15.FCC Modular Approval Request rev1

FCC ID: TE7KLM100

Cover Letter(s)

Download: PDF
FCCID_4132531

Modular Approval Request FCC (KDB 996369 D01 & Part 15.212) FCC ID: TE7KLM100 Items to be covered by Limited single-modular transmitter. Answer from applicant 1. The modular transmitter must have its own RF shielding. YES, Please refer to External Photos. 2. The modular transmitter must have buffered modulation/data inputs (if such inputs YES,U1 MT7682SN is used for are provided) to ensure that the module will comply with Part 15 requirements the function. under conditions of excessive data rates or over-modulation. 3. The modular transmitter must have its own power supply regulation. No, the modular does not have its own power supply regulation. 4. The modular transmitter must comply with the antenna requirements of Section YES, it is printed antenna. 15.203 and 15.204(b)(c). The antenna must either be permanently attached or employ a “unique” antenna coupler (at all connections between the module and the antenna, including the cable). 5. The modular transmitter must be tested in a stand-alone configuration, i.e., the No, the module was not tested in module must not be inside another device during testing. This is intended to a stand-alone configuration as the demonstrate that the module is capable of complying with Part 15 emission limits test photos show. regardless of the device into which it is eventually installed. 6. The modular transmitter must be equipped with either a permanently affixed label YES, please refer to the or must be capable of electronically displaying its FCC identification number in exhibition label sample for this accordance with 15.212 (a)(1)(vi)(A) / (B). module. 7. The modular transmitter must comply with any specific rule or operating YES, please refer to the user requirements applicable to the transmitter and the manufacturer must provide manual. adequate instructions along with the module to explain any such requirements. A copy of these instructions must be included in the application for equipment authorization. For example, there are very strict operational and timing requirements that must be met before a transmitter is authorized for operation under Section 15.231. For instance, data transmission is prohibited, except for operation under Section 15.231(e), in which case there are separate field strength level and timing requirements. Compliance with these requirements must be assured. 8. The modular transmitter must comply with any applicable RF exposure YES, RF exposure statement is requirements. For example, FCC Rules in Sections 1.1310, 2.1091, 2.1093, and attached in the user manual. specific Sections of Part 15, including 15.319(i), 15.407(f), 15.253(f) and 15.255(g), require that Unlicensed PCS, UNII and millimeter wave devices perform routine environmental evaluation for RF Exposure to demonstrate compliance. In addition, spread spectrum transmitters operating under Section 15.247 are required to address RF Exposure compliance. Modular transmitters approved under other Sections of Part 15, when necessary, may also need to address certain RF Exposure concerns, typically by providing specific installation and operating instructions for users, installers and other interested parties to ensure compliance. Note: A limited modular approval (LMA) may be granted for single or split modular transmitters that comply partially with the requirements above. Name and surname of applicant (or authorized representative): Jing Huang Date: 2018-12-29 Signature:


Document Created: 2019-01-10 08:53:14
Document Modified: 2019-01-10 08:53:14
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC