1905TW0114-U5-FCC RF Exposure Report_Rev01

FCC ID: TE7AX50

RF Exposure Info

Download: PDF
FCCID_4307437

MRT Technology (Taiwan) Co., Ltd Report No.: 1905TW0114-U5 Phone: +886-3-3288388 Report Version: V01 Web: www.mrt-cert.com Issue Date: 05-25-2019 RF Exposure Evaluation Declaration FCC ID: TE7AX50 APPLICANT: TP-Link Technologies Co., Ltd. Application Type: Certification Product: AX3000 Gigabit Wi-Fi Router Model No.: Archer AX50, Archer AX3000 Trademark: tp-link FCC Classification: Digital Transmission System (DTS) Unlicensed National Information Infrastructure (NII) Test Procedure(s): KDB 447498 D01v06 Test Date: May 24, 2019 Reviewed By: ( Paddy Chen ) Approved By: (Chenz Ker) The test results relate only to the samples tested. The test results shown in the test report are traceable to the national/international standards through the calibration of the equipment and evaluated measurement uncertainty herein. The test report shall not be reproduced except in full without the written approval of MRT Technology (Taiwan) Co., Ltd. FCC ID: TE7AX50 Page Number: 1 of 7

Report No.: 1905TW0114-U5 Revision History Report No. Version Description Issue Date Note 1905TW0114-U5 Rev. 01 Initial report 05-25-2019 Valid FCC ID: TE7AX50 Page Number: 2 of 7

Report No.: 1905TW0114-U5 1. PRODUCT INFORMATION 1.1. Equipment Description Product Name AX3000 Gigabit Wi-Fi 6 Router Model No. Archer AX50, Archer AX3000 Brand Name: tp-link Wi-Fi Specification: 802.11a/b/g/n/ac/ax Note: These models are different in the USB interface, Archer AX50 supports USB 3.0, Archer AX3000 supports USB2.0. Others are the same. So Archer AX50 is chosen for the tests. 1.2. Description of Available Antennas Antenna Type Frequency TX Max Antenna Gain (dBi) Directional Gain (dBi) Band (MHz) Paths Ant 0 Ant 1 For Power For PSD 2400 ~ 2500 2 2.00 2.00 2.00 5.01 Dipole Antenna 5150 ~ 5850 2 3.00 3.00 3.00 6.01 Note: 1. 802.11b support single transmission at Ant 0 port only. 2. The EUT supports Cyclic Delay Diversity (CDD) mode, and CDD signals are correlated. For CDD transmissions, directional gain is calculated as follows, NANT = 2, NSS = 1. If all antennas have the same gain, GANT, Directional gain = GANT + Array Gain, where Array Gain is as follows. • For power spectral density (PSD) measurements on all devices, Array Gain = 10 log (NANT/ NSS) dB = 3.01; • For power measurements on IEEE 802.11 devices, Array Gain = 0 dB for NANT ≤ 4; FCC ID: TE7AX50 Page Number: 3 of 7

Report No.: 1905TW0114-U5 1.3. Description of Antenna RF Port Antenna RF Port Software 2.4GHz RF Port 5GHz RF Port Control Port Ant 0 Ant 1 Ant 0 Ant 1 FCC ID: TE7AX50 Page Number: 4 of 7

Report No.: 1905TW0114-U5 2. RF Exposure Evaluation 2.1. Limits According to FCC 1.1310: The criteria listed in the following table shall be used to evaluate the environment impact of human exposure to radio frequency (RF) radiation as specified in 1.1307(b) LIMITS FOR MAXIMUM PERMISSIBLE EXPOSURE (MPE) Frequency Range Electric Field Magnetic Field Power Density Average Time 2 (MHz) Strength (V/m) Strength (A/m) (mW/cm ) (Minutes) (A) Limits for Occupational/ Control Exposures 300-1500 -- -- f/300 6 1500-100,000 -- -- 5 6 (B) Limits for General Population/ Uncontrolled Exposures 300-1500 -- -- f/1500 6 1500-100,000 -- -- 1 30 f= Frequency in MHz Calculation Formula: Pd = (Pout*G)/(4*pi*r2) Where Pd = power density in mW/cm2 Pout = output power to antenna in mW G = gain of antenna in linear scale Pi = 3.1416 r = distance between observation point and center of the radiator in cm Pd is the limit of MPE, 1mW/cm². If we know the maximum gain of the antenna and the total power input to the antenna, through the calculation, we will know the distance r where the MPE limit is reached. FCC ID: TE7AX50 Page Number: 5 of 7

Report No.: 1905TW0114-U5 2.2. Test Result of RF Exposure Evaluation Product AX3000 Gigabit Wi-Fi 6 Router Test Item RF Exposure Evaluation Antenna Gain: Refer to clause 1.2. Test Mode Frequency Band Max Conducted Antenna Gain Maximum EIRP (MHz) Power (dBi) (dBm) (dBm) 802.11b/g/n/ax 2412 ~ 2462 29.79 2.00 31.79 5180 ~ 5320, 802.11 a/n/ac/ax 5500 ~ 5720, 29.71 3.00 32.71 5745 ~ 5825 Test Mode Frequency Band Maximum EIRP Power Density at Limit (MHz) (dBm) R = 20 cm (mW/cm2) (mW/cm2) 802.11b/g/n/ax 2412 ~ 2462 31.79 0.3004 1 5180 ~ 5320, 802.11 a/n/ac/ax 5500 ~ 5720, 32.71 0.3713 1 5745 ~ 5825 CONCLUSION: Both of the WLAN 2.4GHz Band and WLAN 5GHz Band can transmit simultaneously. The max Power Density at R (20 cm) = 0.3004mW/cm2 + 0.3713mW/cm2 = 0.6717mW/cm2 < 1mW/cm2. So the safety distance is 20cm for AX3000 Gigabit Wi-Fi 6 Router installed without any other radio equipment. The End FCC ID: TE7AX50 Page Number: 6 of 7

Report No.: 1905TW0114-U5 Appendix A - EUT Photograph Refer to “1905TW0114-UE” file. FCC ID: TE7AX50 Page Number: 7 of 7


Document Created: 2019-06-04 19:50:24
Document Modified: 2019-06-04 19:50:24
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC