Test Report 3

FCC ID: TA8CKRD901108

Test Report

Download: PDF
FCCID_4449192

No.I19Z61573-WMD01 Page 61 of 76 Configuration NR-MIMO-1C 80M, QPSK Port 55, Channel Position B ©Copyright. All rights reserved by CTTL.

No.I19Z61573-WMD01 Page 62 of 76 Port 55, Channel Position M ©Copyright. All rights reserved by CTTL.

No.I19Z61573-WMD01 Page 63 of 76 Port 55, Channel Position T ©Copyright. All rights reserved by CTTL.

No.I19Z61573-WMD01 Page 64 of 76 Configuration NR-MIMO-1C 90M, QPSK Port 55, Channel Position B ©Copyright. All rights reserved by CTTL.

No.I19Z61573-WMD01 Page 65 of 76 Port 55, Channel Position M ©Copyright. All rights reserved by CTTL.

No.I19Z61573-WMD01 Page 66 of 76 Port 55, Channel Position T ©Copyright. All rights reserved by CTTL.

No.I19Z61573-WMD01 Page 67 of 76 A.5 Radiated Spurious Emission A.5.1 Reference FCC CFR 47 Part 2, Clause 2.1053 FCC CFR 47 Part 27, Clause 27.53 (m) A.5.2 Method of measurement The measurements procedures in TIA-603-E: 2016 are used. This measurement is carried out in semi-anechoic chamber. A preliminary profile of the Spurious Radiated Emissions was obtained by operating the EUT on a remotely controlled turntable within the chamber. Measurements of emissions from the EUT were obtained with the measurement antenna in both horizontal and vertical polarisations. Emissions identified within the range 30MHz to 40GHz were then formally measured using a peak detector as the worst case. The limits for outside a licensee’s frequency band(s) of operation the power of the spurious emissions have been calculated, as shown below using the following formula: Field Strength of Carrier - (43 + 10Log (P)) dB Where: Field Strength is measured in dBμV/m P is measured Transmitter Power in Watts The EUT was measured with the antenna height varied between 1 and 4 m with the turntable rotated between 0 and 360 degrees. The emission of any outside a licensee’s frequencies within 20dB of the limit were measured with the substitution method used according to the standard. The measurements were performed at a 3m distance unless otherwise stated. A.5.3 Measurement limit The field strength of the carrier has been calculated assuming that the power is to be fed to a half-wave tuned dipoles as per 2.1053 (a). E(v/m)=(30 x Gi x Po )0.5 / d Where Gi is the antenna gain of ideal half-wave dipoles, Po is the power out of the transceiver in W, d is the measurement distance in meter. Therefore at 3m measurement distance the field strength using the lowest transceiver output power would be: E(v/m)=(30 x 1.64 x 16.56)0.5 / 3 = 9.51V/m = 139.57 dBμV/m As per 24.238 (a) the spurious emission must be attenuated by 43 + 10log (Po) dB this gives: 43 + 10log(16.56) = 55.19 dB Therefore the limit at 3m measurement distance is: 139.57 – 55.19 = 84.4 dBμV/m These limits have been used to determine Pass or Fail for the harmonics measured and detailed in the following results. A.5.4 Measurement results ©Copyright. All rights reserved by CTTL.

No.I19Z61573-WMD01 Page 68 of 76 Configuration NR-MIMO-1C 30.0M Maximum Output Power 50.79 dBm, 256QAM Channel Position Channel Frequencies Channel Position B 2511MHz Channel Position M 2593.02MHz Channel Position T 2675.01MHz No emissions were detected within 20dB of the limit. Configuration NR-MIMO-1C 50.0M Maximum Output Power 53.01 dBm, 256QAM Channel Position Channel Frequencies Channel Position B 2511MHz Channel Position M 2593.02MHz Channel Position T 2675.01MHz No emissions were detected within 20dB of the limit. Configuration NR-MIMO-1C 60.0M Maximum Output Power 53.01 dBm, 256QAM Channel Position Channel Frequencies Channel Position B 2526MHz No emissions were detected within 20dB of the limit. Configuration NR-MIMO-1C 80.0M Maximum Output Power 53.01 dBm, 256QAM Channel Position Channel Frequencies Channel Position B 2536.02MHz No emissions were detected within 20dB of the limit. Configuration NR-MIMO-1C 90.0M Maximum Output Power 53.01 dBm, 256QAM Channel Position Channel Frequencies Channel Position B 2541MHz No emissions were detected within 20dB of the limit. ©Copyright. All rights reserved by CTTL.

No.I19Z61573-WMD01 Page 69 of 76 Final Results 100 90 80 70 60 Level in dB礦/m 50 40 30 20 10 0 30M 50 60 80 100M 200 300 400 500 800 1G 100 90 80 70 60 Level in dB礦/m 50 40 30 20 10 0 1G 2G 3G 4G 5G 6 8 10G 18G ©Copyright. All rights reserved by CTTL.

No.I19Z61573-WMD01 Page 70 of 76 Level in dBuV/m Frequency in GHz Level in dBuV/m Frequency in GHz ©Copyright. All rights reserved by CTTL.

No.I19Z61573-WMD01 Page 71 of 76 A.6 Frequency Stability A.6.1 Reference FCC CFR 47 Part 2, Clause 2.1055 FCC CFR 47 Part 27, Clause 27.54 A.6.2 Method of measurement Temperature Variation The EUT was tested over the temperature range -30°C to +50°C in 10°C steps with -48 VDC Power Supply. At each temperature step, the Base Station was configured to transmit a [RAT]* at maximum power on the bottom, middle and top channel of the operating band. After achieving thermal balance, the averages of 200 transmission bursts were measured and the result recorded. Voltage Variation The EUT was tested at the supplied voltages varied from 85 to 115 percent of the nominal value of -48 VDC. At +20°C, the Base Station was configured to transmit a [RAT]* at maximum power on the bottom, middle and top channel of the operating band. The average of 200 transmission bursts was measured and the result recorded. [RAT]*: NR - QPSK modulation A.6.3 Measurement limit The frequency stability shall be sufficient to ensure that the fundamental emissions stay within the authorized bands of operation. ©Copyright. All rights reserved by CTTL.

No.I19Z61573-WMD01 Page 72 of 76 A.6.4 Measurement results Frequency Error – Temperature Variation Configuration NR-MIMO-1C-30 Maximum Output Power 32.73dBm per port, Channel Bandwidth 30MHz Frequency Stability (Hz) Supply Voltage Temperature Channel Channel Channel DC(V) position B position M position T -30 -12.49 -12.022 12.04 -20 8.77 14.305 9.17 -10 -13.05 5.84 -5.12 0 8.80 7.71 1.28 -48 10 -15.51 18.50 1.71 20 -11.41 12.97 -2.30 30 19.84 1.57 18.05 40 -11.11 -12.27 -5.03 50 -2.58 -4.33 -14.03 Configuration NR-MIMO-1C-50 Maximum Output Power 34.95dBm per port, Channel Bandwidth 50MHz Frequency Stability (Hz) Supply Voltage Temperature Channel Channel Channel DC(V) position B position M position T -30 -2.61 9.81 10.78 -20 -17.46 -4.39 17.68 -10 -18.95 -9.45 -15.17 0 -4.07 11.47 -7.97 -48 10 -17.89 18.71 -15.12 20 -11.47 -3.40 9.94 30 6.46 -2.39 -5.74 40 12.97 -15.85 2.97 50 5.24 18.59 -4.43 ©Copyright. All rights reserved by CTTL.

No.I19Z61573-WMD01 Page 73 of 76 Configuration NR-MIMO-1C-60 Maximum Output Power 34.95dBm per port, Channel Bandwidth 60MHz Frequency Stability (Hz) Supply Voltage Temperature Channel Channel Channel DC(V) position B position M position T -30 -3.81 -6.71 -6.11 -20 14.33 18.05 -4.08 -10 6.80 12.43 -16.57 0 -11.10 -15.97 17.89 -48 10 6.66 13.55 -12.01 20 12.58 18.53 -7.10 30 -4.68 16.90 -12.59 40 6.35 9.01 -17.63 50 1.52 -17.43 -10.32 Configuration NR-MIMO-1C-80 Maximum Output Power 34.95dBm per port, Channel Bandwidth 80MHz Frequency Stability (Hz) Supply Voltage Temperature Channel Channel Channel DC(V) position B position M position T -30 -8.62 2.20 7.52 -20 -11.94 0.49 -14.49 -10 -8.32 -12.26 -9.76 0 4.25 7.93 1.05 -48 10 1.33 20.02 2.38 20 -18.17 17.90 -3.70 30 5.42 6.31 18.84 40 -17.67 15.37 -10.33 50 5.72 12.42 10.72 ©Copyright. All rights reserved by CTTL.

No.I19Z61573-WMD01 Page 74 of 76 Configuration NR-MIMO-1C-90 Maximum Output Power 34.95dBm per port, Channel Bandwidth 90MHz Frequency Stability (Hz) Supply Voltage Temperature Channel Channel Channel DC(V) position B position M position T -30 -13.91 1.87 12.09 -20 13.65 -2.06 7.49 -10 -3.62 -6.74 9.26 0 -7.89 18.76 -3.07 -48 10 -7.67 14.66 4.73 20 -10.92 -3.69 -8.47 30 4.07 -14.33 1.78 40 11.18 8.28 4.70 50 -19.31 -1.33 18.82 Frequency Error – Voltage Variation Configuration NR-MIMO-1C-30 Maximum Output Power 34.95dBm per port, Channel Bandwidth 30MHz Frequency Stability (Hz) Supply Voltage Temperature(°C) Channel Channel Channel DC(V) position B position M position T -40.8 20 16.05 -9.45 -4.41 -48 20 -16.37 -17.28 -11.98 -55.2 20 4.69 -12.45 -12.80 Configuration NR-MIMO-1C-50 Maximum Output Power 34.95dBm per port, Channel Bandwidth 50MHz Frequency Stability (Hz) Supply Voltage Temperature(°C) Channel Channel Channel DC(V) position B position M position T -40.8 20 -13.92 1.45 -4.88 -48 20 2.53 -19.97 4.60 -55.2 20 1.20 -10.24 -3.20 Configuration NR-MIMO-1C-60 Maximum Output Power 34.95dBm per port, Channel Bandwidth 60MHz Frequency Stability (Hz) Supply Voltage Temperature(°C) Channel Channel Channel DC(V) position B position M position T -40.8 20 -2.20 6.02 4.73 -48 20 17.23 -18.35 -5.66 -55.2 20 3.43 10.62 10.14 ©Copyright. All rights reserved by CTTL.

No.I19Z61573-WMD01 Page 75 of 76 Configuration NR-MIMO-1C-80 Maximum Output Power 34.95dBm per port, Channel Bandwidth 80MHz Frequency Stability (Hz) Supply Voltage Temperature(°C) Channel Channel Channel DC(V) position B position M position T -40.8 20 12.56 -11.22 17.70 -48 20 -18.78 -7.98 -1.25 -55.2 20 10.48 5.03 17.40 Configuration NR-MIMO-1C-90 Maximum Output Power 34.95dBm per port, Channel Bandwidth 90MHz Frequency Stability (Hz) Supply Voltage Temperature(°C) Channel Channel Channel DC(V) position B position M position T -40.8 20 -18.4 7.05 -9.33 -48 20 -8.22 -4.63 11.66 -55.2 20 1.90 -5.26 -10.68 ©Copyright. All rights reserved by CTTL.

No.I19Z61573-WMD01 Page 76 of 76 ANNEX B: Accreditation Certificate ***END OF REPORT*** ©Copyright. All rights reserved by CTTL.


Document Created: 2019-09-12 10:11:31
Document Modified: 2019-09-12 10:11:31
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC