                                                                                    are still attached.




        WiFi wireless     Power light      Power
                                            ower                                    Connection to
        connectivity                                                                garage door wall
        light         Signal strength              Reset button                     mount button
                      light for wireless           To factory reset, connect the
                                                   device to power and wait at
                                                   least 1 minute.
                                                   With power connected, press
                                                   and hold down the reset
                                                   button until quick blinking of
                                                   lights are noticed. Let go of
                                                   reset bbutton and wait for
                                                   device to reboot.



                                                                720mm


180mm

                FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT
                This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
                the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
                installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
                accordance with the instructions, may cause harmful interference to radio communications. However, there is no
                guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
                to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
                to try to correct the interference by one or more of the following measures:
                – Reorient or relocate the receiving antenna.
                –
                – Increase the separation between the equipment and receiver.
                –
                – Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
                –
                – Consult the dealer or an experienced radio/TV technician for help.
                –




                                                                                                                                             150mm


                                                                            Asante GarageViewer
                                                                                    Installation Guide


                CAUTION:
                Any changes or modifications not expressly approved by the party responsible for compliance could void the
                user's authority to operate the equipment.
                This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
                (1) This device may not cause harmful interference and
                (2) This device must accept any interference received, including interference that may cause undesired operation.
                RF exposure warning
                This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used
                for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and
                must not be co-located or operating in conjunction with any other antenna or transmitter.
                End-users and installers must be provide with antenna installation instructions and transmitter operating conditions for
                satisfying RF exposure compliance.
        720mm



Document Created: 2019-03-27 15:51:25
Document Modified: 2019-03-27 15:51:25

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC